Preparation，characterization and tissue distribution of polyethylene glycol-modified Curcumin solid lipid nanoparticle inhalable micropowder
- VernacularTitle:聚乙二醇修饰姜黄素固体脂质纳米粒吸入微粉的制备、表征及组织分布研究
- Author:
Nan LI
1
;
Zi WANG
1
;
Di HAO
1
;
Lingyu KONG
1
;
Xu LI
1
Author Information
1. Tianjin Institute of Medical and Pharmaceutical Sciences，Tianjin 300020，China
- Publication Type:Journal Article
- Keywords:
curcumin;
polyethylene glycol;
solid lipid nanoparticles;
inhalable micropowder;
inhalation administration;
in
- From:
China Pharmacy
2025;36(19):2387-2392
- CountryChina
- Language:Chinese
-
Abstract:
OBJECTIVE To prepare polyethylene glycol （PEG）-modified flower lactose （FL） loaded Curcumin （Cur） solid lipid nanoparticle （SLN） inhalable micropowder （referred to as “PEG-Cur-FL”）. METHODS PEG-Cur-FL was prepared by the solvent emulsification diffusion low-temperature solidification method， and its encapsulation efficiency， drug loading capacity， powder properties， aerodynamic particle size， in vitro deposition properties， and in vitro release characteristics were characterized. The mice were divided into Cur-SLN-FL （unmodified with PEG） group and PEG-Cur-FL group， with 55 mice in each group. Both groups of mice were given a single inhalation of 5 mg/kg （calculated as Cur） of the corresponding drug micropowder through an air tube. At 0.25， 0.5， 1， 2， 4， 6， 8， 12， 24， 48 and 72 hours after administration， eyeballs were removed to collect blood and tracheal， lung， liver and kidney tissues were separated. The mass concentration of Cur in mouse plasma and various tissue samples was measured， and the tissue distribution and retention of the drug were analyzed. RESULTS The encapsulation efficiency and drug loading capacity of PEG-Cur-FL were （86.2±1.8）% and （4.2±0.2）%， respectively； the bulk density and tap density were （0.24±0.01） g/cm3 and （0.30±0.01） g/cm3， respectively； the aerodynamic particle size was （2.74±0.64） μm； the in vitro effective site deposition rate （secondary drug deposition rate） was （45.07±2.79）%. Compared with Cur raw materials， Cur-SLN- FL and PEG-Cur-FL had sustained release effects under both leakage and non-leakage conditions， and PEG-Cur-FL had a smoother sustained release in artificial lung fluid， with release characteristics consistent with the Weibull model. The results of in vivo distribution showed that the drug concentration in the lung tissue of PEG-Cur-FL group was significantly lower than that of Cur- SLN-FL group during the same period after 1 hour of administration， while the drug concentration in the lung tissue at 4 to 48 hours was significantly higher than that of Cur-SLN-FL group during the same period （P＜0.05）； the plasma drug concentrations of the PEG-Cur-FL group at all time points from 0.25 to 12 hours were significantly lower than those of the Cur-SLN-FL group during the same period （P＜0.05）， and the drug concentrations in liver and kidney tissues were also lower than those of the Cur-SLN-FL group during the same period （P＜0.05）. CONCLUSIONS PEG-Cur-FL is prepared successfully； the inhalable micropowder has good inhalability and release performance； after administration through the trachea， the effective concentration of Cur in lung tissue can be increased， while reducing its plasma drug concentration and drug distribution concentration in non-target organs.
