Study on long-term morphological stability of three-dimensional-printed photosensitive resin dental models.
10.3760/cma.j.cn112144-20220529-00283
- VernacularTitle:三维打印光敏树脂牙列模型形态的长期稳定性研究
- Author:
Rui GU
1
;
Yi Peng WANG
1
;
Wu Shuang YE
1
;
Jing Yi SHAO
1
;
Chao Ran XUE
1
;
Ding BAI
1
Author Information
1. Department of Orthodontics, West China Hospital of Stomatology, Sichuan University & State Key Laboratory of Oral Diseases & National Clinical Research Center for Oral Diseases, Chengdu 6 10041, China.
- Publication Type:Journal Article
- From:
Chinese Journal of Stomatology
2023;58(3):271-276
- CountryChina
- Language:Chinese
-
Abstract:
Objective: To study the long-term morphological stability of three-dimensional (3D) printed photosensitive resin dental models under natural light and dark conditions. Methods: Eighty sets of resin dental models were made by the desktop 3D printer from one digital standard model set, and randomly divided into two groups, namely natural light group (40 sets) and dark group (40 sets). All resin models were stored in sealed bags, with 4 model sets from each group randomly collected after 1, 3, 5, 7, 14, 21, 28, 40, 60, or 90 days of storage and 3D scanned using an optical model scanner. The root-mean-square error (RMSE) was calculated to represent the mean deviation of the difference between the digital standard model and the scanned resin model. Meanwhile, three linear indexes (the width between the canines, the width between the first molars, and the arch length) of the resin dental model were measured and compared with the corresponding values of the standard model. RMSE and the linear measurements between the digital standard model and the scanned resin models were compared between the natural light group and the dark group and among models from different time points. Results: Compared with the digital standard model, the RMSE values of 96.9% (155/160) resin dental models were less than 0.1 mm within 90-day storage. Also, at the same time point, there was no significant difference in the RMSE between the natural light group and the dark group (P>0.05). 75.0% (360/480) of the absolute values of the linear differences (differences in inter-canine width, intra-molar width, and arch length between the digital standard model and the scanned resin model) were within 0.2 mm, and about 0.1% (3/480) of the linear differences were greater than 0.5 mm, and all of the linear differences were within 0.6 mm. Conclusions: 3D-printed resin dental models can be stored stably under natural light and dark conditions for a long time.
