Aims: This study examined the mycosynthesis of phosphorus nanoparticles (PNPs) and its application as a fertilizer for flax plant. Methodology and results: A total of thirty eight fungal isolates were isolated and screened for their abilities to synthesize PNPs. The fungal isolate was determined and identified as Aspergillus fumigatus (NCBI GenBank accession No. MN610566-MN610567). The biosynthesized nanoparticles were characterized by particle size analyzer, UV-visible spectrophotometer, transmission electron microscope (TEM), energy-dispersive X-ray spectroscopy (EDX) and fourier transform infrared spectroscopy (FT-IR). They were found to have an average diameter of 45.1 nm, regular round shape, EDX confirms the 54.63 atom % of phosphorous. The cytotoxicity of produced nanoparticles was performed to determine the safe dose that will be applied in agricultural experiment and was found to be 12.5 μg/mL. Pot experiment was performed to determine the fertilizing impact of mycosynthesized PNPs on flax plant and to equate their influence with granular single super phosphate. Results revealed that growth parameters, phosphorus content and microbial activities in the rhizosphere of flax plants were highly significantly (p ≤ 0.05) affected by foliar application of PNPs in presence of half dose of super phosphate. The TEM-micrographs of stained ultrastructural leaves showed that the PNPs treated leaves in the presence of half dose of super phosphate had normal cell structure similar to control, while the cell structure of leaves treated with PNPs but did not receive super phosphate were adversely affected. Conclusion, significance and impact of study This study clearly indicated that the application of low cost biosynthesised PNPs could save about 50% of recommended dose of phosphorus fertilizer. This study also demonstrates that it is not preferred to use PNPs as a fertilizer alone without adding super phosphate. Hence, this investigation suggests that further studies should be established to detect the safety of this nanofertilizers.
Nanoparticles--chemistry ; Aspergillus fumigatus

Asiaticoside is a compound extracted from traditional Chinese medicine Centella asiatica, and mainly used in wound healing and scar repair in clinical, with notable efficacy. However, its poor transdermal absorption and short action time restrict its wide application. In this experiment, the reserve-phase-extrusion-lyophilization method was conducted to prepare the lyophilized asiaticoside-loaded flexible nanoliposomes (LAFL). Its characteristics including electron microscope structure, particle size, Zeta potential, entrapment rate, drug-loading rate, stability and drug release were determined with the intelligent transdermal absorption instrument. LAFL were white spheroids, with pH, particle size and zeta potential of 7. 03, 70. 14 nm and - 36. 5 mV, respectively. The average entrapment rate of the 3 batch samples were 31. 43% , and the average asiaticoside content in 1 mg lyophilized simple was 0. 134 mg. The results indicated that LAFL have good physicochemical properties and pharmaceutical characteristics, with an improved transdermal performance.
Animals ; Liposomes ; chemistry ; Nanoparticles ; chemistry ; Triterpenes ; chemistry

Aims: This study was designed to evaluate the effectiveness of the synthesised carvacrol loaded chitosan nanoparticles (CLCNPs) on the growing and pre-formed biofilms of Listeria monocytogenes isolated from slaughterhouses. Methodology and results: The swab samples were collected from knives, hocks and cutting tables representing slaughterhouses meat contact surfaces (MCS), while those samples from walls and floors represent slaughterhouses meat non-contact surfaces (MNCS). The bacteriological analysis revealed the existence of L. monocytogenes with a prevalence rate of 3.3, 10 and 6.7% for knives, hocks and cutting tables, respectively and 2.2 and 6.6% for walls and floors, respectively. The isolates L. monocytogenes were assayed for biofilm production by the crystal violet binding assay method. Among the 10 L. monocytogenes isolates, 10%, 50% and 30% of the isolates were found to be strong, moderate and weak biofilm producers, respectively. The activities of carvacrol, chitosan nanoparticles (NPs) and CLCNPs against the only strong biofilm producer strain of L. monocytogenes were tested by microtiter plate assay. The minimum inhibitory concentrations (MIC) values were 3.75 mg/mL for CAR, 5 mg/mL for chitosan NPs and 0.62 mg/mL for CLCNPs. CLCNPs inhibit the produced biofilm by 35.79, 73.37 and 77.76%, when 0.5 MIC, 1 MIC and 2 MIC were used, respectively. Furthermore, the pre-formed L. monocytogenes biofilms were significantly reduced from 1.01 (control) OD570 to 0.40 and 0.29 OD570 by applying 2 MIC and 4 MIC doses, respectively. Conclusion, significance and impact of study The data generated is promising to develop bio-green disinfectants to inhibit biofilm formation by L. monocytogenes in the food processing environment and control its adverse effects for consumers.
Chitosan--chemistry ; Listeria monocytogenes ; Nanoparticles

Based on the self-assembly process occurring in the human body all the time, self-assembled nanomaterials were designed by the researchers. The self-assembled nanomaterials have controllability, biocompatibility and functional advantages in vivo. The self-assembled nanomaterials constructed in situ under a physiological environment display various biological characteristics which can be used for imaging, therapy, and broad clinical applications. In situ self-assembled nanomaterials can boost drug function, reduce toxic and side effects, prolong imaging time and enlarge signal-to-noise ratio. By using pathological conditions to trigger specific responses in vivo, well-ordered nanoaggregates can be spontaneously formed by multiple weak bonding interactions. The assembly shows higher accumulation and longer retention in situ. Endogenous triggers for in situ assembly, such as enzymes, pH, reactive oxygen species and ligand receptor interaction, can be used to transform the materials into a variety of controllable nanostructures including nanoparticles, nanofibers and gels through bioactivated in vivo assembly (BIVA) strategies. BIVA strategies can be applied for treatment, imaging or participate in the physiological activities of cells at the lesion site. This review summarized and prospected the design of self-assembled peptide materials based on BIVA technology and their biomedical applications. The nanostructures of the self-assembly enable some beneficial biological effects, such as assembly induced retention (AIR) effect, enhanced targeting effect, multivalent bond effect, and membrane disturbance. Thus, the BIVA nanotechnology is promising for efficient drug delivery, enhancement of targeting and treatment, as well as optimization of the biological distribution of drugs.
Drug Delivery Systems ; Humans ; Nanofibers/chemistry* ; Nanoparticles ; Nanostructures/chemistry* ; Peptides

A new quercetin nanocrystals self-stabilized Pickering emulsion(QT-NSSPE) was prepared by high-pressure homogenization combined with probe ultrasonic method. The influences of oil fraction, quercetin(QT) concentration, and pH of water phase on the formation of QT-NSSPE were investigated. On this basis, the QT-NSSPE prepared under optimal conditions was evaluated in terms of microstructure, stability, and in vitro release and the droplet size and drug loading were 15.82 μm and 4.87 mg·mL~(-1), respectively. The shell structure formed by quercetin nanocrystals(QT-NC) on the emulsion droplet surface was observed under a scanning electron microscope(SEM). X-ray diffraction(XRD) showed that the crystallinity of adsorbed QT-NC decreased significantly as compared with the raw QT. There were not significant changes of QT-NSSPE properties after 30 days of storage at room temperature. The in vitro release experiment confirmed that QT-NSSPE has a higher accumulative release rate than the raw QT. All these results indicated that QT-NSSPE has a great stability and a satisfactory in vitro release behavior, which is a promising new oral delivery system for QT.
Emulsions/chemistry* ; Nanoparticles ; Particle Size ; Quercetin ; Water/chemistry*

OBJECTIVETo characterize the property of uricase loaded in uricase-catalase liposomes (BUCLPs) prepared using borate buffer.

METHODSBUCLPs were prepared using reverse-phase evaporation, and the physicochemical properties of uricase in the prepared BUCLPs were examined.

RESULTSThe optimal temperature of BUCLP and URI was 40 degrees celsius, their optimal pH values were 8.0 and 8.5, and their Michaelis-Menten constants were 14.207 µmol/L and 13.623 µmol/L, respectively. Fluorescence intensity of nanoliposome-loaded uricase-catalase that bound to FITC was higher than that of uricase-catalase binding directly with FITC; the fluorescence intensity of BUCLP was higher than that of free uricase-catalase at 280 nm.

CONCLUSIONUricase activity is enhanced after loading in uricase and catalase liposomes.

Borates ; Catalase ; Liposomes ; Nanoparticles ; chemistry ; Temperature ; Urate Oxidase ; chemistry

Chitosan has natural abundance, unique bioactivity and attractive physicochemical properties. Recent years, the synthesis of chitosan-based metal nanomaterials has attracted increasing attention. The synthesis of metal nanoparticles utilizing biomolecular or organism offers a mild medium, and thus a greater degree of control over the nanoparticles produced, along with higher reproducibility. In particular, preparation of metal nanoparticles based on biomolecular or organism has its unique facility in integrating "minimum feature sizes" into labile biological components to an excellent synergy and bifunctional effect and consequently a more broad application. Herein, we review the new development of chitosan, chitosan-based synthesis of metal nanomaterials, and their application.
Catalysis ; Chitosan ; chemistry ; Metal Nanoparticles ; chemistry ; Oxidation-Reduction

The wide use of ZnO and CuO nanoparticles in research, medicine, industry, and other fields has raised concerns about their biosafety. It is therefore unavoidable to be discharged into the sewage treatment system. Due to the unique physical and chemical properties of ZnO NPs and CuO NPs, it may be toxic to the members of the microbial community and their growth and metabolism, which in turn affects the stable operation of sewage nitrogen removal. This study summarizes the toxicity mechanism of two typical metal oxide nanoparticles (ZnO NPs and CuO NPs) to nitrogen removal microorganisms in sewage treatment systems. Furthermore, the factors affecting the cytotoxicity of metal oxide nanoparticles (MONPs) are summarized. This review aims to provide a theoretical basis and support for the future mitigating and emergent treatment of the adverse effects of nanoparticles on sewage treatment systems.
Wastewater/toxicity* ; Sewage/chemistry* ; Zinc Oxide/chemistry* ; Waste Disposal, Fluid ; Nanoparticles/chemistry* ; Metal Nanoparticles/chemistry* ; Nitrogen/metabolism* ; Water Purification

OBJECTIVETo investigate reductive dechlorination of 4-chlorophenol (4-CP) by nanoscale Fe0 under different conditions.

METHODSNanoscale Fe0 was synthesized by using reductive method. 4-CP and its intermediate products were analyzed by HPLC. Chlorine ion was quantified with DX-100 ion chromatograph. Nano-iron particles were observed under a FEI Quanta 200 FEG environmental scanning electron microscope (ESEM).

RESULTSThe size of the particles was in the range of 10-100 nm. The nano-iron particles could reduce 4-CP effectively. The initial concentration of 4-CP increased with the decrease of the relative degradation rate, whereas the reduced amount of 4-CP increased. Temperature could influence both the dechlorination rate and the reaction pathway. Moreover, the stability and durability of nanoscale Fe0 was evaluated through batch studies over extended periods of time.

CONCLUSIONThe nanoscale Fe0 can be used for sustainable treatment of contaminants in groundwater.

Chlorine ; chemistry ; Chlorophenols ; chemistry ; Iron ; chemistry ; Nanoparticles ; chemistry ; ultrastructure ; Temperature ; Water Pollutants, Chemical ; chemistry

To prepare beta-cyclodextrin (beta-CD)-deoxyrhaponti inclusion complex by the homogeneous method, and characterize the inclusion complex with ultraviolet-visible spectrum and fluorescence spectroscopy, in order to determine the inclusion rate, the ratio of subject-object, the binding constant of supra-molecular system and the thermodynamic function. The results showed that the designed method was so rational that the inclusion complex was successfully prepared. The ultraviolet-visible spectrophotometry method was adoptedto determine the inclusion rate of 38%, and the ratio of subject-object of 2: 1. The thermodynamic parameters of this inclusion complex: deltaH(0), deltaS(0) was all smaller than zero, which indicated that the main acting forces generated by the inclusion complex were hydrogen bonding and Vander Waals' force. deltaG(0) < 0 and deltaG(0) were directly proportional to the reaction temperature, which suggested that the reaction would spontaneously increase with the temperature rise. The polarization fluorescence method was used to quantitatively prove the non-covalent inclusion complex generated during the interaction between beta-CD interacting with DES. The results could also provide reference for studies on cyclodextrin supra-molecular system.
Drug Carriers ; chemistry ; Drugs, Chinese Herbal ; chemistry ; Nanoparticles ; chemistry ; Stilbenes ; chemistry ; beta-Cyclodextrins ; chemistry