Objective To optimize the extraction of polysaccharides from Ophiopogon japonicus by the use of response surface methodology.Method According to the design principle of Box-Behnken, effects of extraction temperature, extraction time , extraction times and solid-liquid ratio on the extraction yield of Ophiopogon japonicus polysaccharides were studied by response surface methodology,meanwhile regression analysis of these experimental data was used by Design-Expert 8.05b software.Results The optimum extraction conditions from Ophiopogon japonicus were concluded as follows: the extraction temperature was 93℃, extraction time was 2 h, extraction times was 3 times, and solid-liquid ratio was 1:15 g/ml.Conclusion Under these conditions, the extraction yield of Ophiopogon japonicus polysaccharides is up to 5.440%, and the relative error is 7.328%.

Objective To investigate the preventive and therapeutic effects of Ginger extraction on heart failure in rabbits.Methods Twenty-seven New Zealand pure-breed rabbits were randomized into 3 groups:group A,group B and group C.Group A was orally administrated with 2 %Ginger extraction 3 days before and after modeling;group B was orally administrated with purified water 3 days before modeling and with 2 %Ginger extraction after modeling;group C was orally administrated with purified water 3 days before and after the establishment.The differences of modeling time and dosage of pentobarbital sodium between groups were compared;hemodynamics parameters before and after administration were detected.Results (1)The modeling time and dosage of Pentobarbital Sodium were remarkably increased in group A,differences being significant compared other 2 groups(P

Objective To investigate the effects of Rhizoma Zingiberis Extract (RZE) on the cardiac functions of rabbits with heart failure. Methods Forty pure-bred New-Zealand rabbits were randomly allocated to 4 groups: control group, low-dosage RZE group, moderate-dosage RZE group and high-dosage RZE group. The rabbit model of heart failure was established by intravenous dripping of 20 g/L pentobarbital sodium. Oral tube perfusion of RZE was given after model establishment.The hemodynamic changes were observed before and after the modeling and 5,10,15,20,30,45,60,90,120,150 minutes after treatment by a RM-6000 4-graph physiological monitor. Results After treatment, LVSP, lv?dp/dtmax,lv +dp/dtmax,lv-dp/dtmax showed an ascending tend in all the groups, particularly in RZE groups; the differences between the control group and RZE groups were significant 30 minutes after treatment (P

OBJECTIVETo establish a SPE-HPLC method for analyzing astilbin in rats serum and explore the effects of Yinxieling (YXL) prescription and Smilacis Glabrae Rhizoma on the pharmacokinetic characteristics of effective components.

METHODMale Sprague-dawley rats were administrated YXL and Smilacis Glabrae Rhizoma respectively. At different time points, serum concentration of astilbin was extracted by Solid Phase Extraction (SPE) and determined using HPLC method. Chromatographic separation was achieved on a reversed-phase Phenomenex C18 column with the mobile phase of methanol-acetonitrile-formic acid water solution (0.05% formic acid) and gradient elution, temperature of bar was 24 degrees C, flow rate was 0.8 mL x min(-1).

RESULTThe method showed excellent linearity over the concentration range 0.266-53.1 mg x L(-1) of astilbin (r = 0.996). The extract recoveries were from 79.0% to 89.1%. Significant diffenerce in pharmacokinetic parameter of astilbin including t1/2, Cmax, AUC(0-t), AUC(0-infinity) and MRT were obtained through non-compartment model after oral administration of YXL prescription comparing with Smilacis Glabrae Rhizoma.

CONCLUSIONThe method was applied to a pharmacokinetic study of astilbin. It indicated that the bioavailability of astilbin in YXL enhanced in rats and one of the reasons may be that components of prescription affect the pharmacokinetics of astilbin in vivo.

Administration, Oral ; Animals ; Drugs, Chinese Herbal ; administration & dosage ; chemistry ; Flavonols ; blood ; pharmacokinetics ; Male ; Rats ; Rats, Sprague-Dawley ; Reproducibility of Results

Objective To evaluate the clinical application value of multi-slice helical CT volumetric (VH) scanning in lumber spine. Methods One thousand of patients with back and leg pain who underwent CT examinations were selected as subjects. We simulated the traditional protocol of single-slice(SS) discrete scanning for L3/4, L4/5, and LS/S1 intervertebral discs. The VH scanning mode was performed with 120 kV, 210 mAs,pitch of 1.5 and coverage of 97. 5 mm. The simulated SS scanning mode was performed with 120 kV, 240 mAs and coverage of 45.0 mm. The diagnostic outcomes and the radiation doses were compared between the two scanning modes. Two groups doctors observed ten terms, including the osseous spinal stenosis,narrowed intervertebral space and so on in two scanning modes respectively. Then consistency analysis of the data was carried out. Results The VH scanning mode showed far more features than the SS mode. The detection rates of the VH mode in the osseous spinal stenosis, narrowed intervertebral space,herniated nucleus pulposus, narrowed lateral recess, vertebral lesion, hypertrophy of L5 transverse process,abnormal direction of facet, facet degeneration, lumbar spondyloschisis, and paraspinal soft tissue were 11.8% (n =118), 38. 5% (n =385), 9. 3% (n =93), 46. 8% (n =468), 31.4% (n =314), 5.7% (n =57), 25.4% (n = 254), 49. 7% (n = 497), 9.9% (n = 99), and 0. 6% (n = 6) respectively, while the detection rates of the SS mode in ten terms were 5.6% (n = 56), 0, 0. 6% (n = 6), 27. 9% (n = 279),22.4% (n =224), 1.2% (n = 12), 16.7% (n = 167), 37.2% (n =372), 0.5% (n =5), and 0.2%(n = 2) respectively. The difference between the two groups had statistically significance (average P <0.05), except the paraspinal soft tissue abnormal (P > 0.05). The detection rates of the VH mode were higher than the SS mode in the osseous spinal stenosis, narrowed intervertebral space, herniated nucleus pulposus, lumbar spondyloschisis, being 6.2% (n = 62) , 38. 5% (n = 385) , 8.7% (n = 87), and 9.4%(n =94), respectively. In addition, VH mode only partially showed the articular facets, narrowed lateral recess, hypertrophy of L.5 transverse process, and paraspinal soft tissue. We could not acquire the imaging slices paralleling to intervertebral discs in SS mode in 467 patients (46.7%) with lumbosacral angle greater than 35°. The radiation dose of VH mode (164.9 mGy/em) was slightly higher than SS mode (147.0 mGy/cm) Conclusion MSCT VH scanning mode can significantly improve the diagnostic rate of lumbar spine diseases compared with SS mode, and was not restricted by the lumbosacral angle with slightly increasing radiation dosage.

Objective:To develop an information system for testing radiological protection that can interface with National Radiation Health Information Platform/Medical Radiation Monitoring Subsystem and to improve the testing efficiency.Methods:Complying with the relevant national regulations and standards, the analysis was carried out of demand investigation and system modeling. An information system for testing radiological protection was established using B/S architecture, comprising three modules such as testing, audit and system management. The users at four levels were set of administrator, inspector, auditor and report issuer.Results:Based on test result, the developed information system has been shown to realize the informatization of the whole process from filling, auditing, issuing, issuing of the testing report to data uploading, with improved testing efficiency.Conclusions:The developed information system for testing radiological protection can improve the testing efficiency, and can be successfully interfaced with the National Radiation Health Information Platform/Medical Radiation Protection Monitoring Subsystem.

Psoriasis is a refractory disease mainly co-acted by immune,genetic and environment.Tumor necrosis factor α (TNF-α)-related biologics have brought the landmark advances in the treatment of psoriasis;however,the anti-TNF-α therapy has the adverse response,its limitation may be related to the different bio-logical functions exerted by activation of TNF-α different receptors.Tumor necrosis factor receptor 2 (TNFR2) is one of the key receptors for TNF-α,and after binding to TNF-α,it can activate multiple signaling pathways such as NF-κB,PI3K/Akt,MAPK,STAT3,etc.,which are involved in the regulation of inflamma-tion,epidermal homeostasis,cellular apoptosis,cellular proliferation,cellular autophagy and other biological processes.It is suggested that TNFR2 is closely related to the occurrence and development of psoriasis.Previ-ous studies have often overlooked the role of TNFR2 in anti-TNF-α therapies;therefore,this article reviews the structure and signaling pathways of TNFR2,research advances in the disease,and its relationship with psoriasis to provide new references for exploring the pathogenesis and treatment of psoriasis.

Objective:To conduct radiation detection and dose assessment in selective internal radiotherapy with 90Y resin microspheres for the purpose of providing a reference for radiological protection. Methods:The dose rates from radiotherapy with 90Y resin microspheres were detected in the process of each operation at different distances from the body surface of patients the levels of dose to the persons concerned were compared with the relevant national regulations and standards. Results:The estimated dose rates were 1.12-454 μSv/h during 90Y resin microspheres dispensing and 2.06-58.2 μSv/h during surgical procedure. The dose rates at 0.5 h after surgery were 22.7-64.1 μSv/h at 5 cm and 0.82-2.55 μSv/h at 1 m from three patient′s body surface. Assuming treating 200 patients a year, the annual individual effective dose to the radiation workers was 0.12-1.03 mSv/year. The annual individual effective dose to the public, comforters and carers of patients was 0.02-0.24 mSv/year after release of a patient. Conclusions:During the treatment, nursing and release of patients, the radiation doses to workers, carers and the public are lower than the individual dose limit given in the GB18871-2002 basic standards for protection against ionizing radiation and for the safety of radiation sources and the management target value set by of the relevant medical institutions.

OBJECTIVES: The current study aimed to investigate the bonding properties of a novel low-shrinkage resin adhesive containing expanding monomer and epoxy resin monomer after thermal cycling aging treatment. METHODS: Expanding monomer of 3,9-diethyl-3,9-dimethylol-1,5,7,11-tetraoxaspiro-[5,5] undecane (DDTU) as an anti-shrinkage additive and unsaturated epoxy monomer of diallyl bisphenol A diglycidyl ether (DBDE) as a coupling agent were synthesized. A blend of DDTU and DBDE at a mass ratio of 1∶1, referred to as "UE", was added into the resin matrix at the mass fraction of 20% to prepare a novel low-shrinkage resin adhesive.Then, the methacrylate resin adhesive without UE was used as the blank control group, and a commercial resin adhesive system was selected as the commercial control group. Moreover, the resin-dentin bonding and micro-leakage testing specimens were prepared for the thermal cycling aging treatment. The bonding strength was tested, the fracture modes were calculated, the bonding fracture surface was observed by scanning electron microscope (SEM), and the dye penetration was used to evaluate the tooth-restoration marginal interface micro-leakage. All the data were analyzed statistically. RESULTS: After aging, the dentin bonding strength of the experimental group was (19.20±1.03) MPa without a significant decrease (P>0.05), that of the blank control group was (11.22±1.48) MPa with a significant decrease (P<0.05) and that of the commercial control group was (19.16±1.68) MPa without a significant decrease (P>0.05). The interface fracture was observed as the main fracture mode in each group after thermal cycling by SEM. The fractured bonding surfaces of the experimental group often occurred on the top of the hybrid layer, whereas those of the blank and commercial control groups mostly occurred on the bottom of the hybrid layer. Micro-leakage rating counts of specimens before and after thermal cycling were as follows: the experimental group was primarily 0 grade, thereby indicating that a relatively ideal marginal sealing effect could be achieved (P>0.05); meanwhile, the blank control group was primarily 1 grade, and the penetration depth of dye significantly increased after thermal cycling (P<0.05); the commercial control group was primarily 0 grade without statistical difference before and after thermal cycling (P>0.05), while a significant difference was observed between the commercial control group and experimental group after thermal cycling (P<0.05). CONCLUSIONS The novel low-shrinkage resin adhesive containing 20%UE exhibited excellent bonding properties even after thermal cycling aging treatment, thereby showing a promising prospect for dental application.
Composite Resins ; Dental Bonding ; Dental Cements ; Surface Properties ; Resin Cements ; Dentin-Bonding Agents ; Dentin ; Materials Testing ; Microscopy, Electron, Scanning