A 19-years-old girl was referred for lung transplant due to end stage lung disease secondary to idiopathic bilateral bronchiectasis. Her routine pre lung transplant evaluation showed normal esophageal high-resolution manometry (HRM) and 24-hours impedance pH monitoring. Four weeks after the bilateral sequential lung transplantation (LTx), she developed dysphagia, chest pain and regurgitation, complicated by aspiration pneumonia. Repeated HRM showed Jackhammer esophagus, delayed gastric emptying and abnormal 24-hour pH impedance monitoring consistent with the diagnosis of gastroesophageal reflux disease. Twelve weeks after LTx, she was symptom free, HRM and 24-hour impedance pH monitoring returned to normal. To the best of our knowledge, this rare transient esophageal hypercontractility episode occurred after LTx and recovered without any specific treatment was never reported in literature. The etiopathogenesis of Jackhammer esophagus in general and LTx induced dysmotility in particular is discussed and reviewed.
Bronchiectasis ; Chest Pain ; Deglutition Disorders ; Electric Impedance ; Esophagus ; Gastric Emptying ; Gastroesophageal Reflux ; Hydrogen-Ion Concentration ; Lung ; Lung Diseases ; Lung Transplantation ; Manometry ; Pneumonia, Aspiration ; Transplants

BACKGROUND/AIMS: Approximately one-third of non-erosive reflux disease (NERD) patients are refractory to proton pump inhibitors (PPI) and face a therapeutic challenge. Therefore, it is important to differentiate between pathological and non-pathological reflux utilizing multichannel intraluminal impedance-pH (MII-pH) to analyze symptom-reflux association and diagnose true NERD versus hyper-sensitive esophagus (HE) and functional heartburn (FH). Herein, we evaluated the diagnostic yield of MII-pH in refractory NERD and sub-classified it based on quantity and quality of acid/non-acid reflux and reflux-symptom association. METHODS: Sixty symptomatic NERD patients on twice daily PPI for > 2 months were prospectively evaluated by MII-pH. Distal and proximal refluxes, bolus exposure time (BET), esophageal acid exposure time, symptom index (SI) and symptom association probability (SAP) were measured. RESULTS: Thirty-two (53%) patients had BET > 1.4% (MII-pH positive-true NERD), while 28 (47%) had BET < 1.4% (MII-pH negative NERD) where SI and SAP were negative in 15/60 (25%; categorized as FH) and SI or SAP were positive in 13/60 (22%; identified as HE). Thirty-eight (63%) patients reported significant SI or SAP parameters where > 80% of symptoms were associated with non-acid reflux. The number of distal refluxes in true NERD versus FH or HE were significantly different, but not between FH and HE. CONCLUSIONS: Approximately 60% of refractory PPI NERD patients had positive reflux-symptom association, primarily due to non-acid reflux. Nearly half of NERD patients on PPI had normal MII-pH monitoring, sub-divided further into FH and HE equally.
Esophagus ; Heartburn ; Humans ; Prospective Studies ; Proton Pump Inhibitors

PURPOSE: This study aimed to evaluate the effect of incorporating zirconium oxide nanoparticles (nano-ZrO 2 ) in polymethylmethacrylate (PMMA) denture base resin on flexural properties at different material thicknesses. MATERIALS AND METHODS: Heat polymerized acrylic resin specimens (N = 120) were fabricated and divided into 4 groups according to denture base thickness (2.5 mm, 2.0 mm, 1.5 mm, 1.0 mm). Each group was subdivided into 3 subgroups (n = 10) according to nano-ZrO2 concentration (0%, 2.5%, and 5%). Flexural strength and elastic modulus were evaluated using a three-point bending test. One-way ANOVA, Tukey’s post hoc, and two-way ANOVA were used for data analysis (α = .05). Scanning electron microscopy (SEM) was used for fracture surface analysis and nanoparticles distributions. RESULTS: Groups with 0% nano-ZrO2 showed no significant difference in the flexural strength as thickness decreased (P = .153). The addition of nano-zirconia significantly increased the flexural strength (P < .001). The highest value was with 5% nano-ZrO2 and 2 mm-thickness (125.4± 18.3 MPa), followed by 5% nano-ZrO2 and 1.5 mm-thickness (110.3 ± 8.5 MPa). Moreover, the effect of various concentration levels on elastic modulus was statistically significant for 2 mm thickness (P = .001), but the combined effect of thickness and concentration on elastic modulus was insignificant (P = .10). CONCLUSION Reinforcement of denture base material with nano-ZrO2 significantly increased flexural strength and modulus of elasticity. Reducing material thickness did not decrease flexural strength when nano-ZrO2 was incorporated. In clinical practice, when low thickness of denture base material is indicated, PMMAano-ZrO2 could be used with minimum acceptable thickness of 1.5 mm.

PURPOSE: This study aimed to evaluate the effect of incorporating zirconium oxide nanoparticles (nano-ZrO 2 ) in polymethylmethacrylate (PMMA) denture base resin on flexural properties at different material thicknesses. MATERIALS AND METHODS: Heat polymerized acrylic resin specimens (N = 120) were fabricated and divided into 4 groups according to denture base thickness (2.5 mm, 2.0 mm, 1.5 mm, 1.0 mm). Each group was subdivided into 3 subgroups (n = 10) according to nano-ZrO2 concentration (0%, 2.5%, and 5%). Flexural strength and elastic modulus were evaluated using a three-point bending test. One-way ANOVA, Tukey’s post hoc, and two-way ANOVA were used for data analysis (α = .05). Scanning electron microscopy (SEM) was used for fracture surface analysis and nanoparticles distributions. RESULTS: Groups with 0% nano-ZrO2 showed no significant difference in the flexural strength as thickness decreased (P = .153). The addition of nano-zirconia significantly increased the flexural strength (P < .001). The highest value was with 5% nano-ZrO2 and 2 mm-thickness (125.4± 18.3 MPa), followed by 5% nano-ZrO2 and 1.5 mm-thickness (110.3 ± 8.5 MPa). Moreover, the effect of various concentration levels on elastic modulus was statistically significant for 2 mm thickness (P = .001), but the combined effect of thickness and concentration on elastic modulus was insignificant (P = .10). CONCLUSION Reinforcement of denture base material with nano-ZrO2 significantly increased flexural strength and modulus of elasticity. Reducing material thickness did not decrease flexural strength when nano-ZrO2 was incorporated. In clinical practice, when low thickness of denture base material is indicated, PMMAano-ZrO2 could be used with minimum acceptable thickness of 1.5 mm.