Fire twinkling is the common method in cupping therapy. In the teaching materials of acupuncture and moxibustion, and the national standard, Standardized Manipulations of Acupuncture and Moxibustion-Part 5: Cupping Therapy, this cupping technique is operated by igniting an alcohol-soaked cotton ball held with a forceps, placing it inside the cup, taking it out after "turning around in several circles", and placing the cup on the selected area. Based on the clinical experience of chief physician LI Yan, a high-efficient and safe fire twinkling was developed. Clamping the middle part of the cotton ball with a holder, dipping it in 95% ethanol, and squeezing the cotton ball to ensure no ethanol drops left; holding the cup with the dominant hand and covering the ignited cotton ball vertically, removing the cup immediately when the ball touching the cup bottom. Such manipulation mode, "flame going in and out directly", can avoid the potential safety hazards such as residual ethanol left on the cup opening, overheating of cup opening and accidentally falling-off of the ignited cotton ball.
Humans ; Cupping Therapy/instrumentation* ; Acupuncture Therapy/instrumentation* ; Fires

To explore the differences in biological gas production in the waterlogged zone of a coal seam fire-affected area, in this study the in-situ gas production experiment was conducted with the mine water from aquitard layers in coal seam fire zones in Xinjiang. The results showed that the biogas production first increased and then decreased with the increase in distance, and the highest gas production reached 216.55 mL. The changes in key metabolic pathways during the anaerobic fermentation of coal were analyzed, which showed that as the distance from the aquitard layer in the coal seam fire zone increased, the methanogenesis pathways gradually shifted from acetic acid decarboxylation and carbon dioxide reduction to acetic acid decarboxylation and methylamine methanogenesis. The significant variability in the in-situ mine water reservoir conditions contributed to the differences. In addition, the reservoir pressure and temperature increased as the distance from the fire zone became longer, and the salinity of the farthest mine water in the reverse fault was the highest due to the lack of groundwater supply. Pearson correlation analysis revealed significant correlations of microbial communities with key functional genes and the types and concentrations of ions. The ions significantly influencing microbial enzymatic metabolic activities included Al³⁺, Fe²⁺, Co²⁺, Ni²⁺, Cu²⁺, Zn²⁺, Mg²⁺, PO₄^3-, and Mo⁶⁺. The differences in metabolic pathways were attributed to the integrated effects of a co-occurring environment with multiple ions. The gas production simulation experiments and metagenomic analyses provide data support for the practical application of in-situ biogas experiments, laying a foundation for engineering applications.
Biofuels ; Coal ; Methane/biosynthesis* ; Fires ; Groundwater ; Coal Mining ; Fermentation ; China ; Anaerobiosis

No abstract available.
Fires ; Open Access Publishing

PURPOSE: The aim of this study was to investigate the effect of different numbers of heat treatments applied to superstructure porcelain on optical, thermal, and phase formation properties of zirconia.MATERIALS AND METHODS: Forty zirconia specimens were prepared in the form of rectangular prism. Specimens were divided into four groups (n = 10) according to the number of firing at heating values of porcelain. Color differences and translucency parameter were measured, and X-ray diffraction (XRD) analysis and differential scanning calorimetry (DSC) were performed. Data were analyzed with analysis of variance (ANOVA).RESULTS: There were no statistically significant differences in ΔE, TP, L, a, and b value changes of the zirconia specimens as a result of repetitive firing processes (P>.05).CONCLUSION: Although additional firing processes up to 4 increase peak density in thermal analysis, additional firing processes up to 4 times can be applied safely as they do not result in a change in color and phase character of zircon frameworks.
Calorimetry, Differential Scanning ; Dental Porcelain ; Fires ; Heating ; Hot Temperature ; X-Ray Diffraction

PURPOSE: To characterize associated reactions (ARs) in the contralateral arm across multiple muscles during unimanual tasks and to identify factors related to ARs in children with cerebral palsy (CP).MATERIALS AND METHODS: This was a prospective, cross-sectional study of 35 children with CP. The extent of ARs of the contra-lateral, non-task hand was assessed while performing three unimanual tasks (opening and clenching the fist, a finger opposition task, and tapping fingers). The occurrence of ARs in each trial was evaluated separately for each task using a four-point scale (total scores ranged from 0 to 12). Surface electromyography (SEMG) was used to measure the firing activity of the muscles of the opposite arm during the task. The Manual Ability Classification System and Melbourne Assessment 2 (MA-2) were used to evaluate upper limb function.RESULTS: AR scores were higher in the more-affected limb than in the less-affected limb. SEMG data on the non-task hand showed motor overflow up to the elbow muscles in the more-affected limb. Root mean square ratios of EMG signals were significantly higher in children with ARs than in children without ARs. Multiple regression analysis showed both age and MA-2 to be significant factors related to ARs in the more-affected limb.CONCLUSION: Children with visible ARs showed motor overflow in the non-task limb during unimanual hand tasks. Age and upper limb function were significantly related to the extent of ARs in the more-affected limb of children with CP.
Arm ; Cerebral Palsy ; Child ; Classification ; Cross-Sectional Studies ; Elbow ; Electromyography ; Extremities ; Fingers ; Fires ; Hand ; Humans ; Muscles ; Prospective Studies ; Upper Extremity

Cotinine ; Daegu ; Firefighters ; Fires ; Humans ; Male ; Sensitivity and Specificity ; Smoke ; Smoking ; Tobacco Use

Fires in operating rooms rarely occur. However, this type of disaster can complicate almost any surgical procedure. Fuel, heat and oxygen are related with fire outbreak. When ignition sources such as alcohol-based surgical preparation solutions are present, the risk of an operating room fire increases, and burns are more severe in such conditions. Many manufacturers recommend waiting at least three minutes after application to allow complete drying for reduce fire risk. There are a few studies regarding flame burns in the operation room, although most of these studies are related to preoperative skin preparation. However, alcohol containing solutions can be used occasionally for cleansing of the operation field after the surgery, therefore, the surgical team should pay attention to surgical fires, even if they have completed the operation successfully. We present our case of a post-operative flame burn and introduce some precautions that will reduce the risk of alcohol burns.]]>
Burns ; Disasters ; Electrocoagulation ; Fires ; Hot Temperature ; Operating Rooms ; Oxygen ; Skin

OBJECTIVE: Assessing the severity of injury and predicting outcomes are essential in traumatic brain injury (TBI). However, the respiratory rate and Glasgow Coma Scale (GCS) of the Revised Trauma Score (RTS) are difficult to use in the prehospital setting. This investigation aimed to develop a new prehospital trauma score for TBI (NTS-TBI) to predict mortality and disability.METHODS: We used a nationwide trauma database on severe trauma cases transported by fire departments across Korea in 2013 and 2015. NTS-TBI model 1 used systolic blood pressure < 90 mmHg, peripheral capillary oxygen saturation < 90% measured via pulse oximeter, and motor component of GCS. Model 2 comprised variables of model 1 and age >65 years. We assessed discriminative power via area under the curve (AUC) value for in-hospital mortality and disability defined according to the Glasgow Outcome Scale with scores of 2 or 3. We then compared AUC values of NTS-TBI with those of RTS.RESULTS: In total, 3,642 patients were enrolled. AUC values of NTS-TBI models 1 and 2 for mortality were 0.833 (95% confidence interval [CI], 0.815 to 0.852) and 0.852 (95% CI, 0.835 to 0.869), respectively, while AUC values for disability were 0.772 (95% CI, 0.749 to 0.796) and 0.784 (95% CI, 0.761 to 0.807), respectively. AUC values of NTS-TBI model 2 for mortality and disability were higher than those of RTS (0.819 and 0.761, respectively) (P < 0.01).CONCLUSION: Our NTS-TBI model using systolic blood pressure, motor component of GCS, oxygen saturation, and age was feasible for prehospital care and showed outstanding discriminative power for mortality.
Anoxia ; Area Under Curve ; Blood Pressure ; Brain Injuries ; Capillaries ; Fires ; Glasgow Coma Scale ; Glasgow Outcome Scale ; Hospital Mortality ; Humans ; Hypotension ; Korea ; Mortality ; Observational Study ; Oxygen ; Quality Improvement ; Respiratory Rate

PURPOSE: The purpose of this study was to identify the relationships among occupational identity, social support, posttraumatic growth, and health-related quality of life regarding firefighters.METHODS: The study was conducted with 149 firefighters working at two fire stations in South Gyeongsang Province. Data were collected between August and September 2018. There were four research instruments in the structured survey, including the occupational identity scale, social support scale, Korea Posttraumatic Growth Inventory and World Health Organization Quality of Life Assessment Instrument.RESULTS: As a result, the quality of life of firefighters was positively correlated with social support, occupational identity, and posttraumatic growth. The factors associated with the quality of life of firefighters were social support (β=.36, p < .001), and occupational identity (β=.31, p < .001). The total explanatory power of these variables was 53.1%.CONCLUSION: To improve the health-related quality of life of firefighters based on the results of this study, it is necessary to develop support programs to strengthen social support and occupational identity.
Firefighters ; Fires ; Humans ; Korea ; Occupations ; Quality of Life ; Social Identification ; World Health Organization

PURPOSE: To evaluate an effect of additional firing process after sintering of monolithic zirconia crown on marginal and internal fit through three-dimensional analysis. MATERIALS AND METHODS: Ten monolithic zirconia crowns were fabricated using titanium abutment model. Monolithic zirconia crowns were designed, milled, and sintered as a control group, and additional firing with coloring was performed as a test group. Three dimensional analysis were performed by using triple-scan protocol, and cross-section analysis on mesio-distal and disto-lingual section was evaluated to measure marginal and internal fitness. Then, three-dimensional surface difference on between two groups was evaluated (α=.05). RESULTS: There was statistically significant difference between the control group (32.0 ± 24.3 µm) and the test group (17.0 ± 10.8 µm) in the mesial axial wall (P < .02) and the control group (60.2 ± 24.3 µm) and the test group (71.8 ± 21.5 µm) in the distal axial wall (P < .01). There was no statistically significant difference at the remaining point. CONCLUSION: There was no statistical significance on the deviation of inner surface of crown according to firing number, and the results of both group were considered clinically acceptable.
Crowns ; Fires ; Titanium