Cleft lip lower-lip deformity is a secondary deformity in patients who underwent primary cheiloplasty of the upper lip, characterized by an enlarged and anteriorly rotated lower lip. In these cases, soft-tissue imbalances remain even after skeletal correction with orthognathic surgery, and additional soft tissue treatment is required for lip harmony and esthetic facial balance in CLP (cleft lip palate) patients. This study describes three cases of transverse myomucosal excision of the lower lip for correction of cleft lip lower-lip deformity to restore facial esthetic balance. Each patient underwent orthognathic surgery, rhinoplasty, or upper lip revision cheiloplasty according to condition. Postoperatively, volume of the lower lip decreased and lip harmony was improved in all three patients. The surgeon should fully understand the anatomical structure around the lips and be able to evaluate overall harmony of the soft tissue. When a lower lip deformity is present, careful surgical planning and execution are important for each patient.

OBJECTIVES: The aim of this study was to verify the concordance of the measurement values when the same cephalometric analysis method was used for two-dimensional (2D) cephalometric radiography and three-dimensional computed tomography (3D CT), and to identify which 3D Frankfort horizontal (FH) plane was the most concordant with FH plane used for cephalometric radiography. MATERIALS AND METHODS: Reference horizontal plane was FH plane. Palatal angle and occlusal plane angle was evaluated with FH plane. Gonial angle (GA), palatal angle, upper occlusal plane angle (UOPA), mandibular plane angle (MPA), U1 to occlusal plane angle, U1 to FH plane angle, SNA and SNB were obtained on 2D cephalmetries and reconstructed 3D CT. The values measured eight angles in 2D lateral cephalometry and reconstructed 3D CT were evaluated by intraclass correlation coefficiency (ICC). It also was evaluated to identify 3D FH plane with high degree of concordance to 2D one by studying which one in four FH planes shows the highest degree of concordance with 2D FH plane. RESULTS: ICCs of MPA (0.752), UOPA (0.745), SNA (0.798) and SNB (0.869) were high. On the other hand, ICCs of gonial angle (0.583), palatal angle (0.287), U1 to occlusal plane (0.404), U1 to FH plane (0.617) were low respectively. Additionally GA and MPA acquired from 2D were bigger than those on 3D in all 20 patients included in this study. Concordance between one UOPA from 2D and four UOPAs from 3D CT were evaluated by ICC values. Results showed no significant difference among four FH planes defined on 3D CT. CONCLUSION: FH plane that can be set on 3D CT does not have difference in concordance from FH plane on lateral cephalometry. However, it is desirable to define FH plane on 3D CT with two orbitales and one porion considering the reproduction of orbitale itself.
Cephalometry* ; Dental Occlusion ; Hand ; Humans ; Radiography ; Reproduction

Tracheostomy is a surgical procedure that is commonly used to treat upper airway obstruction. In particular, patients with head and neck cancer may require elective or emergency tracheostomy because of airway obstruction due to massive bleeding of the intraoral tumor mass and rapid growth of the tumor mass in the neck area.Here, we report four cases of tracheostomy in patients with head and neck cancer with narrowed airway space and difficulty in breathing. Based on these cases and a literature review, we recommend that oral and maxillofacial surgeons and dental anesthesiologists should cooperate closely and determine the appropriate timing to perform definitive airway management for such patients during palliative treatment, along with continuous evaluation of tumor location, risk of recurrence, and airway involvement.