Cuproptosis is a type of independent cell death form, that differs from apoptosis, necroptosis and ferroptosis. It is mediated by Copper (Cu), and mainly affects the lipoylation of proteases in the mitochondrial tricarboxylic acid (TCA) cycle and exhibits cytotoxicity through oligomerization; however, its specific mechanism, signal transduction process and regulation mode are still not clear. Mitochondria affect the sensitivity of cells to copper toxicity and play a central role in the occurrence and development of copper-related death. In recent years, though hematological tumors have achieved better remission through targeted therapy and immunotherapy, they are associated with high recurrence rates and poor prognoses. It is therefore imperative to find better prognostic indicators and new treatment ideas. This paper summarizes the interaction between Cu and mitochondria in the development of tumors and provides ideas for further exploration of the mechanism of copper death and coping with hematological tumors.

Objective To analyze the influence of shaping on the bending strength of bone plates and the influence of different locking nail distributions on plate force to provide biomechanical references for shaping plates and selecting different locking nail distributions.Methods Finite element simulation analysis of the four-point bending strength of a plate was performed according to the YY/T 0342-2020 standard.Theoretical analysis and finite element simulation method were used to analyze the force on prosthesis models with different lock-nail distributions.Results At 30° bending,the 3.7 mm-thick plate had 28%higher equivalent plastic strain than the 2.7 mm-thick plate.The 3.7 and 2.7 mm-thick plates had ultimate bending angles of 55° and 67°,respectively.The crease had little impact on the plate stress.The four-point bending strength and equivalent bending stiffness of the unshapeed structure were 2.64 N·m and 1.12 N·m2,respectively.The four-point bending strength and equivalent bending stiffness with the crease were 2.63 N·m and 1.10 N·m2,respectively.After forward and backward bending,the four-point bending strength of the plate decreased from 2.64 to 2.45 N·m by approximately 7.72%,and the equivalent bending stiffness decreased from 1.12 to 0.98 N·m2 by approximately 12%.The impact was obvious.After implantation of tamponade screws,the four-point bending strength of the single-hole plate improved significantly from 2.64 to 3.15 N·m,by approximately 19.32%and the equivalent bending stiffness increased from 1.12 to 1.14 N·m2,by approximately 2.1%.At least two locking holes were reserved on both sides of the fracture line.Not inserting the locking screw reduced the stress by approximately 50%compared with the full insertion of the locking screw.During 15-week postoperative walking without bone callus formation,the material stress of TC4 reached 852.7 MPa and yielding occurred.Conclusions In a clinical scenario where larger shaping is required,it is not suitable for plates with larger thicknesses and plate fractures are more likely to occur after large-thickness shaping.This can guide the clinical selection of plates with appropriate thickness based on the shaping angle,and tamponade screws can be implanted in extreme cases.Fixing locking screws clinically is recommended;however,a method of fixing the locking screws with full screws is not recommended.The biomechanical effect is best when two locking holes at both ends of the fracture line are maintained without fixing the locking screws.

OBJECTIVES: To evaluate the immunogenicity and osteogenic ability of animal-derived bone graft material decellularized with supercritical carbon dioxide. METHODS: Porcine femurs were randomly divided into two groups after preliminary treatment, and decellularized with conventional method (control group) or supercritical carbon dioxide (experimental group). Allogenic demineralized bone matrix was used as positive control. Clearance rate of galactose-α-1, 3-galactose (α-Gal) antigen was determined by enzyme-linked immunosorbent assay and residual DNA was detected by a fluorescence method. Nine SPF-grade male athymic nude mice of 6 weeks old were randomly divided into experimental, control and positive control groups. Samples were implanted over biceps femoris muscle of athymic nude mice. The explants were collected 4 weeks post implantation. Hematoxylin and eosin (HE) staining and immunohistochemistry were applied to determine the osteogenic ability and bone tissue-associated protein expressions of the implants. RESULTS: The clearance rates of α-Gal antigen in the experimental group and the control group were (99.09±0.26)% and (30.18±2.02)%, respectively (t=58.67, P<0.01). The residual DNA of the experimental, control and positive control groups were (13.49±0.07), (15.20±0.21) and (14.70±0.17) ng/mg. The residual DNA in the experimental group was significantly lower than that in the control group (t=－13.41, P<0.01) and positive control group (t=－11.30, P<0.01). HE staining results showed that multiple bone formation centers with active osteogenesis and rich bone marrow were observed in experimental group 4 weeks after implantation, but only a small number of bone formation centers were observed in the control and positive control groups, with no obvious osteoblasts present. Immunohistochemistry results indicated that the expressions of alkaline phosphatase, Runt-related transcription factor 2, collagen typeⅠand osteocalcin in the experimental group showed an increasing trend compared with those in the control and positive control groups. CONCLUSIONS Compared with clinically used allogenic demineralized bone matrix and bone graft material decellularized with conventional method, bone graft material decellularized with supercritical carbon dioxide exhibits lower immunogenicity and better osteogenic ability.
Animals ; Mice ; Swine ; Male ; Bone Transplantation/methods* ; Mice, Nude ; Carbon Dioxide ; Osteogenesis/drug effects* ; Femur ; Bone Substitutes ; Tissue Engineering/methods*

【Objective】 To explore the key genes and potential therapeutic drugs for ER-negative breast cancer by bioinformatics. 【Methods】 The gene expression profile of breast cancer (GSE22219) was downloaded from the Gene Expression Omnibus (GEO). Principal components analysis (PCA) of GSE22219, and analyses of differentially expressed genes (DEGs) between the ER-negative and ER-positive subjects and Gene Ontology (GO) analysis were performed by R software. We analyzed The Kyoto Encyclopedia of Genes and Genomes (KEGG) pathway and Protein-Protein Interaction (PPI) network using STRING. The hub genes were identified using Cytoscape and analyzed using online programs. Drugbank analysis was used to find small molecular compounds as potential therapeutic agents to target the DEGs. 【Results】 We detect 69 DEGs and 8 hub genes between the ER-negative and ER-positive subjects. We found the most significant KEGG pathway of DEGs was aldosterone-regulated sodium reabsorption. The Gene Ontology (GO) analysis indicated that the most significantly enriched in prostate gland morphogenesis. Totally 21 small molecular compounds were identified as potential therapeutic agents for ER-negative breast cancer. 【Conclusion】 The bioinformatical analysis combined with drug database can help us find potential therapeutic agents to treat diseases. This method is a new paradigm which can guide future research on drugs.

The aim of this study was to investigate the role of S100 calcium binding protein A16 (S100A16) in lipid metabolism in hepatocytes and its possible biological mechanism. HepG2 cells (human hepatoma cell line) were cultured with fatty acid to establish fatty acid culture model. The control model was cultured without fatty acid. Each model was divided into three groups and transfected with S100a16 over-expression, shRNA and vector plasmids, respectively. The concentration of triglyceride (TG) in the cells was measured by kit, and the lipid droplets was observed by oil red O staining. Immunoprecipitation and mass spectrometry were used to find the interesting proteins interacting with S100A16, and the interaction was verified by immunoprecipitation. The further mechanism was studied by Western blot and qRT-PCR. The results showed that the intracellular lipid droplet and TG concentrations in the fatty acid culture model were significantly higher than those in the control model. The accumulation of intracellular fat in the S100a16 over-expression group was significantly higher than that in the vector plasmid transfection group. There was an interaction between heat shock protein A5 (HSPA5) and S100A16. Over-expression of S100A16 up-regulated protein expression levels of HSPA5, inositol-requiring enzyme 1α (IRE1α) and pIREα1, which belong to endoplasmic reticulum stress HSPA5/IRE1α-XBP1 pathway. Meanwhile, over-expression of S100A16 up-regulated the mRNA expression levels of adipose synthesis-related gene Srebp1c, Acc and Fas. In the S100a16 shRNA plasmid transfection group, the above-mentioned protein and mRNA levels were lower than those of vector plasmid transfection group. These results suggest that S100A16 may promote lipid synthesis in HepG2 cells through endoplasmic reticulum stress HSPA5/IRE1α-XBP1 pathway.
Endoplasmic Reticulum Stress ; Endoribonucleases ; physiology ; Heat-Shock Proteins ; physiology ; Hep G2 Cells ; Humans ; Lipid Metabolism ; Protein-Serine-Threonine Kinases ; physiology ; S100 Proteins ; physiology ; Triglycerides ; biosynthesis ; X-Box Binding Protein 1 ; physiology