Clinical analysis of reducing adverse ventilator-related events during cardiopulmonary resuscitation with low-peak flow ventilation
10.3969/j.issn.1008-9691.2025.04.005
- VernacularTitle:通过低峰流速通气模式降低心肺复苏患者人机不良反应的临床分析
- Author:
Chaojun QU
1
;
Guiqiong WU
1
;
Yuequn CHEN
1
;
Liqin ZHANG
1
;
Xin TIAN
1
Author Information
1. 丽水市中心医院重症医学科,浙江 丽水 323000
- Publication Type:Journal Article
- Keywords:
Cardiopulmonary resuscitation;
Chest cardiac compressions;
Mechanical ventilation;
Peak flow;
Peak airway pressure
- From:
Chinese Journal of Integrated Traditional and Western Medicine in Intensive and Critical Care
2025;32(4):410-413
- CountryChina
- Language:Chinese
-
Abstract:
Objective To investigate the impact of lower inspiratory peak flow rates on airway peak pressure when using a ventilator to maintain respiratory function during the advanced life support phase of in-hospital cardiopulmonary resuscitation(CPR).Methods A prospective study was conducted,30 patients who underwent CPR for more than 20 minutes admitted to Lishui Municipal Central Hospital between September 2021 and December 2023 were enrolled as the study subjects.Volume controlled ventilation(VCV)with a descending flow waveform was used,while other preset parameters remained unchanged.Airway peak pressure was measured at different peak flow rates(55,50,45,and 40 L/min).The influence of varying flow rates on peak pressure was analyzed.Results During CPR,patients were in a continuous state of chest compressions.When the ventilator parameters were set conventionally,alarms for high airway pressure,low tidal volume(VT),and high respiratory rate often occurred,which affected the effectiveness of ventilatory support.There was a significant variation in airway peak pressure among different patients.As the peak flow rate increased from 40 L/min to 55 L/min,the airway peak pressure gradually increased.During the process of reducing the peak flow rate,the pulse oxygen saturation(SpO2)of all patients remained stable without significant changes.The 40 L/min group had significantly lower peak pressures than the 50 and 55 L/min groups,whereas the 55 L/min group had significantly higher pressures than all others[cmH2O(1 cmH2O≈0.098 kPa):41.20±9.06 vs.47.90±9.04 and 53.70±7.96,all P<0.05].When comparing patients with peak flow rates of 40 L/min and 50 L/min,as well as 45 L/min and 55 L/min,the average airway peak pressure increased significantly with each 10 L/min increment in inspiratory peak flow rate.However,the SpO2 remained essentially unchanged or slightly increased as the peak flow rate decreased.There were no statistically significant differences in SpO2 among patients at different peak flow rate levels.When the peak flow rate was set at 55,50,45,and 40 L/min,the proportions of patients with airway peak pressure>40 cmH2O were 100.0%,83.3%,63.3%,and 53.3%,respectively.Among them,the proportions of patients with airway peak pressure>50 cmH2O were 66.7%,40.0%,16.6%,and 16.6%,respectively.As the peak flow rate decreased,the proportion of patients with airway peak pressure>40 cmH2O gradually decreased.If the peak flow rate was set at 45 L/min or lower,the number of patients with airway peak pressure>50 cmH2O during CPR was less than 50.0%of the total number of cases.Conclusions During mechanical ventilation in CPR,using volume-controlled ventilation(VCV)mode with a decelerating waveform,improper peak flow rate settings can easily trigger high airway pressure alarms and result in low tidal volume(VT),leading to poor synchrony between the ventilator and the patient.Compared to peak flow rates of 55 L/min and above,selecting an inspiratory peak flow rate of 40 L/min and setting the high-pressure alarm at 50 cmH2O is suitable for the mechanical ventilation needs of most patients and does not affect oxygenation levels.This is a more appropriate choice.
