Germany ; Hazardous Substances ; analysis ; Workplace

Since the first paper by Milham et al. suggested that occupational exposure to an electromagnetic field (EMF) could increase the risk of adult leukemia, many epidemiological studies on this problem have been published. In this report the method of meta−analysis was used to summarize the results from these papers quantitatively. The combined relative risk of all leukemia (RR=1.11), as well as acute lymphocytic leukemia (RR=1.38), acute myeloid leukemia (RR=1.07) and chronic lymphocytic leukemia (RR=1.14) increased but not significantly. So far, it is difficult to make a consistent conclusion about the relationship of the occupational exposure to EMF and adult leukemia. Further carefully designed case−control and cohort studies using the more valid means of exposure assessment are required.
Leukemia ; Adult ; Risk ; Electromagnetic Fields ; Analysis of substances

OBJECTIVETo analyze systematically the characteristics of occupational hazards in the foundry, and provide precise data for epidemiology studies and control of occupational hazards in the foundry.

METHODSData of airborne dust, chemical occupational hazards and physical occupational agents in environment in the foundry from 1978 to 2008 were dynamically collected. Mean concentration and intensity (geometric mean) of occupational hazards were calculated by job in different years.

RESULTSMain occupational hazards in the foundry were silica, metal fume, noise and heat stress. Silica existed in all of main jobs. The mean concentration of silica before 1986 was an extremely high level of 8.6 mg/m(3), and then remarkably dropped after 1986, with the level of 2.4 mg/m(3) from 1986 to 1989, 2.7 mg/m(3) from 1990 to 2002 and 2.7 mg/m(3) from 2003 to 2008. The trend of silica concentrations by job was consistent with that in general. Silica concentrations among jobs were significantly different, with highest level in melting (4.4 mg/m(3)), followed by cast shakeout and finishing (3.4 mg/m(3)), pouring (3.4 mg/m(3)), sand preparation (2.4 mg/m(3)), moulding (2.1 mg/m(3)) and core-making (1.7 mg/m(3)). Concentration of respirable dust in pouring was highest (2.76 mg/m(3)), followed by cast shakeout and finishing (1.14 mg/m(3)). Mean concentration of asbestos dust in melting was a relative high level of 2.0 mg/m(3). In core-making and sand preparation, there existed emission production of adhesive, with mean concentrations as followed, ammonia (5.84 mg/m(3)), formaldehyde (0.60 mg/m(3)), phenol (1.73 mg/m(3)) and phenol formaldehyde resin (1.3 mg/m(3)) also existed. Benzene and its homologues existed in cast shakeout and finishing, and the level of benzene, toluene, xylene was 0.2 mg/m(3), 0.1 mg/m(3) and 1.3 mg/m(3), respectively. In pouring and melting, there existed chemical occupational hazards, including benzo(a) pyrene, metal fume (lead, cadmium, manganese, nickel, chromium) and gas(hydrogen sulfide, phosphine, sulfur dioxide, carbon monoxide). Mean concentration of benzo(a) pyrene was a low level of 1.80 x 10(-4) microg/m(3). Physical occupational agents in the foundry were noise, heat stress and vibration. Intensity of heat stress was high in melting, pouring and cast shakeout and finishing, with the level of 30 degrees C, 29 degrees C and 26 degrees C, respectively. Noise was high in cast shakeout and finishing and core-making, with the level of 93.1 dB(A) and 89.5 dB(A), respectively. Vibration existed in core-making and cast shakeout and finishing. Compulsory postures included long standing, seating and bowing.

CONCLUSIONOccupational hazards in environment of the foundry are diversified and their concentrations exceed permissible exposure limits stipulated by the national occupational hygienic standards. High-concentrations of dust, metal fume, low-concentrations of variety of chemicals, high-intensity of noise and vibration, heat stress, and harmful compulsory posture, and so on all co-exist in the foundry. Control and protective measures should be strengthened.

The objective of this study was to elucidate the association of various risk factors with dengue cases reported in Lundu district, Sarawak, by analyzing the interaction between environmental, entomological, socio-demographic factors. Besides conventional entomological, serological and house surveys, this study also used GIS technology to generate geographic and environmental data on Aedes albopictus and dengue transmission. Seven villages were chosen based on the high number of dengue cases reported. A total of 551 households were surveyed. An overall description of the socio-demographic background and basic facilities was presented together with entomological and geographical profiles. For serological and ovitrap studies, systematic random sampling was used. Serological tests indicated that 23.7% of the 215 samples had a history of dengue, either recent or previous infections. Two samples (0.9%) were confirmed by IgM ELISA and 49 samples (22.8%) had IgG responses. A total of 32,838 Aedes albopictus eggs were collected in 56 days of trapping. Cluster sampling was also done to determine whether any of the risk factors (entomological or geographical) were influenced by geographical location. These clusters were defined as border villages with East Kalimantan and roadside villages along Lundu/Biawas trunk road. The data collected were analyzed using SPSS version 10.01. Descriptive analysis using frequency, means, and median were used. To determine the association between variables and dengue cases reported, and to describe the differences between the two clusters of villages, two-sample t-test, and Pearson's Chi-Square were used. Accurate maps were produced with overlay and density function, which facilitates the map visualization and report generating phases. This study also highlights the use of differential Global Positioning System in mapping sites of 1m accuracy. Analysis of the data revealed there are significant differences in clusters of villages attributable to container density, house density, distance of the house from the main road, and number of Ae. albopictus eggs from ovitraps set indoor, outdoor and in dumping sites (Person's Chi-Square = 6.111, df = 1, p < 0.01). Further analysis using t-test showed that house density, container density, indoor mosquitoes egg count, outdoor mosquitoes egg count, and dumping sites mosquitoes egg count were higher at the roadside villages compared to border villages. A number of potential risk factors including those generated from GIS were investigated. None of the factors investigated in this study were associated with the dengue cases reported.
Dengue ; seconds ; physical density ; Risk Factors ; Analysis of substances

India is the second most populous in the world, having crossed the population mark of 1 billion in the year 2000. The different geographical regions exhibit different levels of health and nutritional status. Out of 35 states, some are identified as demographically lagging behind, called BIMARU. Central India falls in this category and the present paper provides a situational analysis of the region with respect to population growth, socio-economic condition, health scenario and level of nutrition in the region. The level of socio-economic development is relatively poor in this part when compared to other parts of the country. The population growth is higher than the national average. The Infant mortality rate (IMR) continues to be higher in Central India, varying from 70 to 164 across the districts in the region. Regression analysis shows a negative correlation between Human development index (HDI) and infant mortality rate. Considering 18.5 as a cut-off point for screening the individuals into normal and chronic energy deficiency (CED) groups, it is found that the prevalence of CED is lower among the populations of non-backward districts (50.5 %) than that in the backward districts (53.6 %). It is suggested that the overall socio-economic development should be accelerated and infant mortality controlled in order to improve the health and nutritional status of the people in Central India.
India ; Nutritional status ; Health ; Central brand of multivitamin with minerals ; Analysis of substances

Air ; analysis ; Air Pollutants ; analysis ; Hazardous Substances ; analysis ; Spectrophotometry, Atomic ; methods

OBJECTIVETo evaluate the safety of artificial musk by determining its content of five hazard heavy metals.

METHODThe contents of Pb, Cd,As,Hg,and Cu in artificial musk were detected using inductively coupled plasma-mass spectrometry.

RESULTThe contents of Pb,Cd,As,Hg,and Cu was less than 0.35,0.05,0.30,0.20,and 4.50 mg/kg in artificial musk.

CONCLUSIONArtificial musk has low contents of heavy metals and therefore meets the safety and quality requirments.

OBJECTIVES: The molecular mechanisms that regulate cardiomyocyte cell cycle and terminal differentiation in humans remain largely unknown. To determine which cyclins, cyclin dependent kinases (CDKs) and cyclin kinase inhibitors (CKIs) are important for cardiomyocyte proliferation, we have examined protein levels of cyclins, CDKs and CKIs during normal atrial development in humans. METHODS: Atrial tissues were obtained in the fetus from inevitable abortion and in the adult during surgery. Cyclin and CDK proteins were determined by Western blot analysis. CDK activities were determined by phosphorylation amount using specific substrate. RESULTS: Most cyclins and CDKs were high during the fetal period and their levels decreased at different rates during the adult period. While the protein levels of cyclin D1, cyclin D3, CDK4, CDK6 and CDK2 were still detectable in adult atria, the protein levels of cyclin E, cyclin A, cyclin B, cdc2 and PCNA were not detectable. Interestingly, p27KIP1 protein increased markedly in the adult period, while p21CIP1 protein in atria was detectable only in the fetal period. While the activities of CDK6, CDK2 and cdc2 decreased markedly, the activity of CDK4 did not change from the fetal period to the adult period. CONCLUSION: These findings indicate that marked reduction of protein levels and activities of cyclins and CDKs, and marked induction of p27KIP1 in atria, are associated with the withdrawal of cardiac cell cycle in adult humans.
Adult ; Age Factors ; Animal ; Blotting, Western ; Cell Cycle ; Cells, Cultured ; Comparative Study ; Cyclin A/analysis ; Cyclin B/analysis ; Cyclin D1/analysis ; Cyclin E/analysis ; Cyclin-Dependent Kinases/analysis* ; Cyclins/analysis* ; Female ; Fetal Development ; Heart Atrium/growth & development* ; Heart Atrium/embryology ; Heart Atrium/cytology* ; Heart Atrium/chemistry ; Human ; Male ; Middle Age ; Myocardium/chemistry* ; Rats ; Rats, Sprague-Dawley ; Substances: Cyclin D1 ; Substances: Cyclins ; Substances: Cyclin-Dependent Kinases ; Substances: Cyclin E ; Substances: Cyclin B ; Substances: Cyclin A

The relation between the critical radius and the particle size distribution for generalized Ostwald type ripening processes whereby the mass transfer coefficient is modelled by a power law was derived. The critical radius is determined by the growth rate, the mass transfer coefficient and the mass balance, and is independent of whether the limiting stationary growth regime has been obtained.
Computer Simulation ; Crystallization ; methods ; Macromolecular Substances ; analysis ; chemistry ; Models, Chemical ; Models, Molecular ; Molecular Conformation ; Particle Size

OBJECTIVES: To explore the ability of inhibition resistibility of multiple displacement amplification （MDA） in samples with inhibitors. To explain the application and value of MDA in forensic medicine by comparing with using magnetic beads methods （MBM） to purify sample. METHODS: Different concentrations of hemoglobin and humid acid （HA） mixed with DNA samples and then divided the samples into MDA group, MBM group and control group. D3S1358 locus was amplified and detected by polyacrylamide gel electrophoresis detection system and AmpFℓSTR® Identifiler™ Plus Kit-capillary electrophoresis detection system. RESULTS: When hemoglobin concentrations exceed 1 ng/μL or HA concentrations exceed 0.1 ng/μL, amplification products could not be obtained by single-locus system in control group. When hemoglobin concentration exceeds 100 ng/μL or HA concentrations exceed 1 ng/μL, the samples could not be amplified by MBM. Inhibitors in different concentrations were amplified successfully in MDA group without any influence from inhibitors. CONCLUSIONS MDA has the capability to remove the inhibition of hemoglobin and HA, which is better than MBM and has a certain value in forensic practices.
DNA/analysis* ; Electrophoresis, Polyacrylamide Gel ; Forensic Medicine/methods* ; Hemoglobins ; Humans ; Humic Substances ; Nucleic Acid Amplification Techniques