Six derivatives of 5-nitrofurfural were evaluated for their cytotoxic activities. The cytotoxic effect has been tested in vitro on the tumor cell lines KB and FI. All six tested compounds demonstrated a significant cytotoxic effect in both examined tumor cell lines. Among these, the compound H25 showed the highest activity
Pharmacy ; chemistry ; Activity Cycles ; drugs ; Furaldehyde

Nitration of furfural to give 5-nitrofurfural diacetate (NFD). By the condensation of NFD with 2-butanone (or acethylacetone), two cetone a, b-ethylenic deriva-tives (I,II) were formed. Condensation of furfural with acetone to give (XII). Condensation of I (or II or XII) with various H2N-B compounds to give 15 derivatives (III-XI, XIII- XVIII). The structure of the obtained products were characterized by elemental analysis and IR and 1H-NMR spectroscopy.The synthesized compounds were tested for biological ethylenic activities such as antibacterial and antifungal. Among these, two cetone a, b-ethylenic derivatives of 5-nitrofurfural (I,II) showed a high antibacterial activity on 10 strains of bacteria and a high antifungal activity against Candida albicans.
Chemical synthesis ; Physiological Effects of Drugs ; Furaldehyde ; Analogs & derivatives

Accidents, Occupational ; Acute Disease ; Adult ; Furaldehyde ; poisoning ; Humans ; Male

Fast pyrolysis experiments of corn stalk were performed to investigate the optimal pyrolysis conditions of temperature and bed material for maximum bio-oil production under flue gas atmosphere. Under the optimized pyrolysis conditions, furfural residue, xylose residue and kelp seaweed were pyrolyzed to examine their yield distributions of products, and the physical characteristics of bio-oil were studied. The best flow rate of the flue gas at selected temperature is obtained, and the pyrolysis temperature at 500 degrees C and dolomite as bed material could give a maximum bio-oil yield. The highest bio-oil yield of 43.3% (W/W) was achieved from corn stalk under the optimal conditions. Two main fractions were recovered from the stratified bio-oils: light oils and heavy oils. The physical properties of heavy oils from all feedstocks varied little. The calorific values of heavy oils were much higher than that of light oils. The pyrolysis gas could be used as a gaseous fuel due to a relatively high calorific value of 6.5-8.5 MJ/m3.
Biofuels ; Biomass ; Bioreactors ; Furaldehyde ; chemistry ; Hot Temperature ; Kelp ; Temperature ; Xylose ; chemistry ; Zea mays

To evaluate the absorptive characteristics of furfural onto biomass charcoals derived from rice husk pyrolysis, we studied the information of the structure and surface chemistry properties of the rice husk charcoals modified by thermal treatment under nitrogen and carbon dioxide flow and adsorption mechanism of furfural. The modified samples are labeled as RH-N2 and RH-CO2. Fresh rice husk charcoal sample (RH-450) and modified samples were characterized by elemental analysis, nitrogen adsorption-desorption isotherms, Fourier-transform infrared spectroscopy and Boehm titration. The results show that fresh rice husk charcoal obtained at 450 degrees C had a large number of organic groups on its surface and poor pore structure. After the modification under nitrogen and carbon dioxide flow, oxygenic organics in rice husk charcoals decompose further, leading to the reduction of acidic functional groups on charcoals surface, and the increase of the pyrone structures of the basic groups. Meanwhile, pore structure was improved significantly and the surface area was increased, especially for the micropores. This resulted in the increase of π-π dispersion between the surfaces of rice husk charcoals and furfural molecular. With making comprehensive consideration of π-π dispersion and pore structure, the best removal efficiency of furfural was obtained by rice husk charcoal modified under carbon dioxide flow.
Adsorption ; Biomass ; Carbon Dioxide ; Charcoal ; Furaldehyde ; chemistry ; Nitrogen ; Oryza ; Spectroscopy, Fourier Transform Infrared ; Surface Properties

The expensive production of bioethanol is because it has not yet reached the 'THREE-HIGH' (High-titer, high-conversion and high-productivity) technical levels of starchy ethanol production. To cope with it, it is necessary to implement a high-gravity mash bioethanol production (HMBP), in which sugar hydrolysates are thick and fermentation-inhibitive compounds are negligible. In this work, HMBP from an atmospheric glycerol autocatalytic organosolv pretreated wheat straw was carried out with different fermentation strategies. Under an optimized condition (15% substrate concentration, 10 g/L (NH4)2SO4, 30 FPU/g dry matter, 10% (V/V) inoculum ratio), HMBP was at 31.2 g/L with a shaking simultaneous saccharification and fermentation (SSF) at 37 degrees C for 72 h, and achieved with a conversion of 73% and a productivity of 0.43 g/(L x h). Further by a semi-SFF with pre-hydrolysis time of 24 h, HMBP reached 33.7 g/L, the conversion and productivity of which was 79% and 0.47 g/(L x h), respectively. During the SSF and semi-SSF, more than 90% of the cellulose in both substrates were hydrolyzed into fermentable sugars. Finally, a fed-batch semi-SFF was developed with an initial substrate concentration of 15%, in which dried substrate (= the weight of the initial substrate) was divided into three portions and added into the conical flask once each 8 h during the first 24 h. HMBP achieved at 51.2 g/L for 72 h with a high productivity of 0.71 g/(L x h) while a low cellulose conversion of 62%. Interestingly, the fermentation inhibitive compound was mainly acetic acid, less than 3.0 g/L, and there were no other inhibitors detected, commonly furfural and hydroxymethyl furfural existing in the slurry. The data indicate that the lignocellulosic substrate subjected to the atmospheric glycerol autocatalytic organosolv pretreatment is very applicable for HMBP. The fed-batch semi-SFF is effective and desirable to realize an HMBP.
Biofuels ; Carbohydrates ; chemistry ; Cellulose ; chemistry ; Ethanol ; metabolism ; Fermentation ; Furaldehyde ; chemistry ; Glycerol ; chemistry ; Hydrolysis ; Triticum

Some degradation products from lignocellulose pretreatment strongly inhibit the activities of cellulolytic enzymes and ethanol fermentation strains, thus the efficient removal of the inhibitor substances ("detoxification") is the inevitable step for the biotransformation processes. In this study, the biological detoxification of furfural by a newly isolated fungus, Amorphotheca resinae ZN1, was studied and the metabolic pathways of furfural degradation was analyzed. The metabolic pathway of furfural degradation in A. resinae ZN1 was described as follows: first, furfural was quickly converted into the low toxic furfuryl alcohol; then the furfuryl alcohol was gradually converted into furfural again but under the low concentration under aerobic condition, which was not lethal to the growth of the fungi; furfural continued to be oxidized to furoic acid by A. resinae ZN1. It is likely that furoic acid was further degraded in the TCA cycle to complete the biological degradation of furfural. The present study provided the important experimental basis for speeding up the biodetoxification of furfural by A. resinae ZN1 and the rate-limiting step in the lignocellulose biotransformation to ethanol.
Biodegradation, Environmental ; Biotransformation ; Ethanol ; metabolism ; Fermentation ; Fungi ; metabolism ; Furaldehyde ; isolation & purification ; metabolism ; Furans ; metabolism ; Lignin ; metabolism

Byproducts in lignocellulose hydrolysates, namely sodium formate (1 to 5 g/L), sodium acetic (2.5 to 8.0 g/L), furfural (0.2-2 g/L), 5-hydroxymethylfurfural (5-HMF, 1 to 1.0 g/L) or vanillin (0.5 to 2 g/L) were used to evaluate their effects on ethanol fermentation by Issatchenkia orientalis HN-1 using single factor test and the response surface central composite experiment. Results showed that most of the byproducts had no obvious inhibition on the production of ethanol, except for the addition of 2 g/L vanillin or 1 g/L of 5-HMF, which reduced the ethanol production by 20.38% and 11.2%, respectively. However, high concentration of some byproducts in lignocellulose hydrolysates, such as sodium formate (1 to 5 g/L), sodium acetic (2.5 to 8.0 g/L), furfural (0.2 to 2 g/L) and vanillin (0.5 to 2 g/L) inhibited the growth of I. orientalis HN-1 significantly. Compared with the control, the dry cell weight of I. orientalis HN-1 decreased by 25.04% to 37.02%, 28.83% to 43.82%, 20.06% to 37.60% and 26.39% to 52.64%, respectively, when the above components were added into the fermentation broth and the fermentation lasted for 36 h. No significant interaction effect of the various inhibitors (sodium formate, sodium acetic, furfural and vanillin) except for vanillin single factor on the ethanol production was observed based on the central composite experiments. The concentrations of byproducts in most lignocellulose hydrolysates were below the initial inhibition concentration on ethanol production by Issatchenkia orientalis HN-1, which indicated that Issatchenkia orientalis HN-1 can be used for ethanol production from lignocellulose hydrolysates.
Ethanol ; metabolism ; Fermentation ; Furaldehyde ; analogs & derivatives ; chemistry ; Lignin ; chemistry ; Saccharomycetales ; metabolism

In order to investigate the influencing factors of 5-hydroxymethyl-2-furaldehyde (5-HMF) content in Schisandra, confirm the theory of 5-HMF deriving mainly from Schisandra processing course, and give some suggestions about the Schisandra processing method, the 5-HMF contents in decoctions of Schisandra under different heating temperature, decocting time, soaking time, processing methods and treatment with different solvents before decocting the Schisandra were measured by RP-HPLC method. The results showed that there is great difference of 5-HMF level in decoctions from differently processed Schisandra and unprocessed Schisandra; decocting time of 60 min has some effects on 5-HMF level in decoctions and there is certain quantity 5-HMF in processed Schisandra itself and very little 5-HMF in unprocessed Schisandra. Heating time, heating temperature and treating solvents all have effect on 5-HMF level in decoction of Schisandra. 5-HMF in Schisandra was mainly from processing course. Both long heating time and high heating temperature can increase 5-HMF level in Schisandra. The production of 5-HMF in Schisandra may have some relationships with some polar components, which can dissolve in water, ethanol and acetone, especially in ethanol. To control processing temperature, processing time and treatment with some solvent is very important for controlling 5-HMF level in Schisandra.
Chromatography, High Pressure Liquid ; Furaldehyde ; analogs & derivatives ; analysis ; Plant Extracts ; chemistry ; Schisandra ; chemistry ; Temperature ; Time Factors

The antifungal effect of pine needle extract prepared by a distinguishable extraction method and the dry distillation method, was examined. The effect of this extract itself was insignificant. The chemical components of pine needle extract were then investigated by gas chromatographic analysis, and four chemical components, acetol, furfural, 5-methyl furfural, and terpine-4-ol, were identified. The antifungal effects of those four chemical components against Alternaria mali (A. mali), an agent of Alternaria blotch of apple, were then examined. It was observed that the minimum inhibitory concentrations (MICs) were 6.25, 0.78, 0.78, and 12.5 (mg/ml) of acetol, furfural, 5-methyl furfural, and terpine-4-ol, respectively. MICs of furfural and 5-methyl furfural had the same order of magnitude as that of an antifungal agrochemical, chlorothalonil. Although furfural itself can not be completely substituted for an antifungal agrochemical, a partial mixture of furfural and antifungal agrochemical may be used as a substitute. The use of agrochemicals for the prevention of plant disease caused by pathogenic fungus such as A. mali could be partially reduced by the application of this mixture.
Agrochemicals ; Alternaria* ; Distillation ; Fungi* ; Furaldehyde* ; Mali* ; Microbial Sensitivity Tests ; Needles* ; Plant Diseases ; Plants*