Objective: To investigate the epidemiological characteristics of human brucellosis in Jiande City, Zhejiang Province from 2005 to 2024, so as to provide the evidence for strengthening the prevention and control of brucellosis. Methods: Data on brucellosis cases and surveillance in Jiande City from 2005 to 2024 were collected through the Chinese Disease Prevention and Control Information System, the annual brucellosis surveillance reports from the Jiande Center for Disease Control and Prevention, and the annual summaries of brucellosis prevention and control efforts. The epidemiological characteristics of human brucellosis were analyzed using a descriptive epidemiological method. Results: A total of 1 125 individuals were monitored in Jiande City from 2005 to 2024, with 18 seropositive cases identified and the seropositivity rate of 1.60%. The average annual seropositivity rate from 2015 to 2024 was 3.35%, which was significantly higher than that of 0.57% from 2005 to 2014 (P<0.05). There were 10 confirmed brucellosis cases and 8 asymptomatic infections, with no reported deaths. The peak incidence occurred between March and August. Among the 16 towns (streets) in Jiande City, 8 reported brucellosis cases. Of the brucellosis cases, 14 were male and 4 were female, with a male-to-female ratio of 3.5∶1. The majority of cases (13 cases) were aged between 40 and 60 years. Occupational exposure was identified in 16 cases, all of whom were infected through direct hand contact with the excreta, secretions, or animal products of infected sheep or cattle. The primary source of infection was sheep, followed by cattle. Five strains of Brucella were isolated and cultured, all identified as Brucella melitensis biovar 3. Conclusions The brucellosis epidemic in Jiande City remained at a sporadic and low prevalence level from 2005 to 2024, with an increasing trend observed from 2015 to 2024. Male occupational groups aged 40 to 60 years were the key population for brucellosis prevention and control, and sheep were the primary source of infection.

OBJECTIVES: This study aimed to compare the osteogenic performance differences of titanium surface coatings modified by dopamine or silanized graphene oxide, and to provide a more suitable modification scheme for titanium surface graphene oxide coatings. METHODS: Titanium was subjected to alkali-heat treatment and then modified with dopamine and silanization, respectively, followed by coating with graphene oxide. Control and experimental groups were designed as follows: pure titanium (Ti) group; titanium after alkali-heat treatment (Ti-NaOH) group; titanium after alkali-heat treatment and silanization modification (Ti-APTES) group; titanium after alkali-heat treatment and dopamine modification (Ti-DOPA) group; titanium with silanization-modified surface decorated with graphene oxide (Ti-APTES/GO) group; titanium with dopamine-modified surface decorated with graphene oxide (Ti-DOPA/GO) group. The physical and chemical properties of the material surfaces were analyzed using scanning electron microscopy (SEM), contact angle goniometer, X-ray photoelectron spectroscopy (XPS), and Raman spectrometer. The proliferation and adhesion morphology of mouse embryonic osteoblast precursor cells MC3T3-E1 on the material surfaces were observed by cell viability detection and immunofluorescence staining followed by laser confocal microscopy. The effects on the osteogenic differentiation of MC3T3-E1 cells were studied by alkaline phosphatase (ALP) staining, alizarin red staining and quantification, and real-time quantitative polymerase chain reaction. RESULTS: After modification with graphene oxide coating, a thin-film-like structure was observed on the surface under SEM. The hydrophilicity of all experimental groups was improved, among which the Ti-DOPA/GO group had the best hydrophilicity. XPS and Raman spectroscopy analysis showed that the modified materials exhibited typical D and G peaks, and XPS revealed the presence of a large number of oxygen-containing functional groups on the surface. CCK8 assay showed that all groups of materials had no cytotoxicity, and the proliferation level of the Ti-APTES/GO group was higher than that of the Ti-DOPA/GO group. Under the laser confocal microscope, the cells in the Ti-DOPA/GO and Ti-APTES/GO groups spread more fully. The Ti-DOPA/GO and Ti-APTES/GO groups had the deepest ALP staining, and the Ti-APTES/GO group had the most alizarin red-stained mineralized nodules and the highest quantitative result of alizarin red staining. In the Ti-DOPA/GO and Ti-APTES/GO groups, the expression of the early osteogenic-related gene RUNX2 reached a relatively high level, while in the expression of the late osteogenic-related genes OPN and OCN, the Ti-APTES/GO group performed better than the Ti-DOPA/GO group. CONCLUSIONS Ti-APTES/GO significantly outperformed Ti-DOPA/GO in promoting the adhesion, proliferation, and in vitro osteogenic differentiation of MC3T3-E1 cells.
Titanium/chemistry* ; Graphite/chemistry* ; Dopamine/chemistry* ; Animals ; Mice ; Osteogenesis ; Osteoblasts/cytology* ; Surface Properties ; Cell Proliferation ; Silanes/chemistry* ; Cell Adhesion ; Coated Materials, Biocompatible/chemistry* ; Cell Differentiation ; Alkaline Phosphatase/metabolism* ; Microscopy, Electron, Scanning