Application of digital design and manufacture to refabricate a removable partial denture:A case report
10.3969/j.issn.1001-3733.2025.06.021
- VernacularTitle:应用数字化技术设计和研磨制作可摘局部义齿1例
- Author:
Min YAN
1
;
Min WANG
;
Yulu WU
;
Yan LI
;
Bo GAO
Author Information
1. 710032 西安,口颌系统重建与再生全国重点实验室,国家口腔疾病临床医学研究中心,陕西省口腔医学重点实验室,空军军医大学口腔医院修复科
- Publication Type:Journal Article
- Keywords:
A removable partial denture;
Cuttable resin;
Computer aided design and computer aided manufacture
- From:
Journal of Practical Stomatology
2025;41(6):848-851
- CountryChina
- Language:Chinese
-
Abstract:
Complete dentures can be fabricated by cutting and grinding the resin in one step.It is worth trying to manufacture removable partial dentures through simulating this approach to minimize manual fabrication as much as possible.This article reports on a case where a digitally designed and milled removable partial denture was made from a cuttable resin.After a two-month postoperative follow-up,there was no significant pain or discomfort in the soft or hard tissues.This preliminary study suggests that this digital restoration plan could a-chieve good restoration results and can be further clinically promoted.
