Compatibility of self-etching dentin adhesives with resin luting cements.
10.5395/JKACD.2005.30.6.493
- Author:
Do Wan KIM
1
;
Sang Jin PARK
;
Kyoung Kyu CHOI
Author Information
1. Department of Conservative Dentistry, Division of Dentistry, Graduate School, Kyung Hee University, Korea. choikkyu@khu.ac.kr
- Publication Type:Original Article
- Keywords:
Compatibility;
Self-etching dentin adhesives;
Resin luting cements;
Microtensile bond strength;
Indirect resin composite block;
Dentin
- MeSH:
Adhesives*;
Dentin*;
Molar, Third;
Resin Cements;
Tooth
- From:Journal of Korean Academy of Conservative Dentistry
2005;30(6):493-504
- CountryRepublic of Korea
- Language:Korean
-
Abstract:
This study was performed to investigate the compatibility between 4 dentin adhesives and 4 resin luting cements. Dentin adhesives used in this study were All-Bond 2 (Bisco Inc., Schaumbrug, IL, USA), Clearfil SE-Bond (Kuraray Medical Inc, Osaka, Japan), Prompt L-Pop (3M Dental Products, St. Paul, MN, USA), One-Up Bond F (Tokuyama corp., Tokyo, Japan). Resin luting cements used in this study were Choice (Bisco Inc., Schaumbrug, IL, USA), Panavia F (Kuraray Medical Inc, Osaka, Japan), RelyX ARC (3M Dental Products, St. Paul, MN, USA), Bistite II DC (Tokuyama corp., Tokyo, Japan). Combination of each dentin adhesive and corresponding resin cement was made to 16 experimental groups. Flat dentin surfaces was created on mid-coronal dentin of extracted mandibular third molars, then dentin surface was polished with 320-grit silicon carbide abrasive papers. Indirect resin composite block (Tescera, Bisco) was fabricated. Its surface for bonding to tooth was polished with silicon carbide abrasive papers. Each dentin adhesive was treated on tooth surface and resin composite overlay were luted with each resin cement. Each bonded specimen was poured in epoxy resin and sectioned occluso-gingivally into 1.0 mm thick slab, then further sectioned into 1.0 x 1.0 mm2 composite-dentin beams. Microtensile bond strength was tested at a crosshead speed of 1.0 mm/min. The data were analysed by one-way ANOVA and Duncan's multiple comparison tests. The results of this study were as follows; 2-step self-etching dentin adhesive which has additional bonding resin is more compatible than 1-step self-etching dentin adhesive.
