OBJECTIVETo evaluate the trabecular bone micro-structure from different sites of spine in adolescent idiopathic scoliosis patients. The target site consisted of the bilateral facet joints from apical vertebrae and from end vertebrae.

METHODSNine AIS patients with mean age 14.9 years (range 12-17 years) and mean Cobb angle 56 degrees (ranged 48 degrees-84 degrees) were recruited into this study. Corrective surgery was indicated to these patients, and facet joint biopsies were collected during decortications for spinal fusion. Biopsy consents were obtained from patients. Bone specimens were fixed with routine histology procedures and scanned by micro computer tomography (muCT40, Scanco Medical, Switzerland). Ten pairs of facet joint were harvested from apical vertebrae and 12 pairs from end vertebrae. Three-dimensional reconstructed images with the resolution of 20 microm were achieved for histomorphometric analysis.

RESULTSThe values of BV/TV (0.268 vs. 0.354, P < 0.05), TbTh (0.20 vs. 0.24, P < 0.05), TbSP (0.66 vs. 0.56, P < 0.05) and BS/BV (12.7 vs. 10.4, P < 0.05) between convex and concave side at the apex area were significantly different. No difference was found in any structural parameters between left and right side at end area, and upper thoracic (T5, 6) and thoracolumbar (T12, L1).

CONCLUSIONDue to asymmetric compression and tension shared between convex and concave side, more bone and thicker and more profound trabecular bones are observed in the concave side than in the convex side, which seems to resist the progression of spinal curvature. This finding suggests that the provocative factors which cause the progression of the curve in certain patients may not lie in the bone component of spine.

Adolescent ; Child ; Female ; Humans ; Scoliosis ; diagnostic imaging ; pathology ; physiopathology ; Tomography, X-Ray Computed ; Zygapophyseal Joint ; pathology ; physiopathology

A geometrical model of L4-L5 lumbar segment was constructed using a three-dimensional graphics software. Four conditions of the degenerated discs, i. e. light degeneration, moderate degeneration, severe degeneration and complete excision degeneration, were simulated with loading situations using finite element method under the condition of appropriate computational accuracy. By applying a vertical load of 378.93 N on L4 vertebral plate, stress nephograms on joint isthmus under four different working conditions were obtained. The results showed that the contacted area of facet joint was influenced by the degree of intervertebral disc degeneration level, which influenced the mises stress on joint isthmus. It was proved that joint isthmus was the important pressure-proof structure of the back of lumbar vertebra, and the stress values and distribution were related to structural stiffness of the back of lumbar vertebra as well as the contact area of facet joint. The conclusion could be the theoretical reference for the analysis of spinal biomechanics and artificial disc replacement as well.
Biomechanical Phenomena ; Finite Element Analysis ; Humans ; Intervertebral Disc ; pathology ; Intervertebral Disc Degeneration ; Lumbar Vertebrae ; physiopathology ; Models, Anatomic ; Pressure ; Zygapophyseal Joint

Aged ; Bone Screws ; Bone Transplantation ; Female ; Humans ; Internal Fixators ; Joint Instability ; physiopathology ; surgery ; therapy ; Lumbar Vertebrae ; pathology ; Male ; Middle Aged ; Recovery of Function ; Treatment Outcome ; Zygapophyseal Joint ; surgery ; transplantation

PURPOSE: The authors investigated the effect of lumbar facet tropism (FT) on intervertebral disc degeneration (DD), facet joint degeneration (FJD), and segmental translational motion. MATERIALS AND METHODS: Using kinetic MRI (KMRI), lumbar FT, which was defined as a difference in symmetry of more than 7degrees between the orientations of the facet joints, was investigated in 900 functional spinal units (300 subjects) in flexion, neutral, and extension postures. Each segment at L3-L4, L4-L5, and L5-S1 was assessed based on the extent of DD (grade I-V) and FJD (grade 1-4). According to the presence of FT, they were classified into two groups; one with FT and one with facet symmetry. For each group, demographics, DD, FJD and translational segmental motion were compared. RESULTS: The incidence of FT was 34.5% at L3-L4, 35.1% at L4-L5, and 35.2% at L5-S1. Age and gender did not show any significant relationship with FT. Additionally, no correlation was observed between DD and FT. FT, however, wasfound to be associated with a higher incidence of highly degenerated facet joints at L4-L5 when compared to patients without FT (p < 0.01). Finally, FT was not observed to have any effects upon translational segmental motion. CONCLUSION: No significant correlation was observed between lumbar FT and DD or translational segmental motion. However, FT was shown to be associated significantly with the presence of high grades of FJD at L4-L5. This suggests that at active sites of segmental motion, FT may predispose to the development of facet joint degeneration.
Adolescent ; Adult ; Age Factors ; Aged ; Aged, 80 and over ; Female ; Humans ; Intervertebral Disk Displacement/*etiology/pathology ; Joint Diseases/*complications/pathology ; Lumbar Vertebrae/*pathology ; Magnetic Resonance Imaging ; Male ; Middle Aged ; Sex Factors ; Zygapophyseal Joint/*pathology/physiopathology

PURPOSE: The purpose of this study was to evaluate and compare the biomechanical behavior of the lumbar spine after posterior decompression with the spinous process osteotomy (SPiO) technique or the conventional laminectomy (CL) technique using a finite element (FE) model. MATERIALS AND METHODS: Three validated lumbar FE models (L2-5) which represented intact spine and two decompression models using SPiO and CL techniques at the L3-4 segment were developed. In each model, the ranges of motion, the maximal von Mises stress of the annulus fibrosus, and the intradiscal pressures at the index segment (L3-4) and adjacent segments (L2-3 and L4-5) under 7.5 Nm moments were analyzed. Facet contact forces were also compared among three models under the extension and torsion moments. RESULTS: Compared to the intact model, the CL and SPiO models had increased range of motion and annulus stress at both the index segment (L3-4) and the adjacent segments under flexion and torsion. However, the SPiO model demonstrated a reduced range of motion and annulus stress than the CL model. Both CL and SPiO models had an increase of facet contact force at the L3-4 segment under the torsion moment compared to that of the intact model. Under the extension moment, however, three models demonstrated a similar facet contact force even at the L3-4 model. CONCLUSION: Both decompression methods lead to postoperative segmental instability compared to the intact model. However, SPiO technique leads to better segmental stability compared to the CL technique.
Biomechanical Phenomena ; Decompression, Surgical/*methods ; *Finite Element Analysis ; Humans ; Intervertebral Disc/physiopathology/surgery ; Laminectomy/*methods ; Lumbar Vertebrae/pathology/physiopathology/*surgery ; Male ; Middle Aged ; Models, Anatomic ; Osteotomy/*methods ; Range of Motion, Articular ; Stress, Mechanical ; Zygapophyseal Joint/pathology/physiopathology/surgery