Objective To establish an inductively coupled plasma‐mass spectrometry (ICP‐MS) method for analysis of elements in peripheral blood of children .Methods A total of 474 healthy children in Hunan area were enrolled in this study ,and six ele‐ments ,including Ca ,Mg ,Fe ,Cu ,Zn and Pb ,in peripheral blood specimens were detected by using ICP‐MS method .Results The levels of elements ,including Ca ,Mg ,Fe ,Cu ,Zn and Pb ,in peripheral blood of healthy children showed skewed distributions ,and no significant differences were found in levels of these elements between male and female children(P>0 .05) .The reference intervals of Ca ,Mg ,Fe ,Cu ,Zn and Pb in peripheral blood of healthy children in this area were 57 .30 -81 .40 mg/L ,30 .40 -44 .80 mg/L , 361 .20-531 .40 mg/L ,848 .10-1 469 .20 μg/L ,2 .68 -6 .54 mg/L and 0 .00 -100 .00 μg/L respectively .Conclusion The ICP‐MS method for simultaneously detecting Ca ,Mg ,Fe ,Cu ,Zn and Pb in peripheral blood of children and reference interval of each ele‐ment are successfully established .

ObjectiveTo investigate the effect of N-ras oncogene expression in acute myelogenous leukemia(AML).Methods N-ras oncongene in 10 cases of AML were determined using reverse transcriptase-polymerase chain reaction(RT-PCR).Results 3/10 cases were the positive expression,the positive rates were 30%;2/3 patients were treated to complete remmision(CR).Their N-ras oncogene change negative,1/3 patients was no remmision(NR),his N-ras oncogene change negative,1/3 patient was no remmision(NR),his N-ras oncogene keeps positive and dead after 4 months.Conclusions Determination of the N-ras oncogene expression in AML has worthy for diagnose and prognosis.

Gene expression exhibits temporal and spatial patterns to response environmental changes and growth cycle. Gene expression is under strict control at different levels among which control at transcription level is the predominant mode, especially in prokaryotes. In this review, we summarized the new developments of methods used in transcriptional studies, including modifications and improvements of the classic methods, such as gel-shift assay, DNA foot printing, and in vivo reporter system. In addition, we introduced examples to apply new methods, such as surface plasmon resonance (SPR) and isothermal titration calorimetry (ITC) to characterize protein-DNA, ligand-protein, and ligand-protein-DNA interactions. The collection of these methods and their application could guide and accelerate relevant studies.
Calorimetry ; DNA Footprinting ; Gene Expression ; Ligands ; Proteins ; Surface Plasmon Resonance ; Transcription, Genetic

BACKGROUND:During the restoration of residual molar crown, a little part of tooth is still remained commonly. After the restoration, with various forces, stress distribution affects directly the results after restoration. Finite element method is gradually applied in stress analysis on artificial tooth.OBJECTIVE: To establish the three-dimensional (3-D) finite element model of post-inlay restoration of the first residual mandibular molar crown so as to provide experimental data for improving model establishment of complicated teeth and analysis on the property of stress distribution of restoring methods.DESIGN: Repeated observation and measurement were given.SETTING: Department of Stomatology and Department of Radiology of First Hospital affiliated to Sun Yat-sen University;Department of Solid Mechanics,College of Traffics and Communications, South China University of Technology; Department of Restoration of Guanghua College of Stomatology.MATERIALS: The experiment was performed in Department of Solid Mechanics, College of Traffics and Communications of South China University of Technology from November 2003 to December 2004. Six first mandibular molars on the right side with normal morphology in vitro were collected, and Toshiba Xpress/SX spiral CT machine, image photo synthesis software and finite element analysis software ANSYS were applied in the experiment.METHODS: 1 of the 6 first mandibular molars on the right side with normal morphology in vitro was selected for pulpectomy, which was the best in density and near to clinical requirement in morphology. With pulpectomy, the prosthesis of braking-lock post-inlay restoration was prepared. Spiral CT-cross scanning was performed in premolar crown before the restoration, the residual crown with post-inlay in main root canal after restoration and the residual crown with braking-lock second post-inlay restoration. With image photosynthesis software, 3-D digital model of residual tooth and metal part was established and the entire tooth model was prepared after adhesion of two parts. In order to provide better boundary conditions of simulated natural tooth in practice, alveolar bone was considered. Under Mesh order in ANSYS software, automatic mesh generation was performed in the model directly.MAIN OUTCOME MEASURES: Establishment of 3-D finite element models of residual tooth before restoration, post inlay, and alveolar bone and tooth after restoration and the results of mesh generation.RESULTS: By establishing 3-D finite element models of residual tooth before restoration, post inlay, alveolar bone and tooth after restoration and automatic mesh generation, there were altogether 117720 units and 20988nodes. Good geometric similarity presents between the construction model of 3-D finite element model and solid tissue.CONCLUSION: Combination of 3-D finite-element model with spiral Ctcross technology establishes complex dental models, simulates practical conditions authentically and is good in operation.

Streptomycetes produce many antibiotics and are important model microorgansims for scientific research and antibiotic production. Metabolomics is an emerging technological platform to analyze low molecular weight metabolites in a given organism qualitatively and quantitatively. Compared to other Omics platform, metabolomics has greater advantage in monitoring metabolic flux distribution and thus identifying key metabolites related to target metabolic pathway. The present work aims at establishing a rapid, accurate sample preparation protocol for metabolomics analysis in streptomycetes. In the present work, several sample preparation steps, including cell quenching time, cell separation method, conditions for metabolite extraction and metabolite derivatization were optimized. Then, the metabolic profiles of Streptomyces coelicolor during different growth stages were analyzed by GC-MS. The optimal sample preparation conditions were as follows: time of low-temperature quenching 4 min, cell separation by fast filtration, time of freeze-thaw 45 s/3 min and the conditions of metabolite derivatization at 40 degrees C for 90 min. By using this optimized protocol, 103 metabolites were finally identified from a sample of S. coelicolor, which distribute in central metabolic pathways (glycolysis, pentose phosphate pathway and citrate cycle), amino acid, fatty acid, nucleotide metabolic pathways, etc. By comparing the temporal profiles of these metabolites, the amino acid and fatty acid metabolic pathways were found to stay at a high level during stationary phase, therefore, these pathways may play an important role during the transition between the primary and secondary metabolism. An optimized protocol of sample preparation was established and applied for metabolomics analysis of S. coelicolor, 103 metabolites were identified. The temporal profiles of metabolites reveal amino acid and fatty acid metabolic pathways may play an important role in the transition from primary to secondary metabolism in S. coelicolor.
Gas Chromatography-Mass Spectrometry ; Metabolic Networks and Pathways ; Metabolome ; Metabolomics ; methods ; Streptomyces coelicolor ; metabolism

Objective:To observe the therapeutic efficacy and prognosis of daratumumab combined with chemotherapy bridging to allogeneic hematopoietic stem cell transplantation (allo-HSCT) followed by daratumumab and lenalidomide maintenance treatment for primary plasma cell leukemia (PCL).Methods:The clinical data of a patient with primary PCL admitted to the First People's Hospital of Yunnan Province in January 2020 were retrospectively analyzed, and relevant literatures were reviewed.Results:The patient was diagnosed with primary PCL and treated with daratumumab combined with BD (bortezomib + dexamethasone) for 1 course and BCDD (bortezomib + cyclophosphamide + liposomaldoxorubicin + dexamethasone) for two courses. The patient was treated with daratumumab combined with allo-HSCT after complete remission. The donor cells were successfully implanted and the chimerism rate of donor cells was 94.36% without acute graft-versus-host disease reaction. And then the patient received intermittent maintenance therapy of daratumumab combined with low dose lenalidomide after transplantation, and the current remission period after transplantation reached 4 months.Conclusions:Daratumumab combined with chemotherapy bridging to allo-HSCT followed by daratumumab and lenalidomide may improve the prognosis of primary PCL and prolong survival time.

Although efficient nonsurgical transfer of embryos in mice would provide many advantages over a surgical method, the low success rate of nonsurgical transfer has hampered its acceptance and use. Here, a plastic catheter was used to mimic embryo transfer process and then the transfer efficiency was evaluated by intrauterine trypan blue dye dispersion. Also 3.5-day blastocysts from natural pregnant mice were transferred through cervix into uterine horns. The results show that 70.9% of CD-1 mouse 3.5-day blastocysts transferred into unilateral uterine horns of pseudopregnant 2.5-day recipients can be developed to live newborns, and an efficient mouse nonsurgical embryo transfer technique was established. The technique was simple, rapid, inexpensive, unlikely to get contaminated, ethical and do not need specialized apparatus, and can completely replace surgical embryo transfer techniques. Moreover, the mouse nonsurgical embryo transfer technique provides a research model for human and other large animal embryo transfer.
Animals ; Blastocyst ; Embryo Transfer ; methods ; veterinary ; Female ; Mice ; Pregnancy

OBJECTIVE To promote the standardization of the “Indications” section in package inserts for Chinese patent medicines and ensure rational clinical and patient use. METHODS The “Function and Indications” information of package inserts for Chinese patent medicines was retrieved and collected from the 2020 edition of the Chinese Pharmacopoeia （Volume Ⅰ） and various national and regional standards. Identification criteria were established for syndrome， pathogenesis， disease name， and symptom terminology in the “Indications” section. Microsoft Office Access 2021 was utilized to create query tables for manual extraction of terminological elements， followed by the construction of a three-tier classification system for “Indications” descriptions. A standardized template for “Indications” was developed through quantitative analysis. RESULTS & CONCLUSIONS A total of 9 851 valid package inserts for Chinese patent medicines were included. Among these， the majority （7 991） contained symptom terminology， followed by disease names （5 867） and pathogenesis descriptions （5 167）. Within disease name terminology， Western medical disease names predominated （4 446）， followed by traditional Chinese medicine disease names （2 018）. The “Function and Indications” content of 6 962 package inserts complied with existing requirements. Notably， the secondary classifications of “disease name”， as well as the tertiary classification of “disease name+symptoms” and “symptoms”， failed to meet established standards. Two standardized templates for “Indications” were formulated based on pathogenesis and syndrome：“pathogenesis+disease name+symptoms” and “disease name+syndrome+symptoms”. The “Indications”section should provide complete and accurate information， adhere to standardized formatting， and employ appropriate conjunctions and punctuation. For non-prescription patent medicines， package inserts should be categorized into professional and patient versions. These measures will facilitate the standardization of “Indications” descriptions and advance the overall package inserts for Chinese patent medicines documentation.