Objective: We evaluated the occupational exposure levels of healthcare workers while conducting rotational pressurized intraperitoneal aerosol chemotherapy (RIPAC) using cisplatin in a large animal model. Methods: We performed RIPAC using cisplatin in 6 female pigs and collected surface and air samples during the procedure. Surface samples were obtained from RIPAC devices and personal protective equipment (PPE) by wiping, and air samples were collected around the operating table.All samples were analyzed by inductively coupled plasma–mass spectrometry to detect platinum. Results: Among all surface samples (n=44), platinum was detected in 41 samples (93.2%) but not in all air samples (n=16). Among samples collected from RIPAC devices (n=23), minimum and maximum cisplatin levels of 0.08 and 235.09 ng/cm2 were detected, mainly because of direct aerosol exposure in the abdominal cavity. Among samples collected from healthcare workers’ PPE (n=21), 18 samples (85.7%) showed contamination levels below the detection limit, with a maximum of 0.23 ng/cm2 . There was no significant contamination among samples collected from masks, shoes, or gloves. Conclusion During the RIPAC procedures, there is a potential risk of dermal exposure, as platinum, a surrogate material for cisplatin, was detected at low concentration levels in some surface samples. However, the respiratory exposure risk was not identified, as platinum was not detected in the airborne samples in this study.

Objective: We evaluated the occupational exposure levels of healthcare workers while conducting rotational pressurized intraperitoneal aerosol chemotherapy (RIPAC) using cisplatin in a large animal model. Methods: We performed RIPAC using cisplatin in 6 female pigs and collected surface and air samples during the procedure. Surface samples were obtained from RIPAC devices and personal protective equipment (PPE) by wiping, and air samples were collected around the operating table.All samples were analyzed by inductively coupled plasma–mass spectrometry to detect platinum. Results: Among all surface samples (n=44), platinum was detected in 41 samples (93.2%) but not in all air samples (n=16). Among samples collected from RIPAC devices (n=23), minimum and maximum cisplatin levels of 0.08 and 235.09 ng/cm2 were detected, mainly because of direct aerosol exposure in the abdominal cavity. Among samples collected from healthcare workers’ PPE (n=21), 18 samples (85.7%) showed contamination levels below the detection limit, with a maximum of 0.23 ng/cm2 . There was no significant contamination among samples collected from masks, shoes, or gloves. Conclusion During the RIPAC procedures, there is a potential risk of dermal exposure, as platinum, a surrogate material for cisplatin, was detected at low concentration levels in some surface samples. However, the respiratory exposure risk was not identified, as platinum was not detected in the airborne samples in this study.

Objective: We evaluated the occupational exposure levels of healthcare workers while conducting rotational pressurized intraperitoneal aerosol chemotherapy (RIPAC) using cisplatin in a large animal model. Methods: We performed RIPAC using cisplatin in 6 female pigs and collected surface and air samples during the procedure. Surface samples were obtained from RIPAC devices and personal protective equipment (PPE) by wiping, and air samples were collected around the operating table.All samples were analyzed by inductively coupled plasma–mass spectrometry to detect platinum. Results: Among all surface samples (n=44), platinum was detected in 41 samples (93.2%) but not in all air samples (n=16). Among samples collected from RIPAC devices (n=23), minimum and maximum cisplatin levels of 0.08 and 235.09 ng/cm2 were detected, mainly because of direct aerosol exposure in the abdominal cavity. Among samples collected from healthcare workers’ PPE (n=21), 18 samples (85.7%) showed contamination levels below the detection limit, with a maximum of 0.23 ng/cm2 . There was no significant contamination among samples collected from masks, shoes, or gloves. Conclusion During the RIPAC procedures, there is a potential risk of dermal exposure, as platinum, a surrogate material for cisplatin, was detected at low concentration levels in some surface samples. However, the respiratory exposure risk was not identified, as platinum was not detected in the airborne samples in this study.

Background: This study evaluated occupational exposure levels of doxorubicin in healthcare workers performing rotational intraperitoneal pressurized aerosol chemotherapy (PIPAC) procedures. Methods: All samples were collected during PIPAC procedures applying doxorubicin to an experimental animal model (pigs). All procedures were applied to seven pigs, each for approximately 44 min. Surface samples (n = 51) were obtained from substances contaminating the PIPAC devices, surrounding objects, and protective equipment. Airborne samples were also collected around the operating table (n = 39). All samples were analyzed using ultra-high performance liquid chromatography-mass spectrometry. Results: Among the surface samples, doxorubicin was detected in only five samples (9.8%) that were directly exposed to antineoplastic drug aerosols in the abdominal cavity originating from PIPAC devices. The telescopes showed concentrations of 0.48–5.44 ng/cm2 and the trocar showed 0.98 ng/cm2 in the region where the spraying nozzles were inserted. The syringe line connector showed a maximum concentration of 181.07 ng/cm2, following a leakage. Contamination was not detected on the surgeons' gloves or shoes. Objects surrounding the operating table, including tables, operating lights, entrance doors, and trocar holders, were found to be uncontaminated. All air samples collected at locations where healthcare workers performed procedures were found to be uncontaminated. Conclusions Most air and surface samples were uncontaminated or showed very low doxorubicin concentrations during PIPAC procedures. However, there remains a potential for leakage, in which case dermal exposure may occur. Safety protocols related to leakage accidents, selection of appropriate protective equipment, and the use of disposable devices are necessary to prevent occupational exposure.

Background: There is little information about the airborne hazardous agents released during the heat treatment when manufacturing a welding material. This study aimed to evaluate the airborne hazardous agents generated at welding material manufacturing sites through area sampling. Methods: concentration of airborne particles was measured using a scanning mobility particle sizer and optical particle sizer. Total suspended particles (TSP) and respirable dust samples were collected on polyvinyl chloride filters and weighed to measure the mass concentrations. Volatile organic compounds and heavy metals were analyzed using a gas chromatography mass spectrometer and inductively coupled plasma mass spectrometer, respectively. Results: The average mass concentration of TSP was 683.1 ± 677.4 μg/m3, with respirable dust accounting for 38.6% of the TSP. The average concentration of the airborne particles less than 10 μm in diameter was 11.2–22.8 × 104 particles/cm3, and the average number of the particles with a diameter of 10–100 nm was approximately 78–86% of the total measured particles (<10 μm). In the case of volatile organic compounds, the heat treatment process concentration was significantly higher (p < 0.05) during combustion than during cooling. The airborne heavy metal concentrations differed depending on the materials used for heat treatment. The content of heavy metals in the airborne particles was approximately 32.6%. Conclusions Nanoparticle exposure increased as the number of particles in the air around the heat treatment process increases, and the ratio of heavy metals in dust generated after the heat treatment process is high, which may adversely affect workers' health.

This study presents the development and validation of a risk assessment program of highly pathogenic avian influenza (HPAI). This program was developed by the Korean government (Animal and Plant Quarantine Agency) and a private corporation (Korea Telecom, KT), using a national database (Korean animal health integrated system, KAHIS).

The major purpose of this study is to construct a retrospective exposure assessment for benzene through a review of literature on Korea. Airborne benzene measurements reported in 34 articles were reviewed. A total of 15,729 individual measurements were compiled. Weighted arithmetic means [AM(w)] and their variance calculated across studies were summarized according to 5-year period intervals (prior to the 1970s through the 2010s) and industry type. Industries were classified according to Korea Standard Industrial Classification (KSIC) using information provided in the literature. We estimated quantitative retrospective exposure to benzene for each cell in the matrix through a combination of time and KSIC. Analysis of the AM(w) indicated reductions in exposure levels over time, regardless of industry, with mean levels prior to the 1980e1984 period of 50.4 ppm (n = 2,289), which dropped to 2.8 ppm (n = 305) in the 1990e1994 period, and to 0.1 ppm (n = 294) in the 1995e1999 period. There has been no improvement since the 2000s, when the AM(w) of 4.3 ppm (n = 6,211) for the 2005e2009 period and 4.5 ppm (n = 3,358) for the 2010e2013 period were estimated. A comparison by industry found no consistent patterns in the measurement results. Our estimated benzene measurements can be used to determine not only the possibility of retrospective exposure to benzene, but also to estimate the level of quantitative or semiquantitative retrospective exposure to benzene.
Benzene* ; Classification ; Korea* ; Retrospective Studies

BACKGROUND: Thiopental and propofol have been widely used for general anesthesia induction, but their impacts on cardiac function have not been well described. A recent study speculated that anesthesia induction using propofol 2 mg/kg transiently reduced left ventricular (LV) contraction by analyzing tissue Doppler-derived imaging (TDI) during induction phase. The purpose of this study was to analyze and to compare the impacts of propofol- and thiopental-induction on LV function. METHODS: Twenty-four female patients with normal LV function undergoing non-cardiac surgery were randomly administered intravenous bolus thiopental (5 mg/kg, Thiopental-group, n = 12) or propofol (2 mg/kg, Propofol-group, n = 12) for anesthesia-induction. TDI of septal mitral annular velocity during systole (S'), early diastole (e') and atrial contraction (a') were determined by transthoracic echocardiography before and 1, 3, and 5 minutes after thiopental/propofol administration (T0, T1, T2, and T3, respectively). RESULTS: The bispectral index and systolic blood pressure declined significantly during anesthesia induction in both groups, however, more depressed in Thiopental-group compared with those in Propofol-group at T2 and T3 (all, p < 0.05). Among TDI two parameters demonstrated a significant inter-group difference: the S' in propofol was lower than that in Thiopental-group at T3 (p = 0.002), and a' velocities were persistently lower in Propofol-group, compared with same time values in Thiopental-group (T1, T2, and T3: p = 0.025, 0.007, and 0.009, respectively). CONCLUSION: Anesthesia induction using propofol revealed a more persistent and profound decline of LV and atrial contraction than that using thiopental. Further studies are needed to understand the clinical implication.
Anesthesia* ; Anesthesia, General ; Blood Pressure ; Diastole ; Echocardiography ; Female ; Humans ; Propofol* ; Systole ; Thiopental*

A precise pre-procedural evaluation of mitral valve (MV) pathology is essential for planning the surgical strategy for severe mitral regurgitation (MR) and preparing for the intraoperative procedure. In the present case, a 38-year-old woman was scheduled to undergo MV replacement due to severe MR. She had a history of undergoing percutaneous balloon valvuloplasty due to rheumatic mitral stenosis during a previous pregnancy. A preoperative transthoracic echocardiography suggested a tear in the mid tip of the anterior mitral leaflet. However, the "en face" view of the MV in the left atrial perspective using intraoperative real time three-dimensional transesophageal echocardiography (RT 3D-TEE) provided a different diagnosis: a torn cleft in the P2-scallop of the posterior mitral leaflet (PML) with rupture of the chordae. Thus, surgical planning was changed intraoperatively to MV repair (MVRep) consisting of patch closure of the PML, commissurotomy, and lifting annuloplasty. The present case shows that intraoperative RT 3D-TEE provides more precise and reliable spatial information of MV for MVRep and facilitates critical surgical decision-making.
Adult ; Balloon Valvuloplasty ; Diagnosis ; Echocardiography ; Echocardiography, Transesophageal* ; Female ; Humans ; Lifting ; Mitral Valve Insufficiency ; Mitral Valve Stenosis ; Mitral Valve* ; Pathology ; Pregnancy ; Rupture

No abstract available.
Cardiopulmonary Bypass* ; Thoracic Surgery*