Summary of Event: A transjugular intrahepatic portosystemic shunt (TIPS) stent (Viatorr) was misplaced into main portal vein and superior mesenteric vein. This misplaced covered stent was then successfully retrieved using the rigid endobronchial forceps. Teaching Point: Before release the covered portion of the TIPS stent (Viatorr), it is necessary to confirm the position of uncovered portion in portal vein and covered portion in parenchymal tract. The endobronchial forceps technique is a safe and efficient method for retrieving a misplaced TIPS stent.
Device Removal ; Mesenteric Veins ; Methods ; Portal Vein ; Portasystemic Shunt, Surgical* ; Portasystemic Shunt, Transjugular Intrahepatic ; Stents* ; Surgical Instruments*

OBJECTIVE: Although a transjugular intrahepatic portosystemic shunt (TIPS) is commonly placed to manage isolated gastric varices, balloon-occluded retrograde transvenous obliteration (BRTO) has also been used. We compare the long-term outcomes from these procedures based on our institutional experience. MATERIALS AND METHODS: We conducted a retrospective review of patients with isolated gastric varices who underwent either TIPS with a covered stent or BRTO between January 2000 and July 2013. We identified 52 consecutive patients, 27 who had received TIPS with a covered stent and 25 who had received BRTO. We compared procedural complications, re-bleeding rates, and clinical outcomes between the two groups. RESULTS: There were no significant differences in procedural complications between patients who underwent TIPS (7%) and those who underwent BRTO (12%) (p = 0.57). There were also no statistically significant differences in re-bleeding rates from gastric varices between the two groups (TIPS, 7% [2/27]; BRTO, 8% [2/25]; p = 0.94) or in developing new ascites following either procedure (TIPS, 4%; BRTO, 4%; p = 0.96); significantly more patients who underwent TIPS developed hepatic encephalopathy (22%) than did those who underwent BRTO (0%, p = 0.01). There was no statistically significant difference in mean survival between the two groups (TIPS, 30 months; BRTO, 24 months; p = 0.16); median survival for the patients who received TIPS was 16.6 months, and for those who underwent BRTO, it was 26.6 months. CONCLUSION: BRTO is an effective method of treating isolated gastric varices with similar outcomes and complication rates to those of TIPS with a covered stent but with a lower rate of hepatic encephalopathy.
Ascites ; Esophageal and Gastric Varices* ; Hepatic Encephalopathy ; Humans ; Hypertension, Portal ; Methods ; Portasystemic Shunt, Surgical* ; Retrospective Studies ; Stents*

Transjugular intrahepatic portosystemic shunts (TIPS) are widely used in the management of bleeding gastric varices (GV). More recently, several studies have demonstrated balloon-occluded retrograde transvenous obliteration (BRTO) as an effective treatment method for bleeding isolated GV, especially in patients with contraindications for a TIPS placement. Both TIPS and BRTO can effectively treat bleeding GV with low rebleeding rates. Careful patient selection for TIPS and BRTO procedures is required to best treat the patient's individual clinical situation.
Balloon Occlusion ; Embolization, Therapeutic ; Esophageal and Gastric Varices* ; Hemorrhage ; Humans ; Methods ; Patient Selection ; Portasystemic Shunt, Surgical* ; Portasystemic Shunt, Transjugular Intrahepatic

OBJECTIVE: The purpose of this study was to assess the long-term stability of rapid palatal expansion (RPE) followed by full fixed edgewise appliances. METHODS: This study included 67 patients treated using Haas-type RPE and non-extraction edgewise appliance therapy at a single orthodontic practice. Serial dental casts were obtained at three different time points: pretreatment (T1), after expansion and fixed appliance therapy (T2), and at long-term recall (T3). The mean duration of the T1–T2 and T2–T3 periods was 4.8 ± 3.5 years and 11.0 ± 5.4 years, respectively. The dental casts were digitized, and the computed measurements were compared with untreated reference data. RESULTS: The majority of treatment-related increases in the maxillary and mandibular arch measurements were statistically significant (p < 0.05) and greater than expected for the untreated controls. Although many measurements decreased postretention (T2–T3), the net gains persisted for all of the measurements evaluated. CONCLUSIONS The use of RPE therapy followed by full fixed edgewise appliances is an effective method for increasing maxillary and mandibular arch width dimensions in growing patients.

Objective: The purpose of this study was to evaluate and compare the dimensional accuracy between thermoformed and direct-printed aligners. Methods: Three types of aligners were manufactured from the same reference standard tessellation language (STL) file: thermoformed aligners were manufactured using Zendura FLX TM (n = 12) and Essix ACETM (n = 12), and direct-printed aligners were printed using Tera HarzTM TC-85DAP 3D Printer UV Resin (n = 12). The teeth were not manipulated with any tooth-moving software in this study. The samples were sprayed with an opaque scanning spray, scanned, imported to Geomagic® Control XTM metrology software, and superimposed on the reference STL file by using the best-fit alignment algorithm. Distances between the aligner meshes and the reference STL file were measured at nine anatomical landmarks. Results: Mean absolute discrepancies in the Zendura FLXTM aligners ranged from 0.076 ± 0.057 mm to 0.260 ± 0.089 mm and those in the Essix ACETM aligners ranged from 0.188 ± 0.271 mm to 0.457 ± 0.350 mm, while in the direct-printed aligners, they ranged from 0.079 ± 0.054 mm to 0.224 ± 0.041 mm. Root mean square values, representing the overall trueness, ranged from 0.209 ± 0.094 mm for Essix ACETM , 0.188 ± 0.074 mm for Zendura FLXTM , and 0.140 ± 0.020 mm for the direct-printed aligners. Conclusions This study showed greater trueness and precision of direct-printed aligners than thermoformed aligners.

Purpose: This study aims to investigate the force delivery profile of thermoformed aligners (TFA) compared with direct-printed aligners (DPA) and to explore the effect of different activation amounts on forces and moments of respective groups. A secondary objective is to observe the amount of stress relaxation that occurs over the 7~14 days when aligners are maintained in a simulated intraoral environment. Materials and Methods: An in vitro setup was created to quantify forces and moments. It consisted of a three dimensional-printed base plate and segmented maxillary teeth, placed in a semi-enclosed chamber to maintain a temperature of 37°C. Ninety clear aligners were divided into nine groups of ten aligners each based on material types (Zendura, ATMOS, TC-85) and activation amounts. Aligners were created with 0.00, 0.25- and 0.50-mm activations for lingual bodily movement of the upper left central incisor and kept on models in the “stressed” position in a 37°C water bath. Three force components acting on the upper left lateral incisor, upper left central incisor, and upper right central incisor were measured for each time point, beginning from the initial baseline measurement, 8 hours, 16 hours, 24 hours, 2 days, 3 days, 4 days, 5 days, 6 days, 7 days, and lastly, 14 days.Result: TC-85 aligners in every activation group showed less force on teeth than Zendura and ATMOS. Significant force levels from 0.0 mm activation were present and stayed consistent over the course of 14 days. Comparisons made for baseline measurements to 7-days and 14-days showed statistically significant change from the baseline force level. Conclusion TC-85 aligners demonstrated lower, more consistent forces with fewer side effects. Aligners can generate forces even when no activation is programmed. No major decreases in force levels over time were observed; the intra-oral clinical simulated environment and length of observation time could contribute to this.

Group A Streptococcus (GAS) infections cause substantial worldwide morbidity and mortality, mostly associated with suppurative complications such as pharyngitis, impetigo, and non-suppurative immune syndromes such as acute rheumatic fever, rheumatic heart disease, and acute post-streptococcal glomerulonephritis. Deaths occur mostly in children, adolescents, and young adults in particular pregnant women in low- and middle-income countries. GAS strains are highly variable, and a GAS vaccine would need to overcome the issue of multiple strains. Several approaches have been used multivalent vaccines using N-terminal polypeptides of different M protein; conserved M protein vaccines with antigens from the conserved C-repeat portion of the M protein; incorporation selected T- and B-cell epitopes from the C-repeat region in a synthetic polypeptide or shorter single minimal B-cell epitopes from this same region; and non-M protein approaches utilizing highly conserved motives of streptococcal C5a peptidase, GAS carbohydrate and streptococcal fibronectin-binding proteins. A GAS vaccine represents urgent need for this neglected disease and should therefore deserve the greatest attention of international organizations, donors, and vaccine manufacturers.
Adolescent ; Child ; Epitopes, B-Lymphocyte ; Female ; Glomerulonephritis ; Humans ; Impetigo ; Mortality ; Neglected Diseases ; Peptides ; Pharyngitis ; Pregnant Women ; Public Health* ; Rheumatic Fever ; Rheumatic Heart Disease ; Streptococcus* ; Tissue Donors ; Vaccines ; Young Adult

Rigid cervical deformities are difficult problems to treat. The goals of surgical treatment include deformity correction, achieving a rigid fusion, and performing a thorough neural decompression. In stiff and ankylosed cervical spines, osteotomies are required to restore sagittal and coronal balance. In this chapter, we describe the clinical and radiographic workup for patients with cervical deformities, and delineate the various factors that must be considered when planning surgical treatment. We also describe in detail the various types of cervical osteotomies, along with their surgical technique, advantages, and potential complications.
Congenital Abnormalities ; Decompression ; Humans ; Kyphosis ; Osteotomy* ; Spinal Cord Diseases ; Spine*

The lymphatic vasculature has been regarded as a passive conduit for interstitial fluid and responsible for the absorption of macromolecules such as proteins or lipids and transport of nutrients from food. However, emerging data show that the lymphatic vasculature system plays an important role in immune modulation. One of its major roles is to coordinate antigen transport and immune-cell trafficking from peripheral tissues to secondary lymphoid organs, lymph nodes. This perspective was recently updated with the notion that the interaction between lymphatic endothelial cells and leukocytes controls the immune-cell migration and immune responses by regulating lymphatic flow and various secreted molecules such as chemokines and cytokines. In this review, we introduce the lymphatic vasculature networks and genetic transgenic models for research on the lymphatic vasculature system. Next, we discuss the contribution of lymphatic endothelial cells to the control of immune-cell trafficking and to maintenance of peripheral tolerance. Finally, the physiological roles and features of the lymphatic vasculature system are further discussed regarding inflammation-induced lymphangiogenesis in a pathological condition, especially in mucosal tissues such as the gastrointestinal tract and respiratory tract.
Absorption ; Chemokines ; Cytokines ; Endothelial Cells ; Endothelium ; Extracellular Fluid ; Gastrointestinal Tract ; Leukocytes ; Lymph Nodes ; Lymphangiogenesis ; Mucous Membrane ; Peripheral Tolerance ; Respiratory System

American population consists of people of various race and ethnic group. Palm prints are different from each individual, ethnic group and race. The aim of this study is to investigate influencing anthropometric values to atd angles formed by triradii of palm prints in European American and develop a regression equation that can predict atd angle. This study was done on 208 European American (males: 102 individuals, females: 106 individuals). Data were collected by measuring atd angles using a protractor, distance from triradii a to d, length from triradius t to the distal wrist crease (DWC), palm breadth at metacarpals and palm length perpendicular using digital callipers. The data were analyzed by descriptive statistics, the frequency, independent sample t-test, paired t-test, Pearson correlation analysis, stepwise regression using SPSS win 18.0. This study showed that atd angles of males (38.6degrees) are significantly smaller than those of females (40.4degrees). Influencing anthropometric values to atd angles in males were distance from triradii a to d, the ratio of the length from triradius t to the DWC to palm length, palm length. Influencing anthropometric values to atd angles in females were the ratio of the length from triradius t to the DWC to palm length, the ratio of the distance from triradii a to d to palm breadth, and the ratio of palm breadth to palm length. In addition to, the regression equation predicted atd angle of males was 26.150+(0.741xdistance from triradii a to d)+(52.856xthe ratio of the length from triradius t to the DWC to palm length)-(0.332xpalm length), on the other hand, that of females was -42.935+(51.657xthe ratio of the length from triradius t to the DWC to palm length)+(63.314xthe ratio of the distance from triradii a to d to palm breadth)+(42.764xthe ratio of palm breadth to palm length). The results of this study suggest that there were differences in influencing anthropometric values to atd angles between males and females in European American. Especially, the ratio of the length from triradius t to DWC to palm length was a very significantly influencing anthropometric value to atd angles to all of males and females.
Continental Population Groups ; Ethnic Groups ; Female ; Hand ; Humans ; Male ; Metacarpal Bones ; Wrist