No abstract available.

The purpose of this study was to evaluate the effect of pre-heating on some physical properties of composite resin. Eighty extracted, noncarious human molars were used in the present study. Four different temperatures of composite resin were used: 4degrees C, 17degrees C, 48degrees C, and 56degrees C. The 4degrees C and 17degrees C values represented the refrigerator storage temperature and room temperature respectively. For 48degrees C and 56degrees C, composite resin was heated to the temperatures. As physical properties of composite resin, shear bond strength, microhardness, and degree of conversion were measured. The data for each group were subjected to one-way ANOVAs followed by the Tukey's HSD test at 95% confidence level. Both in enamel and dentin, among composite resin of 4degrees C, 17degrees C, 48degrees C, and 56degrees C, the pre-heated composite resin up to 56degrees C revealed the highest shear bond strength, and pre-heated composite resin to the higher temperature revealed higher shear bond strength. Microhardness value was also higher with composite resin of higher temperature. Degree of conversion was also higher with composite resin of the higher temperature. In this study, it seems that pre-heating composite resin up to the higher temperature may show higher shear bond strength, higher microhardness value, and higher degree of conversion. Therefore, when using composite resin in the clinic, preheating the composite resin could be recommended to have enhanced physical properties of it.
Dental Enamel ; Dentin ; Hot Temperature ; Humans ; Molar

No abstract available.
Adhesives

Cutaneous larva migrans (CLM) is a rare serpiginous cutaneous eruption caused by accidental penetration and migration in the skin with infective larvae of nematode that normally do not have the human as their host. Although CLM has a worldwide distribution, the infection is most frequent in warmer climates. More recently, they have been increasingly imported from the tropics or subtropics by travelers. We experienced two patients who had pruritic serpiginous linear eruption in their skin for a few weeks after traveling to the endemic areas (Brazil and Thailand, respectively). After the treatment with albendazole, the skin lesions resolved with post-inflammatory hyperpigmentation. We report herein two cases of cutaneous larva migrans successfully treated with albendazole.
Adult ; Albendazole/therapeutic use ; Anthelmintics/therapeutic use ; Child, Preschool ; Female ; Human ; Larva Migrans/*drug therapy/pathology ; Male ; *Travel ; Treatment Outcome

PURPOSE: The purpose of this study was to to analyze the effect of Type 2 diabetes on tooth mortality, implant treatment and prosthetic status. MATERIALS AND METHODS: 275 Type 2 diabetics and 300 non-diabetics, aged 40-80 years were selected for analysis. The assessment of number of teeth, missing teeth, fixed prostheses (bridge pontics), implants using panoramic radiographs and dental records were carried out. RESULTS: Diabetes mellitus (DM) patients had a higher number of missing teeth (P<.05) and placed implants (P=.074), age (P<.05), male gender percentage (P=.042), smoker percentage (P<.05) than non-DM patients. In univariate analysis, the patients in older group showed significantly higher number of tooth loss rate at the first dental examination than the patients in younger group. Tooth loss rate of smokers did not show higher value than that of non-smokers. When multiple variables including DM, age, smoking, gender were considered together, diabetics and older group patients showed significantly higher tooth loss rate at the first dental examination than non-diabetics and younger group patients, respectively. Smokers and male group did not show a significant difference than non-smokers and female group, respectively. CONCLUSION: Tooth mortality and implant treatment rate were significantly higher in the DM group as indicated by univariate and multivariate logistic regression analysis. Old age groups showed significantly higher odds ratios and tooth loss rate. As diabetics showed the higher tooth loss rate than non-diabetics, diabetics also had more implant restorations than non-diabetics.
Adult ; Aged ; Dental Records ; Diabetes Mellitus ; Diabetes Mellitus, Type 2 ; Female ; Humans ; Logistic Models ; Male ; Odds Ratio ; Prostheses and Implants ; Smoke ; Smoking ; Tooth ; Tooth Loss

PURPOSE: Tunneling is a periodontal surgical procedure that creates access for patient cleansing and maintenance within the furcal area of a molar tooth with severe furcation involvement. Up to date, there are few studies about a long term clinical and radiographic stability of tunneling. The purpose of this retrospective study is to evaluate the long term prognosis after tunnel preparation of molars with through and through furcation. MATERIAL AND METHODS: 25 teeth of 23 patients aged 36 to 70 (mean age 51.7) were treated surgically with tunnel preparation. These cases were followed for 2 to 13 years (mean 6.5years) after surgery. Patients were recalled for an evaluation which was based on a questionnaire, a clinical examination, and radiographic analysis. Clinical assessment included plaque index, caries registration, probing pocket depth, bleeding on probing, tooth mobility. Baseline and over 2-year follow-up radiographs were collected and evaluated for this study. RESULT: 3 teeth(12%) had been extracted and 1 tooth(4%) hemisected. Root caries was detected in 3 teeth(12%). Thus 72% of the teeth were still caries free and in function. Clinical parameters including PI, PD, BOP, mobility showed somewhat favourable results. Radiographic furcal bone loss showed no statistically significant difference compared to interproximal crestal bone loss (3.59+/-1.69% vs 3.42+/-2.95%) when root length was used as reference. There was no correlation between root trunk length and furcal bone loss. CONCLUSION: Over 2 years after tunneling procedure, teeth showed a clinically and radiographically stable condition, despite of slight root caries and alveolar bone loss within clinically acceptable range. The tunnel procedure may be considered as a viable periodontal treatment option for molar teeth with severe furcation involvement in individuals following a regular maintenance program.
Aged ; Alveolar Bone Loss ; Follow-Up Studies ; Hemorrhage ; Humans ; Molar ; Periodontitis ; Prognosis ; Surveys and Questionnaires ; Retrospective Studies ; Root Caries ; Tooth ; Tooth Mobility

Recently, self-etching adhesive system has been introduced to simplify the clinical bonding procedures. It is less acidic compared to the phosphoric acid, thus there is doubt whether this system has enough bond strength to enamel. The purpose of this study was to investigate the influence of additional etching on the adhesion of resin composite to enamel. Ninety extracted bovine permanent anterior teeth were used. The labial surfaces of the crown were ground with 600-grit abrasive paper under wet condition. The teeth were randomly divided into six groups of 15 teeth each. Clearfil SE Bond(R), Adper(TM) Prompt L-Pop and Tyrian SPE(TM) were used as self-etching primers. Each self-etching primers were applied in both enamel specimens with and without additional etching. For additional etching groups, enamel surface was pretreated with 32% phosphoric acid (UNI-ETCH, Bisco, Inc., Schaumburg, IL, USA). Hybrid resin composite Clearfil AP-X, (Kuraray Co., Ltd., Osaka, Japan) was packed into the mold and light-cured for 40 seconds. Twenty-four hours after storage, the specimens were tested in shear bond strength. The data for each group were subjected to independent t - test at p < 0.01 to make comparisons among the groups. In Clearfil SE Bond(R), shear bond strength of additional etching group was higher than no additional etching group (p < 0.01). In Adper(TM) Prompt L-Pop and Tyrian SPE, there were no significant difference between additional etching and non-etching groups (p > 0.01). In conclusion, self-etching adhesive system with weak acid seems to have higher bond strength to enamel with additional etching, while self-etching adhesive system with strong acid seems not.
Adhesives* ; Crowns ; Dental Enamel* ; Fungi ; Tooth

No abstract available.
Biopsy, Needle* ; Needles*

The purpose of this study was to investigate the function of calcitonin gene-related peptide (CGRP) in regulatory mechanism of pulpal microcirculation with the aim of elucidating neurogenic inflammation. Experiments were performed on twelve cats under general anesthesia. CGRP was administered through the femoral vein to see the systemic influence and through the external carotid artery to see the local effect. Sympathetic nerve to the dental pulp was stimulated electrically and pulpal blood flow (PBF) was measured with a laser Doppler flowmeter on the canine teeth to the drug administration. The paired variables of control and experimental data were compared by paired t-test and differences with p < 0.05 were considered statistically significant. Systemic administration of CGRP (0.3 microg/kg) exerted decreases in systemic blood pressure and caused changes in PBF with an initial increase followed by decrease and a more marked second increase and decrease. Close intra-arterial (i.a.) injection of CGRP (0.03 microg/kg) resulted in slight PBF increase. The effect of CGRP resulted in no significant increase in PBF in the presence of CGRP8-37. The electrical stimulation of the sympathetic nerve alone resulted in PBF decreases. The i.a. administration of CGRP following the electrical stimulation of the sympathetic nerve compensated the decreased PBF. Therefore, CGRP effectively blocked the sympathetic nerve stimulation-induced PBF decrease. Results of the present study have provided evidences that even though the local vasodilatory function of CGRP are weak, CGRP is effectively involved in blocking the vasoconstriction caused by sympathetic nerve stimulation in the feline dental pulp.
Anesthesia, General ; Animals ; Blood Pressure ; Calcitonin Gene-Related Peptide* ; Calcitonin* ; Carotid Artery, External ; Cats ; Cuspid ; Dental Pulp ; Electric Stimulation ; Femoral Vein ; Flowmeters ; Microcirculation* ; Neurogenic Inflammation ; Vasoconstriction

OBJECTIVES: The purpose of this study was to evaluate the proximity of the mandibular molar apex to the buccal bone surface in order to provide anatomic information for apical surgery. MATERIALS AND METHODS: Cone-beam computed tomography (CBCT) images of 127 mandibular first molars and 153 mandibular second molars were analyzed from 160 patients' records. The distance was measured from the buccal bone surface to the root apex and the apical 3.0 mm on the cross-sectional view of CBCT. RESULTS: The second molar apex and apical 3 mm were located significantly deeper relative to the buccal bone surface compared with the first molar (p < 0.01). For the mandibular second molars, the distance from the buccal bone surface to the root apex was significantly shorter in patients over 70 years of age (p < 0.05). Furthermore, this distance was significantly shorter when the first molar was missing compared to nonmissing cases (p < 0.05). For the mandibular first molars, the distance to the distal root apex of one distal-rooted tooth was significantly greater than the distance to the disto-buccal root apex (p < 0.01). In mandibular second molar, the distance to the apex of C-shaped roots was significantly greater than the distance to the mesial root apex of non-C-shaped roots (p < 0.01). CONCLUSIONS: For apical surgery in mandibular molars, the distance from the buccal bone surface to the apex and apical 3 mm is significantly affected by the location, patient age, an adjacent missing anterior tooth, and root configuration.
Apicoectomy ; Cone-Beam Computed Tomography ; Humans ; Molar* ; Tooth