Objective: Using finite element method (FEM) analysis of a clear aligner (CA), this study aimed to investigate the effects of varying the edentulous space on canine distal bodily movement during space closure following maxillary first premolar extraction. Methods: FEM analysis was used to simulate distal canine bodily movement following maxillary first premolar extraction using CAs. Four CA designs for edentulous spaces were compared: no-pontic, full-pontic, halfpontic, and beam. Three-dimensional models of the tooth components and CA were created. The target was set at a 0.25-mm distal canine movement. Long-term tooth movement was simulated using an iterative calculation method. Results: All the groups initially showed crown displacement, distal tipping, and distal rotation.Over time, the movement patterns differed in relation to the design. The no-pontic design exhibited the greatest displacement and tipping. The beam design exhibited the largest initial displacement but showed the lowest displacement and tipping thereafter. Full- and half-pontic designs yielded intermediate results. Significant force reduction was observed immediately after CA application, and was followed by a gradual decrease. The mean tooth-movement achievement rate was approximately 76.7%. Conclusions The edentulous space design of the CA substantially affected tooth-movement behavior. An iterative simulation is necessary to evaluate longterm tooth-movement patterns. The beam design demonstrated optimal suitability for bodily movement with minimal tipping. For optimal results, additional setup or overcorrection may be necessary.

Objective: To quantitatively analyze and compare the forces and moments generated by thermoformed polyethylene terephthalate glycol (PETG) and direct-printed TC-85 clear aligners (CAs), with various margin designs, during premolar rotation. Methods: In total, 132 CAs were fabricated and divided into four groups (n = 33 per group). Group C consisted of thermoformed PETG aligners with a 2 mm gingival margin. Group E comprised direct-printed TC-85 aligners with equi-gingival margin, whereas Group G utilized direct-printed TC-85 aligners with 2 mm gingival margins.Finally, Group T featured direct-printed TC-85 aligners with an additional 1 mm thickness at the mesial embrasure. The forces and moments were measured using a 6-axis force/moment transducer at 2°, 3°, and 4° of rotation. All measurements were conducted at 37°C to simulate intraoral conditions. Forces were measured in the buccolingual, anteroposterior, and vertical directions, while moments were measured in the mesiodistal, buccolingual, and rotational planes. Results: The PETG aligners (Group C) showed significantly increased buccal and posterior force across the rotation angles (P < 0.05), whereas the intrusive force remained consistent. In contrast, the TC-85 aligners maintained consistent forces across all rotation angles.Direct-printed aligners demonstrated significantly lower intrusive forces than PETG aligners (P < 0.001). Group T exhibited reduced unwanted forces while maintaining effective rotational moments. Furthermore, all direct-printed aligners showed more predictable force delivery patterns than thermoformed aligners. Conclusions Direct-printed TC-85 aligners demonstrated superior force consistency and reduced unwanted side effects compared with traditional PETG aligners. Although marginal design modifications did not significantly improve rotational efficiency, they effectively reduced unwanted intrusive forces.

Background/Aims: The World Health Organization (WHO) aims to eliminate hepatitis C virus (HCV) by 2030; therefore, widespread HCV screening is required. The WHO recommends HCV self-testing (HCVST) as a new approach. We aimed to evaluate disease burden reduction using the HCVST screening strategy and identify the most cost-effective approach. Methods: We developed a dynamic open-cohort Markov model to assess the long-term effects and costeffectiveness of HCVST in the Republic of Korea from 2024 to 2030. Strategies for comparison included universal, birth cohort, high-risk group screening, and no screening, focusing on the following: (1) incremental costeffectiveness ratio (ICER) per disability-adjusted life-year (DALY) saved; (2) severe liver disease cases; and (3) liverrelated death reduction. Results: Universal HCVST screening is the most effective strategy for achieving the WHO goal by 2030, substantially lowering the incidence of severe liver disease by 71% and preventing liver-related deaths by 69%, thereby averting 267,942 DALYs. Moreover, with an ICER of US$8,078 per DALY and high cost-effectiveness, the sensitivity results prove that cost-effectiveness is robust. Although high-risk group screening offers the lowest cost compared with other strategies, its effectiveness in preventing severe liver disease is minimal, falling short of the current WHO goal. Conclusions Our study confirms that universal HCVST screening is a cost-effective strategy aligned with the WHO goal to eliminate HCV by 2030. Despite its higher costs compared to risk-based screening, the disease burden can be significantly reduced by providing effective HCVST access to individuals who might otherwise not be tested.

Background/Aims: The Korean guidelines for Helicobacter pylori treatment were revised in 2020, however, the extent of adherence to these guidelines in clinical practice remains unclear. Herein, we initiated a prospective, nationwide, multicenter registry study in 2021 to evaluate the current management of H.pylori infection in Korea. Methods: This interim report describes the adherence to the revised guidelines and their impact on firstline eradication rates. Data on patient demographics, diagnoses, treatments, and eradication outcomes were collected using a web-based electronic case report form. Results: A total of 7,261 patients from 66 hospitals who received first-line treatment were analyzed.The modified intention-to-treat eradication rate for first-line treatment was 81.0%, with 80.4% of the prescriptions adhering to the revised guidelines. The most commonly prescribed regimen was the 14-day clarithromycin-based triple therapy (CTT; 42.0%), followed by tailored therapy (TT; 21.2%), 7-day CTT (14.1%), and 10-day concomitant therapy (CT; 10.1%). Time-trend analysis demonstrated significant increases in guideline adherence and the use of 10-day CT and TT, along with a decrease in the use of 7-day CTT (all p<0.001). Multivariate logistic regression analysis revealed that guideline adherence was significantly associated with first-line eradication success (odds ratio, 2.03; 95% confidence interval, 1.61 to 2.56; p<0.001). Conclusions The revised guidelines for the treatment of H. pylori infection have been increasingly adopted in routine clinical practice in Korea, which may have contributed to improved first-line eradication rates. Notably, the 14-day CTT, 10-day CT, and TT regimens are emerging as the preferred first-line treatment options among Korean physicians.

Purpose: This study analyzed the pathological complete response (pCR) rates, long-term outcomes, and biological features of human epidermal growth factor receptor 2 (HER2)-zero, HER2-low, and HER2-positive breast cancer patients undergoing neoadjuvant treatment. Methods: This single-center study included 1,667 patients who underwent neoadjuvant chemotherapy from 2008 to 2014. Patients were categorized by HER2 status, and their clinicopathological characteristics, chemotherapy responses, and recurrence-free survival (RFS) rates were analyzed. Results: Patients with HER2-low tumors were more likely to be older (p = 0.081), have a lower histological grade (p < 0.001), and have hormone receptor (HorR)-positive tumors (p < 0.001). The HER2-positive group exhibited the highest pCR rate (23.3%), followed by the HER2-zero (15.5%) and HER2-low (10.9%) groups. However, the pCR rate did not differ between HER2-low and HER2-zero tumors in the HorR-positive or HorR-negative subgroups.The 5-year RFS rates increased in the following order: HER2-low, HER2-positive, and HER2-zero (80.0%, 77.5%, and 74.5%, respectively) (log-rank test p = 0.017). A significant survival difference between patients with HER2-low and HER2-zero tumors was only identified in HorR-negative tumors (5-year RFS for HER2-low, 74.5% vs. HER2-zero, 66.0%; log-rank test p-value = 0.04). Multivariate survival analysis revealed that achieving a pCR was the most significant factor associated with improved survival (hazard ratio [HR], 4.279; p < 0.001).Compared with HER2-zero, the HRs for HER2-low and HER2-positive tumors were 0.787 (p = 0.042) and 0.728 (p = 0.005), respectively. After excluding patients who received HER2-targeted therapy, patients with HER2-low tumors exhibited better RFS than those with HER2-zero (HR 0.784, p = 0.04), whereas those with HER2-positive tumors exhibited no significant difference compared with those with HER2-low tumors (HR, 0.975; p = 0.953). Conclusion Patients with HER2-low tumors had no significant difference in pCR rate compared to HER2-zero but showed better survival, especially in HorR-negative tumors.Further investigation into biological differences is warranted.

Background: and Purpose Previous research on patients with acute ischemic stroke (AIS) has shown a 0.5% incidence of major gastrointestinal bleeding (GIB) requiring blood transfusion during hospitalization. The existing literature has insufficiently explored the long-term incidence in this population despite the decremental impact of GIB on stroke outcomes. Methods: We analyzed the data from a cohort of patients with AIS admitted to 14 hospitals as part of a nationwide multicenter prospective stroke registry between 2011 and 2013. These patients were followed up for up to 6 years. The occurrence of major GIB events, defined as GIB necessitating at least two units of blood transfusion, was tracked using the National Health Insurance Service claims data. Results: Among 10,818 patients with AIS (male, 59%; mean age, 68±13 years), 947 (8.8%) experienced 1,224 episodes of major GIB over a median follow-up duration of 3.1 years. Remarkably, 20% of 947 patients experienced multiple episodes of major GIB. The incidence peaked in the first month after AIS, reaching 19.2 per 100 person-years, and gradually decreased to approximately one-sixth of this rate by the 2nd year with subsequent stabilization. Multivariable analysis identified the following predictors of major GIB: anemia, estimated glomerular filtration rate <60 mL/min/1.73 m2 , and a 3-month modified Rankin Scale score of ≥4. Conclusion Patients with AIS are susceptible to major GIB, particularly in the first month after the onset of AIS, with the risk decreasing thereafter. Implementing preventive strategies may be important, especially for patients with anemia and impaired renal function at stroke onset and those with a disabling stroke.

Objective: Using finite element method (FEM) analysis of a clear aligner (CA), this study aimed to investigate the effects of varying the edentulous space on canine distal bodily movement during space closure following maxillary first premolar extraction. Methods: FEM analysis was used to simulate distal canine bodily movement following maxillary first premolar extraction using CAs. Four CA designs for edentulous spaces were compared: no-pontic, full-pontic, halfpontic, and beam. Three-dimensional models of the tooth components and CA were created. The target was set at a 0.25-mm distal canine movement. Long-term tooth movement was simulated using an iterative calculation method. Results: All the groups initially showed crown displacement, distal tipping, and distal rotation.Over time, the movement patterns differed in relation to the design. The no-pontic design exhibited the greatest displacement and tipping. The beam design exhibited the largest initial displacement but showed the lowest displacement and tipping thereafter. Full- and half-pontic designs yielded intermediate results. Significant force reduction was observed immediately after CA application, and was followed by a gradual decrease. The mean tooth-movement achievement rate was approximately 76.7%. Conclusions The edentulous space design of the CA substantially affected tooth-movement behavior. An iterative simulation is necessary to evaluate longterm tooth-movement patterns. The beam design demonstrated optimal suitability for bodily movement with minimal tipping. For optimal results, additional setup or overcorrection may be necessary.

Objective: To quantitatively analyze and compare the forces and moments generated by thermoformed polyethylene terephthalate glycol (PETG) and direct-printed TC-85 clear aligners (CAs), with various margin designs, during premolar rotation. Methods: In total, 132 CAs were fabricated and divided into four groups (n = 33 per group). Group C consisted of thermoformed PETG aligners with a 2 mm gingival margin. Group E comprised direct-printed TC-85 aligners with equi-gingival margin, whereas Group G utilized direct-printed TC-85 aligners with 2 mm gingival margins.Finally, Group T featured direct-printed TC-85 aligners with an additional 1 mm thickness at the mesial embrasure. The forces and moments were measured using a 6-axis force/moment transducer at 2°, 3°, and 4° of rotation. All measurements were conducted at 37°C to simulate intraoral conditions. Forces were measured in the buccolingual, anteroposterior, and vertical directions, while moments were measured in the mesiodistal, buccolingual, and rotational planes. Results: The PETG aligners (Group C) showed significantly increased buccal and posterior force across the rotation angles (P < 0.05), whereas the intrusive force remained consistent. In contrast, the TC-85 aligners maintained consistent forces across all rotation angles.Direct-printed aligners demonstrated significantly lower intrusive forces than PETG aligners (P < 0.001). Group T exhibited reduced unwanted forces while maintaining effective rotational moments. Furthermore, all direct-printed aligners showed more predictable force delivery patterns than thermoformed aligners. Conclusions Direct-printed TC-85 aligners demonstrated superior force consistency and reduced unwanted side effects compared with traditional PETG aligners. Although marginal design modifications did not significantly improve rotational efficiency, they effectively reduced unwanted intrusive forces.

The initial molecular cytogenetic characteristics of blasts plays a significant role in determining the treatment course of B-cell acute lymphoblastic leukemia (B-ALL).B-ALL with intrachromosomal amplification of chromosome 21 (iAMP21) has been well known to have unfavorable prognosis. Also, there are previously recognized germline mutations that increase the risk of ALL, such as trisomy 21, Down syndrome. This case report is about a 16-year-old girl who presented with lymphadenitis, purpura, and fever followed by initial lab of elevated white blood cell with blasts.She had some notable facial features, but no typical Down syndrome related one.Bone marrow biopsy and fluorescence in situ hybridization finalized the diagnosis as B-ALL with iAMP21, high-risk group. The minimal residual disease-negative complete remission was achieved after the induction chemotherapy with Korean multicenter high-risk protocol. However, abnormal karyotype was sustained in bone marrow. Microarrays with her buccal swab raised the possibility that the abnormal karyotype was not from the leukemic blasts but rather from the germline. Although she underwent scheduled chemotherapy uneventfully as slow early responder type, thrombocytopenia and abnormal karyotype persisted, leading to the diagnosis of acute myeloid leukemia. Additional chemotherapy and peripheral blood stem cell transplantation was performed which resulted in engraftment. This case highlights the discovery of a constitutional genetic aberration, which played like a silent yet critical background factor for B-ALL with iAMP21. As the number of reported cases are limited, the role of germline chromosome 21 mutation as the indicator for prognosis of B-ALL should be studied further.