This study estimated the prevalence of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) infection in urban cleaning and solid waste management workers during the transmission of the Omicron variant in one of the poorest regions of Brazil (the state of Sergipe). Nasopharyngeal swabs were collected from 494 workers, and the presence of SARS-CoV-2 RNA was tested by quantitative reverse-transcriptase polymerase chain reaction. Data on socio-demographic characteristics, comorbidities, vaccination status, mask use, and use of public transport to commute to the workplace were collected. The prevalence with a 95% confidence interval (CI) was calculated from the proportion of SARS-CoV-2 positive cases among the total number of individuals tested. The prevalence ratio (PR) with a 95% CI was the measure of association used to evaluate the relationship between SARS-CoV-2 infection and the exposure variables. The prevalence of SARS-CoV-2 infection was 22.5% (95% CI, 19.0 to 26.4). Individuals under the age of 40 had a higher prevalence of infection (PR, 1.53; 95% CI, 1.03 to 2.30) as well as those who did not believe in the protective effect of vaccines (PR, 1.78; 95% CI, 1.05 to 2.89). Our results indicate the need for better guidance on preventive measures against coronavirus disease 2019 among urban cleaning and solid waste management workers.

PURPOSE: . This study aimed to assess and compare the color stability, flexural strength (FS), and surface roughness of occlusal splints fabricated from heatcured acrylic resin, milled polymethyl methacrylate (PMMA)-based resin, and 3D-printed (PMMA) based-resin. MATERIALS AND METHODS: . Samples of each type of resin were obtained, and baseline measurements of color and surface roughness were recorded. The specimens were divided into three groups (n = 10) and subjected to distinct aging protocols: thermomechanical cycling (TMC), simulated brushing (SB), and control (without aging). Final assessments of color and surface roughness and three-point bending test (ODM100; Odeme) were conducted, and data were statistically analyzed (2-way ANOVA, Tukey, P <.05). RESULTS: . Across all resin types, the most significant increase in surface roughness (Ra) was observed after TMC (P < .05), with the 3D-printed resin exhibiting the lowest Ra (P < .05). After brushing, milled resin displayed the highest Ra (P < .05) and greater color alteration (∆E00 ) compared to 3D-printed resin. The most substantial ∆E00 was recorded after brushing for all resins, except for heat-cured resin subjected to TMC. Regardless of aging, milled resin exhibited the highest FS (P < .05), except when compared to 3D-printed resin subjected to TMC. Heat-cured resin exposed to TMC demonstrated the lowest FS, different (P < .05) from the control. Under control conditions, milled resin exhibited the highest FS, different (P < .05) from the brushed group. 3D-printed resin subjected to TMC displayed the highest FS (P< .05). CONCLUSION . Among the tested resins, 3D-printed resin demonstrated superior longevity, characterized by minimal surface roughness and color alterations. Aging had a negligible impact on its mechanical properties.