Background: Infantile hemangioma (IH) is a common benign vascular tumor that occurs during infancy. Oral propranolol is used as a first-line treatment. However, standardized guidelines for evaluating treatment efficacy, particularly the appropriate timing and parameters for Doppler ultrasound (US), have not been established. This study reports on the evaluation of therapeutic efficacy of oral propranolol solution in IH patients using Doppler US, and aims to propose the appropriate timing and parameters for using Doppler US based on this experience. Methods: A retrospective analysis was conducted on 120 patients with IH who were treated with oral propranolol solution and maintained for over 6 months from May 2017 to April 2023. Doppler US evaluation of IH was performed at diagnosis, 1-2 and 6-12 months after treatment initiation, and 6 months post-therapy cessation. A complete response (CR) was identified as a reduction in vascularity along with a decrease in longest diameter (LD) or thickness of 50% or more. Recurrence was evaluated based on increased vascularity or size 6 months after treatment discontinuation. Results: Of 120 patients with IH, 82 females and 38 males were analyzed. IH was first detected at a median age of 12 days (range, 1-240 days), and treatment began at 76 days (range, 27-570 days), continuing for an average of 10.4 months (range, 5-24 months). Initial Doppler US measurements showed an LD of 2.65±1.52 cm and a thickness of 0.79±0.55 cm, with prominent vascularity. After 1-2 months of treatment, LD and thickness decreased by 12.9% and 25.9%, respectively. By 6-12 months, reductions reached 37.2% and 53.6%. CR occurred in 77 patients (64.2%) after 6-12 months of treatment. Eleven patients (9.2%) experienced a recurrence. Conclusion Doppler US is a valuable modality for evaluating the characteristics, treatment response, and recurrence of IH treated with oral propranolol.

Background: The tibiofibular syndesmosis is essential for preserving the stability of the ankle. Acute syndesmotic injuries with evident or latent instability usually warrant surgical interventions. This cadaveric study examines and compares biomechanical characteristics between the following treatments for syndesmosis injuries: suture-button fixation plus syndesmotic repair and screw fixation. Methods: The lower extremities of 10 cadavers disarticulated at the knee joints were used, yielding 20 feet. Ten feet underwent surgery using the suture-button fixation with syndesmotic repair, while the remaining 10 feet underwent surgery using screw fixation. Before surgical treatment of syndesmosis injuries, each cadaveric lower limb underwent preliminary physiological cyclic loading, which was followed by a series of postfixation cyclic loading tests after the surgical procedure. Results: Our principal finding is that suture-button fixation with syndesmotic repair provided torsional strength comparable to that of screw fixation. The mean failure torque did not differ between the 2 groups, but the rotational stiffness was significantly lower in the suture-button fixation/augmentation group. Conclusions Suture-button fixation/augmentation facilitates flexible (physiological) syndesmosis movement and may be a useful alternative treatment for ankle syndesmosis injury.

The detrimental effects of hyperlipidemia on the healing of rotator cuff tears are well documented. The proposed underlying mechanisms for these effects include alterations in the extracellular matrix, inflammation, and oxidative stress, which hamper the reparative processes in the affected tendon tissues. Recent therapeutic strategies target these pathways, reflecting a growing body of research dedicated to mitigating these effects and promoting healing. This literature review aims to provide a comprehensive understanding of the pathophysiology underlying rotator cuff tears, examine the interplay between hyperlipidemia and rotator cuff tear healing, synthesize current knowledge on contributing biological mechanisms, and outline potential therapeutic interventions to optimize clinical management and treatment outcomes for patients.

Background: This study aimed to investigate changes after repeated subacromial drug injections in a rat model of normal rotator cuff. Methods: Thirty-nine male Sprague-Dawley rats were divided into groups 1 (no injection, n = 3), 2 (parecoxib, n = 18; 6 subgroups, n = 3 each; 0.5 mg/kg), and 3 (triamcinolone, n = 18; 6 subgroups, n = 3 each; 0.3 mg/kg). Groups 2 and 3 received subacromial injections 1–6 times once weekly for 6 weeks. The supraspinatus and infraspinatus tendons and muscles were used for biomechanical and histological evaluation. The subacromial bursa was used to analyze the prostaglandin E2 (PEG2) level. Results: In the biomechanical test, load-to-failure and ultimate stress decreased in groups 2 and 3 with repeated injections and the values were significantly lower in group 3 than in group 1 only at the sixth injection (p = 0.007 and p = 0.008, respectively). On the Bonar score, the cellularity, ground substance, and total score were significantly different among the 3 groups at the fifth and sixth injections (cellularity: p = 0.028 and p = 0.033, ground substance: p = 0.018 and p = 0.006, and total score: p = 0.029 and p = 0.027, respectively). The myocyte cross-sectional area of the infraspinatus muscle showed a significant difference among the 3 groups at the third and fourth injections (p = 0.031 and p = 0.020, respectively). The PEG2 level in the subacromial bursa was significantly different among the 3 groups at the third, fifth, and sixth injections (p = 0.019, p = 0.004, and p = 0.004, respectively). Conclusions In the rat model of normal rotator cuff, repeated local injections of the cyclooxygenase-2 inhibitor showed fewer negative effects on the biomechanical and histological properties of the normal tendon than triamcinolone.

Background: This study explores effective fixation methods for Pauwel type III femoral neck fractures by evaluating the biomechanical benefits of adding a screw to the Femoral Neck System (FNS). Methods: Computed tomography (CT) scans of an 82-year-old female patient with an intertrochanteric fracture were used to establish a finite element femur model with heterogeneous material properties. Finite element models of Pauwel type III fractures were created with and without an additional screw. The central and inferior trajectories of the FNS bolt were examined separately and combined with an additional screw for virtual fixation. Walking and stair-climbing loads were applied. Results: With the addition of a screw, both peak maximum and minimum principal strains consistently stayed comparable or decreased in models with both central and inferior bolt trajectories, while the volume of elements with principal strain exceeding 1% decreased by more than half. The peak von Mises stress observed in the implants ranged from 215.7 to 359.3 MPa, remaining below the titanium alloy's yield strength of 800 MPa. For normal walking, the addition of a screw to the central bolt trajectory model decreased the fracture gap by 50.6% and reduced sliding distance by 8.6%. For the inferior bolt trajectory, the gap was reduced by 57.9% and sliding distance by 25.0%.Under stair-climbing conditions, these improvements were also evident; the central trajectory model saw a halved fracture gap and a 7.9% decrease in sliding distance, while the inferior trajectory model experienced a 55.7% gap reduction and a 27.2% decrease in sliding distance. The additional screw increased the area ratio of the fracture site experiencing interfragmentary compression 34%–39%, while the additional screw alleviated peak interfragmentary compression by 12%–18% under both normal walking and stair-climbing conditions. Conclusions The addition of a screw reduced the fracture gap, sliding distance, and peak interfragmentary compression, while increasing the area ratio of interfragmentary compression under both walking and stair-climbing loads, regardless of the FNS bolt trajectory, suggesting a better mechanical environment for fracture healing.

Background: This study aimed to evaluate the degree of glenoid concavity restoration and its effect on surgical failure after arthroscopic bony Bankart repair for recurrent anterior shoulder instability with a bony Bankart lesion. Methods: Forty-one patients who underwent arthroscopic bony Bankart repair for recurrent anterior shoulder instability with a bony Bankart lesion were retrospectively evaluated. All patients underwent 3-dimensional computed tomography (3D-CT) preoperatively to evaluate the glenoid concavity using the bony shoulder stability ratio (BSSR). Bony fragments were incorporated to the anterior glenoid during arthroscopic stabilization procedure. All patients were reevaluated by 3D-CT at postoperative 1 year to assess the changes in the BSSR and the final glenoid bone defect size after bony Bankart repair. Clinical outcomes including surgical failure were evaluated at least 2 years after surgery. Results: The BSSR significantly increased after surgery (26.0% ± 14.0% preoperatively and 35.5% ± 13.2% postoperatively, p < 0.001). Preoperative glenoid bone defect size was 16.2% ± 8.1%, and bony Bankart fragment size was 11.3% ± 7.2%. Four patients (9.8%) had recurrent instability requiring revision surgery. In patients with surgical failure, the BSSR was not improved after surgery (18.2% ± 13.3% preoperatively and 23.1% ± 17.3% postoperatively, p = 0.24). In contrast, patients without surgical failure showed significantly improved BSSR after surgery (26.9% ± 14.0% preoperatively and 36.9% ± 12.2% postoperatively, p < 0.001).No significant differences were found in the final glenoid bone defect size (6.6% ± 5.9% in patients with surgical failure vs. 6.2% ± 5.7% in patients without surgical failure, p = 0.92) and bony Bankart fragment nonunion rate (0% in patients with surgical failure vs. 5.4% in patients without surgical failure, p = 0.99) between patients with and without surgical failure. Conclusions Glenoid concavity, as represented by the BSSR, improved after arthroscopic bony Bankart repair, and satisfactory restoration of the glenoid concavity led to successful clinical outcomes without surgical failure. The BSSR could be considered an important factor for predicting clinical outcomes after arthroscopic bony Bankart repair. However, further research including more contributing factors is needed to better analyze the impact of the BSSR on clinical outcomes.

Background: To identify the optimal surgical technique for single-level anterior cervical discectomy and fusion (ACDF), this study compared surgical outcomes and incidence of adjacent segment degeneration (ASD) in patients undergoing single-level ACDF using cage alone single-level fusion and plate fixation techniques. Methods: This single-center retrospective study (2003–2018) included patients who underwent single-level ACDF with either plate fixation (PLATE) or cage (CAGE) alone. The radiologic and clinical outcomes between the 2 surgical groups were compared over a 4-year follow-up period. Outcomes of interest included parameters related to range of motion, sagittal alignment, as well as fusion, subsidence, and ASD rates. Clinical outcomes were evaluated using the Neck Disability Index (NDI) and visual analog scale (VAS) for pain. Dysphagia and hoarseness rates were estimated based on medical records. Results: Forty-seven patients were included (n=17 in CAGE group). In the CAGE group, 94.1% of the patients had Bridwell grade 1 or 2, compared to 83.3% in the PLATE group (p = 0.396). Subsidence occurred in 12.5% and 3.6% of the CAGE and PLATE cases, respectively (p = 0.543). Segmental kyphosis progressed in the CAGE group compared to the PLATE group at 12, 24, and 48 months (p < 0.001). Radiographic ASD was observed in 41.2% and 30.0% of patients in the CAGE and PLATE groups, respectively, with a higher incidence in the upper segments for both groups. Preoperative NDI scores were similar between the groups; however, postoperatively, the CAGE group had significantly lower NDI scores (3.50 ± 2.74 vs. 8.00 ± 5.81) at 4 years (p = 0.020). Neck pain VAS scores also showed significant improvement in the CAGE group (2.33 ± 2.94) compared with that in the PLATE group (3.07 ± 2.31) at 4 years (p = 0.045). Both groups showed comparable arm pain VAS scores at 2 and 4 years postoperatively. Postoperative dysphagia occurred in 1 patient in the PLATE group, resolving almost completely by 1 year. Conclusions Single-level ACDF using a cage alone technique demonstrated favorable radiologic and clinical outcomes overall compared to plate-augmented ACDF. However, plate augmentation is recommended for patients with severe cervical kyphosis or those at high risk of subsidence.

Background: The removal of a well-fixed acetabular cup is a challenging, labor-intensive, and time-consuming step during revision hip arthroplasty. Although the advent of the manual osteotome, Explant, has simplified the procedure, it is still a stressful process as it dissipates the surgeon’s strength and time and risks an iatrogenic pelvic fracture. Recently, EZX, a powered tool for extraction of well-fixed acetabular cups with semicircular blade was invented. This study aimed to compare Explant and EZX in an experimental condition for their efficacy and safety. Methods: Cementless acetabular cups were press-fitted to 20 hemipelvic polyurethane models using foam adhesives. Ten cups were removed with each tool for comparison of the elapsed time, loads on the entire hemipelvis, periacetabular strain and temperature, volume of periacetabular bone removed, and diameter of the remaining acetabular rim. Strains and loads were quantitatively assessed using strain gauges and load cells for precise and reliable measurements. Results: The mean duration required to remove a well-fixed cup with EZX was 38.5 seconds (range, 25–55), whereas that with Explant was 543.7 seconds (range, 214–1,051) (p < 0.001). The load on the entire hemipelvis with EZX (mean, 9.1 kgf; range, 6.4–11.3) was 33% lower than that with Explant (mean, 13.6 kgf; range, 9.2–17.1) (p < 0.001). The periacetabular peak strains at the 3 positions with EZX were significantly lower than those with Explant (p < 0.001). The temperature during the removal did not differ significantly between the 2 tools. Although the mean volume of bone loss with Explant was 2.4 mL more than that with EZX (p < 0.001), the mean diameters of the remaining acetabular rim were not significantly different, measuring 54.1 mm with both tools. Conclusions The present experiment revealed that a well-fixed cup could be removed using a powered tool with less strength and time and less load on the entire pelvis. Although the powered tool removed a larger volume of bone, the diameters of the remaining acetabular rims were equivalent. This tool may help surgeons remove well-fixed cups in a short time and reduce the deforming load on the bone around the cup without increasing the size of the subsequent reconstruction cup.