Objective To specify the occurrence status,distribution characteristics and risk factors of neglected perforations in surgical gloves used during spinal surgery.Methods A total of 932 surgical gloves used during spinal surgery in our hospital from October 2022 to September 2024 were selected.The occurrence and distribution location of neglected perforations were counted.Univariate and binary Logistic regression analyses were respectively conducted on the factors that might lead to neglected perforations of gloves.Results Among the 932 surgical gloves used in spinal surgery selected in this study,a total of 122 gloves(13.09％)with neglected perforations were detected,of which the proportions of neglected perforations at the index finger of the left and right hands in the gloves were the highest,accounting for 37.50％and 37.93％respectively.The results of univariate and binary Logistic regression analyses showed that grade Ⅲ or Ⅳ surgery,open surgery,combined bone grafting operation,operation time≥120 minutes,use of rotating equipment,and gloves worn by instrument nurses were risk factors for neglected perforations(P<0.05,OR>1.0),while wearing double-layer gloves was a protective factor to avoid the occurrence of neglected perforations(P<0.05,OR<1.0).Conclusion The incidence of neglected perforations in surgical gloves used during spinal surgery is relatively high,especially in the area of the glove index finger.For high-risk spinal surgeries(grade Ⅲ or Ⅳ surgery,open surgeries,combined bone grafting procedures)and requiring rotating equipment,health care workers,especially instrumental nurses,are advised to wear double-layer gloves;furthermore,a 120-minute glove change regime is recommended,in order to reduce the incidence of neglected perforation.

Objective To specify the occurrence status,distribution characteristics and risk factors of neglected perforations in surgical gloves used during spinal surgery.Methods A total of 932 surgical gloves used during spinal surgery in our hospital from October 2022 to September 2024 were selected.The occurrence and distribution location of neglected perforations were counted.Univariate and binary Logistic regression analyses were respectively conducted on the factors that might lead to neglected perforations of gloves.Results Among the 932 surgical gloves used in spinal surgery selected in this study,a total of 122 gloves(13.09％)with neglected perforations were detected,of which the proportions of neglected perforations at the index finger of the left and right hands in the gloves were the highest,accounting for 37.50％and 37.93％respectively.The results of univariate and binary Logistic regression analyses showed that grade Ⅲ or Ⅳ surgery,open surgery,combined bone grafting operation,operation time≥120 minutes,use of rotating equipment,and gloves worn by instrument nurses were risk factors for neglected perforations(P<0.05,OR>1.0),while wearing double-layer gloves was a protective factor to avoid the occurrence of neglected perforations(P<0.05,OR<1.0).Conclusion The incidence of neglected perforations in surgical gloves used during spinal surgery is relatively high,especially in the area of the glove index finger.For high-risk spinal surgeries(grade Ⅲ or Ⅳ surgery,open surgeries,combined bone grafting procedures)and requiring rotating equipment,health care workers,especially instrumental nurses,are advised to wear double-layer gloves;furthermore,a 120-minute glove change regime is recommended,in order to reduce the incidence of neglected perforation.

This study aims to investigate the effects and mechanisms of the effective-compounds of Jinshui Huanxian formula (ECC-JHF) in improving pulmonary fibrosis. Animal experiments were approved by the Ethics Committee of the Animal Experiment Center of Henan University of Chinese Medicine (approval number: IACUC-202306012). The mouse model of pulmonary fibrosis was induced using bleomycin (BLM). Hematoxylin-eosin (H&E) staining was used to detect the histopathological changes of lung tissues. Masson staining was used to assess the degree of fibrosis in lung tissues. Immunofluorescence (IF) and real-time quantitative PCR (qPCR) were performed to measure the expression of collagen type I (COL I), α-smooth muscle actin (α-SMA), fibronectin (FN), interleukin (IL)-1β, IL-6, and tumor necrosis factor α (TNF-α) in lung tissues. Flow cytometry (FCM) was employed to detect the proportion of M1 and M2 macrophages in the bronchoalveolar lavage fluid (BALF) of mice. IF and qPCR were also used to detect the expression of lipase family member N (LIPN) in lung tissues. Free fatty acid assay kit was used to detect the level of free fatty acids in lung tissue. Bone marrow-derived macrophages (BMDMs) were treated with interleukin-4 (IL-4) to induce M2 polarization. FCM was used to measure the proportion of CD206⁺ M2 macrophages. IF was utilized to detect LIPN expression and lipid droplet decomposition. The results showed that in BLM-induced pulmonary fibrosis mice, ECC-JHF significantly attenuated BLM-induced alveolar inflammation and collagen deposition, inhibited fibroblast activation in lung tissues, and decreased the proportion of M2 macrophages in BALF. It also significantly suppressed LIPN expression and free fatty acid level in lung tissues. In the IL-4 induced BMDMs M2 polarization model, ECC-JHF significantly inhibited the proportion of CD206⁺ M2 macrophages, down-regulated the expression of LIPN, and blocked lipid droplet catabolism. These results suggest that ECC-JHF may alleviate bleomycin-induced pulmonary fibrosis by inhibiting lipid droplet decomposition and M2 macrophage polarization.

In this study,an ON/OFF type micro-valve with a sandwich(glass-silicon-glass)structure was designed and fabricated based on the micro-electro-mechanical system(MEMS)technique.The deformable membrane of this micro-valve was prepared on the silicon on insulator(SOI)substrate and sealed using Si-Si bonding and anodic bonding methods.The micro-valve had high-temperature stability and was suitable for integration with other gas chromatography components.The deformable membrane with a thickness of 10 μm was processed on the top silicon of the SOI substrate.The flow control of the micro-valve could be achieved by changing the driving pressure applied to the deformable membrane to deform it.Compared with polymer membranes,the deformable membrane prepared on the top layer silicon of SOI had better temperature stability and could be released using the deep reactive ion etching technique after silicon-silicon bonding,avoiding deformation during the preparation process.In addition,due to the small gap between the membrane and the inlet/outlet holes,the dead volume of the microvalve was very small.The test results indicated that the micro-valve achieved flow control and ON/OFF functions with good repeatability.

A monolithic integrated gas chromatography chip,consisting of a micro gas chromatography column(μGCC)and a micro helium discharge ionization detector(μHDID)was proposed.The chip was fabricated using micro electromechanical system(MEMS)technique,and its sensitivity was improved from two aspects.On one hand,open tubular column was selected as the separation device,and the auxiliary helium channel width of μHDID was modulated based on the microchannel width of the μGCC to match the flow rates of μHDID and μGCC.On the other hand,the electrode structure inside the μHDID collection zone was optimized,a bias electrode group around the collection electrode was constructed,and the ion collection efficiency was improved.After coating HKUST-1 as the stationary phase,the monolithic integrated gas chromatography chip could achieve baseline separation and detection of light hydrocarbon gas mixture(methane,ethane,propane,andn-butane),with a detection limit for propane as low as 25 pg.The chip could carried out test under temperature-programmed conditions,with a resolution of 9.24 for ethane and propane.

A micro gas chromatographic column with mesoporous surface micro column array prepared by anodization method was proposed.A porous support layer with a characteristic pore size of about 30 nm inside the chromatographic column was prepared in situ using anodization method,and a uniform alumina stationary phase was deposited on the mesoporous support layer using atom layer deposition(ALD)technique.The existence of a mesoporous support layer increased surface area of the chromatographic column,thereby increasing the total amount of stationary phase loading and enhancing column capacity,which facilitated chromatographic separation.The test results showed that the porous support layer significantly reduced the longitudinal molecular diffusion and mass transfer resistance of the micro gas chromatographic column,and significantly increased the number of theoretical plates(n-nonane increased by 290.2%).Furthermore,column efficiency of the chromatographic column was less affected by flow rate,which was conducive to rapid separation of heavy hydrocarbon mixtures.

Objective To explore whether creatine therapy regulates neuronal ferroptosis by inhibiting the activation of STAT1 signaling pathway associated with suppressor of cytokine signaling 1(SOCS1)in Alzheimer's disease.Methods Immunohistochemical staining and counting of positive results using paraffin sections of human brain frontal lobes were employed to determine the trend of changes in the target proteins.Further validation was performed by immunofluorescence and Western blotting.STAT1 phosphorylation was inhibited by creatine injection using eleven FAD4T mice and by cerebellar medullary pool puncture,and the expression of target proteins was examined by immunohistochemistry and immunofluorescence after postmortem sampling.Results Compared with the age controls,interferon-γ(IFN-γ),an activating cytokine of the STAT1 signaling pathway,and SOCS1,a negative regulator of STAT1 activation,were both significantly up-regulated,STAT1 phosphorylation was enhanced,and the ferroptosis markers ferritin light chain(FTL)and cystine/glutamate transporter(xCT)increased markedly in the cortex of AD human brains;Creatine treatment of FAD4T mice resulted in a reduction of both IFN-γ and SOCS1,and a significant decrease in the ferroptosis markers FTL and xCT(SLC7A11).Conclusion Creatine ameliorates neuronal ferroptosis in AD model mice by reducing neuronal STAT1-SOCS1 signalling activation.

OBJECTIVE: To investigate the accuracy and safety of pedicle screw placement using 3D-printed auxiliary guides in scoliosis correction surgery for adolescents. METHODS: A retrospective analysis was conducted on the clinical data of 51 patients who underwent posterior scoliosis correction surgery from January 2020 to March 2023. Among them, there were 35 cases of adolescent idiopathic scoliosis and 16 cases of congenital scoliosis. The patients were divided into two groups based on the auxiliary tool used:the 3D-printed auxiliary guide screw placement group (3D printing group) and the free-hand screw placement group (free-hand group, without auxiliary tools). The 3D printing group included 32 patients (12 males and 20 females) with an average age of (12.59±2.60) years;the free-hand group included 19 patients (7 males and 12 females) with an average age of (14.58±3.53) years. The two groups were compared in terms of screw placement accuracy and safety, spinal correction rate, intraoperative blood loss, number of intraoperative fluoroscopies, operation time, hospital stay, and preoperative and last follow-up scores of the Scoliosis Research Society-22 (SRS-22) questionnaire. RESULTS: A total of 707 pedicle screws were placed in the two groups, with 441 screws in the 3D printing group and 266 screws in the free-hand group. All patients in both groups successfully completed the surgery. There was a statistically significant difference in operation time between the two groups (P<0.05). The screw placement accuracy rate of the 3D printing group was 95.46% (421/441), among which the Grade A placement rate was 89.34% (394/441);the screw placement accuracy rate of the free-hand group was 86.47% (230/266), with a Grade A placement rate of 73.31% (195/266). There were statistically significant differences in the accuracy of Grade A, B, and C screw placements between the two groups (P<0.05), while no statistically significant differences were observed in intraoperative blood loss, number of fluoroscopies, correction rate, or hospital stay (P>0.05). In the SRS-22 questionnaire scores, the scores of functional status and activity ability, self-image, mental status, and pain of patients in each group at the last follow-up were significantly improved compared with those before surgery (P<0.05), but there were no statistically significant differences in all scores between the two groups (P>0.05). CONCLUSION In scoliosis correction surgery, compared with traditional free-hand screw placement, the use of 3D-printed auxiliary guides for screw placement significantly improves the accuracy and safety of screw placement and shortens the operation time.
Humans ; Male ; Scoliosis/surgery* ; Female ; Adolescent ; Printing, Three-Dimensional ; Retrospective Studies ; Pedicle Screws ; Child

AIM To investigate the role of Tripterygium wilfordii polyglycosides as an inhibitor of pulmonary fibrosis progression in rats.METHODS In contrast to the six rats randomly selected into the blank group,another 34 rats were induced into a rat model of pulmonary fibrosis by bleomycin sulfate ( 5 mg/mL) injection using tracheal puncture followed by 7 days later random assignment of the survival thirty rats into the model group,the prednisone acetate group (1.17 mg/kg) and the low,medium and high dose tripterygium wilfordii polyglycosides groups (1,3,6 mg/kg) for 21 days corresponding dosing of the drugs.The general characteristics of rats were observed during administration.After the administration,the rats had their pulmonary morphology observed;their lung coefficients of each group compared;their structural changes of lung tissue observed using HE staining;their collagen deposition observed by Masson staining;and their hyperplastic conditions assessed by the criteria for judging pulmonary fibrous hyperplasia;their serum HYP,TNF-α,IL-1β and IL-6 levels detected by ELISA;their pulmonary expressions of miR-146a,NF-κB and Col-I mRNA detected by RT-qPCR method;and their pulmonary protein expressions of p-P65,IRAK1,TRAF6 and α-SMA detected by Western blot.RESULTS Compared with the blank group,the model group displayed increased levels of serum TNF-α,IL-6,IL-1β and HYP ( P<0.01);decreased pulmonary miR-146a mRNA expression ( P<0.01);and increased expressions of NF-κB,Col-I mRNA and p-P65,IRAK1,TRAF6 and α-SMA protein ( P<0.01 ).Compared with the model group,the groups intervened with either prednisone acetate or Tripterygium wilfordii polyglycoside shared differently improved alveolar structure and inflammatory cell infiltration;reduced fibrosis;increased pulmonary miR-146a mRNA expression ( P<0.01);increased levels of TRAF6-α,IL-6,IL-1β and HYP in serum,and expressions of NF-κB and Col-I mRNA and expression of p-P65,IRAK1,TRAF6 and α-SMA protein of the lung tissue ( P<0.05,P<0.01) as well.CONCLUSION Tripterygium wilfordii polyglycosides can delay the progression of pulmonary fibrosis in rats,and its mechanism may be related to the regulation via miR-146/NF-κB signaling pathway.

Air Pollution/analysis* ; Environmental Exposure/analysis* ; China/epidemiology* ; Air Pollutants/analysis* ; Particulate Matter/analysis* ; Environmental Monitoring