Removal of plates is a procedure commonly performed by orthopaedic surgeons and stripped screws are probably the most common problem encountered during this procedure. Stripped screws are caused by slippage between the screwdriver and the screw. Due to the inherent difficulty in removing such screws, surgeons should be knowledgeable in techniques for their removal and should be equipped with the proper instruments to expedite the procedure. There are few published articles about such techniques. This report describes a technique for removal of plates with stripped screws. The tip of a stripped screw is approached from the far cortex and then reamed with a trephine reamer in the direction of the screw until both cortices are cleared. The plate is then removed with stripped screws attached. All the removals utilizing this technique to date have been successful with no complications, and this method is safe, efficient and technically easy to learn.
orthopaedic

The objective of this study was to assess the rate of screw cut out in elderly patients treated with the dynamic hip screw and the relationship to the Tip Apex Distance (TAD). This is a retrospective radiological evaluation of 100 cases of elderly patients with intertrochanteric fracture treated with dynamic hip screw fixation surgically treated between 1998 and 2002. The incidence of screw cut out was assessed and correlation of risk of cut out with the TAD was assessed. The rate of screw cut out was 9.0% and the average length of time to screw cut out was 3.8 months (range, 1 to 6 months) postoperatively. The incidence of screw cut out increased significantly when the TAD was 20 mm or more. The screw cut out rates were 2.9%, 20.0%, 30.8%, 50% and 100% for TAD of 20-24 mm, 25-29 mm, 30-34 mm, 35-44 mm and > 45 mm respectively. Overall, a TAD of 20mm or more was associated with a statistically significant screw cut out risk in this Malaysian population.

Taylor’s spatial frame (TSF) and Ilizarov external fixators (IEF) are two circular external fixator commonly used to address complex deformity and fractures. There is currently no data available comparing the biomechanical properties of these two external fixators. This study looks into the mechanical characteristics of each system. TSF rings with 6 oblique struts, 4 tube connectors, 4 threaded rods, and 6 threaded rods were compared to a standard IEF rings with 4 threaded rods. Compression and torsional loading was performed to the frame as well as construct with Polyvinylchloride tubes. TSF rings with 4 tube connectors had the highest stiffness (3288 N/mm) while TSF rings with 6 struts was the least stiff. The situation was reversed for torsion where TSF rings with 6 oblique struts had the highest torsional stiffness (82.01 Nm/Degree) and frame Ilizarov rings with 4 threaded rods the least. Standard TSF construct of two ring with 6 oblique struts have better torsional stiffness and lower axial stiffness compared to the standard IEF.
Ilizarov Technique

Introduction: Endoscopic plantar fascia release (EPFR) is a minimally invasive surgical intervention for recalcitrant plantar fasciitis. Its efficacy has been convincing but the in vivo effect on medial longitudinal foot arch and footprint has not been studied. Our objective is to evaluate the changes of foot posture using radiographs and footprints following endoscopic plantar fascia release in recalcitrant plantar fasciitis. Materials and methods: This prospective cohort involved patients with recalcitrant plantar fasciitis who failed six months of conservative treatment. Two-portal endoscopic release of not more than 50% of plantar fascia width was performed. Footprint and standard weight-bearing anteroposterior and lateral radiographs of the foot were taken pre-operatively and at 12 months post-surgery. Arch index, normalised navicular height truncated, calcaneal inclination angle, calcano-1st metatarsal angle, talonavicular coverage angle and talus-2nd metatarsal angle were measured. Results: Sixteen patients (18 feet) were reported. Patients’ follow-up ranged from 14 to 31 months after surgery (mean±SD: 23.44±5.76). The increase of arch index, calcano-1st metatarsal angle and reduction of calcaneal inclination angle were found statistically significant (p<0.05). Two normal arch patients progressed to asymptomatic flat arch feet. Three complications were noted between three to nine months post-surgery, one with medial column and two with lateral column symptoms. Conclusion: There is evidence of reduction in medial longitudinal arch of the foot after EPFR. Although the reduction remains asymptomatic, post-operative complications related to changes in biomechanics of the foot can occur between three to nine months. Patients should be monitored at least for 12 months and longer for those who are symptomatic.