The aim of the present study was to detect the transmission rate of ultrasonic low intensity pulsed ultrasound (LIPUS) through polytetrafluoroethylene (PTFE) membrane (Thickness: 0.01 mm) and Bio-Gide collagen membrane, and to provide the basis for the barrier membrane selection on the study of LIPUS combined with guided tissue regeneration (GTR). The ultrasonic (LIPUS, frequency 1.5 MHz, pulse width 200 micros, repetition rate 1.0 kHz) transmission coefficient of the two kinds of barrier membrane were detected respectively through setting ten groups from 10 to 100mW/cm2 every other 10 mW/cm2. We found in the study that the ultrasonic transmission coefficient through 0.01 mm PTFE membrane was 78.1% to 92.%, and the ultrasonic transmission coefficient through Bio-Gide collagen membrane was 43.9% to 55.8%. The ultrasonic transmission coefficient through PTFE membrane was obviously higher than that through Bio-Gide collagen membrane. The transmission coefficient of the same barrier membrane of the ultrasonic ion was statistically different under different powers (P < 0.05). The results showed that the ultrasonic transmittance rates through both the 0.01 mm PTFE membrane and Bio-Gide collagen membrane were relatively high. We should select barrier membranes based on different experimental needs, and exercise ultrasonic transmission coefficient experiments to ensure effective power.
Biocompatible Materials ; Collagen ; chemistry ; Membranes, Artificial ; Permeability ; Polytetrafluoroethylene ; chemistry ; Ultrasonics

OBJECTIVES: To establish an experimental method for evaluating material permeability of type I collagen hydrogels. METHODS: Using BSA-FITC as an indicator, by combining BSA-FITC with PBS they were used as permeability media, and using transwell load hydrogen sample to detect BSA-FITC transparent rate. RESULTS: In the concentration range of 100 μg·mL~0.781 μg·mL, the standard curve ≥ 0.99, Lower Limit of Quantity (LLOQ) is 3.125 μg·mL, RSD <5%, detection recovery rate is in the range of 80%~120%. CONCLUSIONS In this study, we established an experimental method for evaluating material permeability of hydrogel. The BSA-FITC transparent rate of type I collagen hydrogel was 100% at 28 h.
Collagen Type I ; chemistry ; Hydrogels ; chemistry ; Materials Testing ; Permeability

BACKGROUNDIntracranial infection is one of the most common complications of open craniocerebral injury and of conventional craniotomy in neurosurgery. The presence of blood-brain barrier leads to lower drug concentrations in the cerebrospinal fluid than in the venous blood. Increasing the intravenous dosage or frequency carries the risk of systemic adverse reactions or infections in other parts of the body. Developing an artificial dura mater (ADM) for sustained antibiotic release for use during neurosurgery can solve the problems perfectly.

METHODSThree types of drug-loaded ADMs made of collagen and containing cefuroxime sodium, ceftriaxone sodium, or norvancomycin were prepared. The antibacterial activity and sustained release characteristics of the ADMs were examined using bacteriostatic and release tests.

RESULTSSingle-layered collagen based ADMs (40 mm×50 mm×5 mm) containing 18 mg cefuroxime sodium or ceftriaxone sodium were not suitable for continued development because of drug preservation and stability issues. Using smaller ADMs (20 mm×30 mm×7 mm), containing 4.86 mg of norvancomycin, with increased collagen density and a three-layered film with two outer drug-free films above and below the antibiotic layer resulted in sustained cumulative release of 2.91 mg (59.9%) of norvancomycin over 72 hours. The similar factor (f2) comparison method proved that products from a same batch were statistically significant similar (f2 > 50).

CONCLUSIONSArtificial ADMs made of collagen can be processed to provide a mature dural repair material for the sustained release of norvancomycin. This system may provide a basis for developing sustained release materials for other drugs.

Anti-Bacterial Agents ; chemistry ; Biocompatible Materials ; chemistry ; Ceftriaxone ; chemistry ; Cefuroxime ; chemistry ; Collagen ; chemistry ; Dura Mater ; chemistry ; Vancomycin ; analogs & derivatives ; chemistry

Fe (III) modified collagen fibers were used to immobilize catalase through the cross-linking of glutaraldehyde. The loading amount of catalase on the supporting matrix was 16.7 mg/g, and 35% enzymatic activity was remained. A series of experiments were conducted on free and immobilized catalase in order to investigate their optimal pH and temperature, and the thermal, storage and operation stability. Results suggest that the free and immobilized catalase prefer similar pH and temperature condition, which were pH 7.0 and 25 degrees C. It should be noted that the thermal stability of catalase was considerably improved after immobilization owing to the fact that the enzyme kept 30% of relative activity after incubation at 75 degrees C for 5 h. On the contrary, the free catalase was completely inactive. As for the storage stability, the immobilized catalase kept 88% of relative activity after stored at room temperature for 12 days while the free one was completely inactive under the same conditions. Moreover, the immobilized catalase preserved 57% of relative activity after being reused 26 times, exhibiting excellent operation stability. Consequently, this investigation suggests that collagen fiber can be used as excellent supporting matrix for the immobilization of catalase, and it is potential to be used for the immobilization of similar enzymes.
Catalase ; chemistry ; metabolism ; Collagen ; chemistry ; metabolism ; Enzymes, Immobilized ; chemistry ; metabolism ; Ferric Compounds ; chemistry

Soft tissue is an indispensable tissue in human body. It plays an important role in protecting the body from external physical, chemical or biological factors. Mild soft tissue injuries can self-heal, while severe soft tissue injuries may require related treatment. Natural polymers (such as chitosan, hyaluronic acid, and collagen) and synthetic polymers (such as polyethylene glycol and polylactic acid) exhibit good biocompatibility, biodegradability and low toxicity. It can be used for soft tissue repairs for antibacterial, hemostatic and wound healing purposes. Their related properties can be enhanced through modification or preparation of composite materials. Commonly used soft tissue repairs include wound dressings, biological patches, medical tissue adhesives, and tissue engineering scaffolds. This study introduces the properties, mechanisms of action and applications of various soft tissue repair medical materials, including chitosan, hyaluronic acid, collagen, polyethylene glycol and polylactic acid, and provides an outlook on the application prospects of soft tissue repair medical materials and products.
Humans ; Biocompatible Materials/chemistry* ; Chitosan/chemistry* ; Hyaluronic Acid ; Tissue Scaffolds/chemistry* ; Collagen/chemistry* ; Polymers/chemistry* ; Polyethylene Glycols ; Soft Tissue Injuries

A composite material consisting of carbonate apatite (CAp) and type I atelocollagen (AtCol) (88/12 in wt/wt%) was designed for use as an artificial bone substitute. CAp was synthesized at 58 degrees C by a solution-precipitation method and then heated at either 980 degrees C or 1,200 degrees C. In this study, type I AtCol was purified from bovine tail skins. A CAp-AtCol mixture was prepared by centirfugation and condensed into composite rods or disks. The scanning electron-microscopic (SEM) characterization indicated that the CAp synthesized at 58 degrees C displayed a crystallinity similar to that of natural bone and had a high porosity (mean pore size: about 3-10 microns in diameter). SEM also revealed that the CAp heated at 980 degrees C was more porous than that sintered at 1,200 degrees C, and the 1,200 degrees C-heated particles were more uniformly encapsulated by the AtCol fibers than the 980 degrees C-heated ones. A Fourier transformed-infrared spectroscopic analysis showed that the bands characteristic of carbonate ions were clearly observed in the 58 degrees C-synthesized CAp. To enhance the intramolecular cross-linking between the collagen molecules, CAp-AtCol composites were irradiated by ultraviolet (UV) ray (wave length 254 nm) for 4 hours or vacuum-dried at 150 degrees C for 2 hours. Compared to the non cross-linked composites, the UV-irradiated or dehydrothermally cross-linked composites showed significantly (p < 0.05) low collagen degradation and swelling ratio. Preliminary mechanical data demonstrated that the compressive strengths of the CAp-AtCol composites were higher than the values reported for bone.
Animal ; Apatites*/chemistry ; Bone Substitutes*/chemistry ; Bone Transplantation ; Cattle ; Collagen*/chemistry

Cell adhesion to material surface plays an important role in regulating cell function such as proliferation and differentiation. Surface patterning provides a useful method to control cell spatial distribution and adhesion to substance. Here microcontact printing and microfluidic channels were introduced to pattern MC3T3 E1 osteoblasts on silicon substance. Dichlordimethylsilane (DMS) was used in microcontact printing to generate the alternating domains of DMS and non-DMS, and cells preferentially adhered to the non-DMS and hydrophilic region. On the patterned surfaces generated from collagen and albumin solutions with microfluidic channels, cells preferentially localized in the collagen-coated region. The results also showed that micropatterning could be a useful method to study the effect of surface chemistry on cell adhesion and other functions.
Cell Adhesion ; Cells, Cultured ; Collagen ; chemistry ; Dimethylpolysiloxanes ; chemistry ; Osteoblasts ; physiology ; Serum Albumin, Bovine ; chemistry ; Surface Properties

Bone cement samples were made of tetracalcium phosphate (TTCP) and monocalcium phosphate monohydrate(MCPM) powder (Ca/P = 1.67) by using water and 5.24 mg/ml of self-made type I collagen sol as hardening liquid with the solid-liquid ratio of 3:1, their setting time and compressive strength were tested. The results showed that: the compressive strength of TTCP/MCPM bone cement containing collagen could increase from 17.8 +/- 1.9 MPa to 22.7 +/- 1.6 MPa, but its setting time hasn't been significantly affected; the compressive strength of both samples immersed in simulated body fluid (SBF) could increase, and the growth rate of the sample containing collagen increased especially; both samples immersed in SBF for 4d and 14d, whose compressive strength could increase to 31.8 +/- 3.9 MPa (collagen)/19.5 +/- 1.3 MPa and 38.1 +/- 3.1 MPa (collagen)/21.9 +/- 2.2 MPa. According to the IR analysis before and after the collagen was mineralized, it showed that: after the collagen was mineralized, the characteristic peaks of the collagen's amide I band showed red-shift, while the amide II band and the amide III band nearly disappeared, suggesting that chemical action occurred between the collagen and hydroxyapatite (HA), which should be the basis of the enhancement on the TTCP/MCPM bone cement caused by collagen; while according to the SEM and XRD patterns of the sample surface before and after the samples were immersed in SBF, it showed that: the immersion in SBF changed brushite (DCPD) into HA, at the same time, large number of new HA deposited, making the samples' surface more dense and smooth. It was not only the enhancement mechanism of immersion in SBF, but also showed the coagulating and hardening process of TTCP/MCPM bone cement was that: the DCPD was generated firstly, then it changed into HA.
Bone Cements ; chemistry ; Calcium Phosphates ; chemistry ; Collagen Type I ; chemistry ; Compressive Strength

BACKGROUNDPeople recently realized that it is important for artificial vascular biodegradable graft to bionically mimic the functions of the native vessel. In order to overcome the high risk of thrombosis and keep the patency in the clinical small-diameter vascular graft (SDVG) transplantation, a double-layer bionic scaffold, which can offer anticoagulation and mechanical strength simultaneously, was designed and fabricated via electrospinning technique.

METHODSHeparin-conjugated polycaprolactone (hPCL) and polyurethane (PU)-collagen type I composite was used as the inner and outer layers, respectively. The porosity and the burst pressure of SDVG were evaluated. Its biocompatibility was demonstrated by the 3-(4,5-dimethyl-2-thiazol)-2,5-diphenyl-2H tetrazolium bromide (MTT) test in vitro and subcutaneous implants in vivo respectively. The grafts of diameter 2.5 mm and length 4.0 cm were implanted to replace the femoral artery in Beagle dog model. Then, angiography was performed in the Beagle dogs to investigate the patency and aneurysm of grafts at 2, 4, and 8 weeks post-transplantation. After angiography, the patent grafts were explanted for histological analysis.

RESULTSThe double-layer bionic SDVG meet the clinical mechanical demand. Its good biocompatibility was proven by cytotoxicity experiment (the cell's relative growth rates (RGR) of PU-collagen outer layer were 102.8%, 109.2% and 103.5%, while the RGR of hPCL inner layer were 99.0%, 100.0% and 98.0%, on days 1, 3, and 5, respectively) and the subdermal implants experiment in the Beagle dog. Arteriography showed that all the implanted SDVGs were patent without any aneurismal dilatation or obvious anastomotic stenosis at the 2nd, 4th, and 8th week after the operation, except one SDVG that failed at the 2nd week. Histological analysis and SEM showed that the inner layer was covered by new endothelial-like cells.

CONCLUSIONThe double-layer bionic SDVG is a promising candidate as a replacement of native small-diameter vascular graft.

Animals ; Bionics ; Blood Vessel Prosthesis ; Cell Line ; Collagen ; Dogs ; Heparin ; chemistry ; Mice ; Polyesters ; chemistry ; Polyurethanes ; chemistry

OBJECTIVETo investigate the structure and degradation property of the polyvinyl alcohol (PVA)-collagen complex drug membrane.

METHODSDrug collagen membrane was complexed with PVA. The physical and chemical properties of the membrane were characterized by transmission electron microscopy, scanning electron microscope, forier transform-infrared spectroscopy and differential scanning calorimetry. Degradation experiment was performed to determine the degradation property of membrane and a degradation curve was therefor drawn.

RESULTSThe thermodynamic stability of collagen membrane was not destroyed by adding PVA. Collagen had good compatibility with PVA. Compared with collagen membrane, collagen-PVA complex membrane had smaller and evener pores. Adding PVA decreased the degradation rate of membrane.

CONCLUSIONSPVA-collagen membrane has better microstructure and antidegradation property than collagen membrane.

Biocompatible Materials ; chemistry ; Collagen ; chemistry ; ultrastructure ; Humans ; Membranes ; Polyvinyl Alcohol ; chemistry ; Spectroscopy, Fourier Transform Infrared