Introduction: Increase in the number of primary shoulder arthroplasty has led to an increase in the number of revisions which presents many complex challenges and often has inferior outcomes. Materials and methods: Data was collected retrospectively, and patients were classified using Dines classification. Comprehensive case reviews were done to identify preoperative and intra-operative challenges. The primary outcome measure was Oxford shoulder score (OSS). The secondary measures were range of motion (ROM) and patient satisfaction (very satisfied, satisfied, not satisfied or worse). Results: A total of 32 patients were identified with a mean age of 67.64 years and the most common cause of revision was a combination of bone and soft tissue failure (39.3%). All patients (n=8) with hemiarthroplasty had rotator cuff deficiency while patients with resurfacing had both rotator cuff failure and bony erosion. Four patients needed a proximal humeral osteotomy and six patients needed allograft reconstruction of the glenoid for bone loss. Twentyone shoulders were revised to reverse total shoulder arthroplasty (TSA), 2 to anatomical TSA and 5 were left with cement spacer in situ. Mean duration of follow-up was 41.6 months. Mean OSS at the last follow-up was 26.88 with statistically significant improvement in ROM. There was no statistical difference in clinical outcomes (p>0.05) based on the type of primary prosthesis or cause of revision. A total of 70% patients were pain free. Patients with infection had inferior outcomes with a mean OSS of 17. Conclusion: Management of patients with failed shoulder arthroplasty is often challenging but has good clinical outcome except in infections.

Impacted third molar extractions are one of the most common oral surgical procedures. In cases where a pathological condition is observed, it is relatively easy to decide on surgery. However, cystic changes can be observed in follicular tissues even in cases where pathological changes are not observed on radiography. The present study aimed to evaluate the histopathologic changes in dental follicles associated with radiographically normal impacted lower third molar. One hundred and one dental follicles were obtained after third molar surgeries. The patients with follicular width of less than 2.5 mm in the panoramic radiographs were included in the study. The relationships between pathological changes in follicular tissues and angular position of impacted teeth, age and gender were statistically examined. Cystic changes were observed in 65 (64.3%) of 101 follicles examined. The relationship between cystic changes and the angular position of impacted lower third molars was statistically significant (p < 0.05). Cystic changes were observed in 13 (43.3%) of 30 mesioangular teeth, 24 (80%) of 30 vertical teeth, 19 (65.5%) of 29 horizontal teeth, and 9 (75%) of 12 distoangular teeth. About 60% of cystic changes and 64.06% of inflammation occurred in patients between the ages of 20 and 30. Cystic changes can be observed in the follicular tissues of impacted lower third molars that are radiographically normal. There is a probability of histopathological changes, especially in patients over the age of 20 years and in the impacted lower third molars in the vertical position.

Purpose: This study was conducted to determine the effect of listening to the sound of running water during urodynamics on the patient’s anxiety and parameters in the pressure-flow study. Methods: The population of the study, which was planned in the nonrandomized experimental study design, consisted of patients who will undergo urodynamics in the Urology Department of a city hospital in Istanbul between September 2022 and January 2023, and the sample consisted of 60 patients, 30 of which were in the experimental group and 30 in the control group. During the pressure-flow study, the patients in the experimental group listened to the sound of running water from a smartphone, while the patients in the control group did not undergo any intervention during urodynamics. The level of anxiety in both groups before, during and after urodynamics was evaluated with the visual analogue scale. During the pressure-flow study, it was evaluated whether the patients emptied on command, and the maximum flow rate (Qmax) and the detrusor pressure at the maximum flow rate (PdetQmax) were measured. Bladder outlet obstruction index (PdetQmax–2Qmax) and bladder contractility index (Pdetqmax+5Qmax) were calculated using these values. Results: During the pressure-flow study, in the experimental group patients who listened to the sound of running water from a smartphone; anxiety level mean scores during and after urodynamics were found to be statistically significantly lower than the control group patients (P < 0.001). The mean bladder contractility index score in the experimental group patients was statistically significantly higher than the control group patients (P < 0.001), and the cases of urinating with a catheter during the pressure-flow study were statistically significantly higher than the control group patients (P < 0.001). Conclusions Listening to the sound of running water during urodynamics had a positive effect on reducing anxiety in patients and micturating during pressure-flow study.

Objective To investigate the effects of design parameters such as neck-shaft angle, femoral offset and anteversion angle of total hip arthroplasty ( THA) prosthesis on contact forces of the hip. Methods A musculoskeletal multi-body dynamic model of THA was established based on AnyBody software. The effects of single or multiple factors on hip contact force were studied when the neck-shaft angle, eccentricity and anteversion angle varied within ±10°, ±20 mm and ±10°, respectively. Results The maximum hip contact force increased by 26. 08% when femoral offset was reduced by 20 mm. The maximum hip contact force increased by 5. 99% when the neck-shaft angle increased by 10°. When the anteversion angle increased by 10°, the hip contact force decreased at 0% -24% of gait cycle, with the peak decreasing by 19. 16% . However, the hip contact force was significantly increased at 38% -70% of gait cycle, with the peak increasing by 67. 78% . Conclusions In extramedullary design of the femoral stem, based on reconstruction of the patient’s anatomical parameters, the offset of the femoral stem can be appropriately increased, and the neck-shaft angle and anteversion angle can bereduced to avoid increasing forces on the hip.

The Rejection of childhood vaccination is still a major issue in many countries. The aim of the study was to assess prevalence of Turkish parent refusal and hesitance rate and its associated factors in Childhood vaccination. A crosssectional study was carried out at the General Pediatric Poly Clinic of Ankara Keçören Training and Research Hospital from January – to April 2020. Data was collected using a questionnaire via face to face interviews with parents. We included parents who have 6 months to 7 years old children, who visited the clinic during the study period and who accepted to join the study. A total of 809 mothers and 132 fathers participated in the survey. Among the parents, 1.2% of them refused the vaccination of their children and 4.8 % of them had incomplete vaccination of their children. More than half (67.4%) of the parents have a high level of knowledge about vaccines. knowledge level was statistically significantly different based on the participant’s occupation, income, education background and father’s age (P <0.05). A majority (72.2%) of the participants had good attitudes toward childhood vaccination, there is no statistically significance based on their occupation, age, income and education background (P > 0.05). Parents with one child had bad attitudes towards vaccines (35.4%).

The geometric bone model of patients is an important basis for individualized biomechanical modeling and analysis, formulation of surgical planning, design of surgical guide plate, and customization of artificial joint. In this study, a rapid three-dimensional (3D) reconstruction method based on statistical shape model was proposed for femur. Combined with the patient plain X-ray film data, rapid 3D modeling of individualized patient femur geometry was realized. The average error of 3D reconstruction was 1.597-1.842 mm, and the root mean square error was 1.453-2.341 mm. The average errors of femoral head diameter, cervical shaft angle, offset distance and anteversion angle of the reconstructed model were 0.597 mm, 1.163°, 1.389 mm and 1.354°, respectively. Compared with traditional modeling methods, the new method could achieve rapid 3D reconstruction of femur more accurately in a shorter time. This paper provides a new technology for rapid 3D modeling of bone geometry, which is helpful to promote rapid biomechanical analysis for patients, and provides a new idea for the selection of orthopedic implants and the rapid research and development of customized implants.
Humans ; Imaging, Three-Dimensional/methods* ; Tomography, X-Ray Computed/methods* ; Femur/surgery* ; Femur Head ; Lower Extremity

Aerospace Medicine ; Aviation ; China ; Dermatitis ; Humans ; Medicine

Objective To evaluate biomechanical properties of the personalized titanium alloy short femoral prosthesis by finite element analysis. Methods Based on the validated femoral finite element model, the base of the femoral neck was simulated, and by inserting different short femoral prostheses, four total hip replacement (THR) models, namely, the SMF stem model (Model A), BE1 stem model (Model B), MINI stem model (Model C) and personalized stem model (Model D) were established, respectively. The same loads and constraints were applied to four groups of models, and the von Mises stress distribution and deformation were calculated and analyzed, so as to compare mechanical stability of each model. Results The deformation of all THR models was smaller than that of the femur model under physiological state. The deformation of Model B was close to that of Model C, and the deformation of Model A was close to that of Model D. The peak stress of Model C was higher than that of the other 3 models, reaching 9555 MPa. The overall stress trend was Model C > Model B > Model D> Model A > Model under physiological state. Conclusions The peak stress, stress distribution of personalized short femoral stem were similar to that of SMF stem, with reasonable stress distribution, small stress shielding of the proximal femur, minimum overall deformation and shear stress of the prosthesis, and its effectiveness and stability could meet the requirements of human biomechanics, which could provide references for joint surgeons and prosthesis researchers.

Introduction: The aim of this study is to assess the outcomes of ala carte posteromedial release in children over two years of age who were not responding to the Ponseti method of treatment of idiopathic clubfoot. Materials and Methods: A retrospective observational study from September 2013 to August 2015 was conducted at a tertiary level medical teaching institution. The clubfeet were classified according to the Harold and Walker classification. Radiographic parameters assessed were the talocalcaneal angle (AP, lateral), talus-first metatarsal angle (AP, lateral) and calcaneal-fifth metatarsal angle. The scar and the functional score, according to Laaveg and Ponseti, were evaluated as outcome measures at the final follow-up. Results: Twenty-four children with a mean age of 43.7 ± 24.7 months were enrolled in the study. There was a total of 36 clubfeet: 21 (65.6%) with a poor functional outcome; 12 (37.4%) with excellent to good scar in both horizontal and vertical components. There was a statistical significance between the pre-operative and post-operative radiological parameters (p<0.05). None of the patients presented with any limitation of activities of daily living despite the poor functional outcome in many of the children. There was no significant association between the qualities of scar (horizontal, vertical) and the functional outcome with age at presentation, pre-operative Harold and Walker classification and pre-operative radiographic angles. Conclusion: Surgical intervention in terms of ala carte posteromedial soft tissue release could not produce a good outcome over four years in CTEV. The threshold for surgery in CTEV should be high, given the poor results.

Introduction: Non-alcoholic fatty liver disease (NAFLD) is the most common cause of chronic liver disease worldwide, especially in the Western world and Asia-Pacific regions. This study was designed to determine the prevalence of NAFLD detected by sonographic assessment among the rural indigenous population in Peninsula Malaysia and its association with anthropometric and biochemical factors. Methods: A cross-sectional survey was carried out from January 2014-February 2016. Subjects were recruited among indigenous peninsula Malaysia population in rural villages, aged ≥18 years old. The survey was questionnaire-based followed by anthropometric and blood parameters measurements. All subjects underwent abdominal ultrasound assessment to screen for the presence of NAFLD. Semi-quantitative visual grading was performed to assess for mild, moderate or severe NAFLD. Results: A total of 270 subjects underwent the screening program (mean age 43.3 ±14.0 years). Approximately 53 subjects (19.6 %) were identified with NAFLD. Of those with NAFLD, approximately 83% had moderate grade of fatty liver and the remainder were diagnosed with mild grade. NAFLD was closely associated with age, body mass index (BMI), central obesity, hypertension, total cholesterol (TC), triglyceride/high density lipoprotein-cholesterol (TG/HDL-C) ratio. On multivariate logistic regression, a high BMI (≥23.0 kg/m2), central obesity, and raised TG/HDL-C ratio were independent risk factors for developing NAFLD. Conclusion: This pioneer study defines the prevalence of NAFLD among rural indigenous population in Peninsula Malaysia. Lifestyle-related diseases, such as NAFLD can affect both rural and urban communities with equal severity. High BMI, central obesity, and elevated TG/HDL-C ratio were independent risk factors for developing NAFLD.