No abstract available.
Silver*

No abstract available.
Silver*

Introduction: The biosynthesis of nanoparticles has been proposed as a cost-effective and environmental friendly alternative to chemical and physical methods. The present study was aimed to characterise Catharanthus roseus (C. roseus)-silver nanoparticles (AgNPs) using a standardised C. roseus aqueous extract. Methods: The standardisation was performed by using Liquid Chromatography/Time-of-Flight ion trap Mass Spectrometry. An optimised C. roseus-AgNPs have been previously synthesised. Further characterisation of C. roseus-AgNPs was evaluated by zeta potential analysis and fourier transform infrared spectroscopy (FTIR). Results: The chromatography analysis has revealed presence of thirteen possible indole alkaloids in C. roseus extract which were lochrovicine, lochnerine, vinleurosine, vindolinine, tabersonine, catharanthine, serpentine, catharosine, vincristine, catharine, ajmalicine, vinleurosine, and vindolicine. Zeta potential analysis exhibited the value at -16.6 mV. FTIR spectrum of C. roseus aqueous extract showed the absorption band at 3210.83 cm-1 (C-H stretch), 2934.11 (C-H bond), 1578.15 (N=O stretch), 1388.76 and 1314.89 (N=O bend), 1119.29 (C-O bond) and 729.94 (C-Cl bond). In comparison, FTIR spectrum of C. roseus-AgNP s showed the absorption band at 2925.01 and 2924.97 (C-H bond), 1622.93 (C-C=C symmetric stretch), 1383.19 and 1384.13 (N-O bend), 1037.92/1038.76/1238.3/1117.2 (C-O bond), 3169.4 (O-H bond), 774.59 and 691.53 (C-Cl bond). Conclusion: The present findings have shown that the C. roseus aqueous extract contains alkaloids that may responsible as reducing and stabilising agents in the synthesis of AgNPs.
silver nanoparticles

This study was done to evaluate whether there were any differences in microleakage of class V composite restorations according to restoration site and cavity size. Total sixty-four restorations were made in molar teeth using Esthet-X. Small (2 x 2 x 1.5 mm) and large (4 x 2 x 1.5 mm) restorations were made at the buccal/lingual surface and the proximal surface each. After 1,000 times of thermocycling (5degrees C - 55degrees C), resin replica was made and the percentage of marginal gap to the whole periphery of the restoration was estimated from SEM evaluation. Thermocycled tooth was dye penetrated with 50% silver nitrate solution. After imbedding in an auto-curing resin, it was serially ground with a thickness of 0.25 mm. Volumetric microleakage was estimated after reconstructing three dimensionally. Two-way ANOVA and independent T-test for dye volume, Mann-Whitney U test for the percentage of marginal gap, Spearman's rho test for the relationship between two techniques were used. The results were as follows: 1. The site and size of the restoration affected on the microleakage of restoration. Namely, much more leakage was seen in the proximal and the large restorations rather than the buccal/lingual and the small restorations. 2. Close relationship was found between two techniques (Correlation coefficient = 0.614 / P = 0.000). Within the limits of this study, it was noted that proximal and the large restorations leaked more than buccal/lingual and the small restorations. Therefore, it should be strictly recommended large exposure of margins should be avoided by reducing unnecessary tooth reduction.
Molar ; Silver Nitrate ; Tooth

No abstract available.
Argyria ; Colloids ; Nails ; Silver

No abstract available.
Argyria ; Colloids ; Nails ; Silver

PURPOSE: LiF TLD has a problem to be used in vivo dosimetry because of the toxic property of LiF. The aim of this study is to develop new dosimeter with LiF TLD to be used in vivo dosimetry. MATERIALS AND METHODS: We designed and manufactured the teflon box(here after TLD holder) to put TLD in. The external size of TLD holder is 4x4x1 mm3. To estimate the effect of TLD holder on TLD response for radiation, the linearity of TLD response to nominal dose were measured for TLD in TLD holder. Measurement were performed in the 10 MV x-ray beam with LiF TLD using a solid water phantom at SSD of 100 cm. Percent Depth Dose (PDD) and Tissue-Maximum Ratio (TMR) with varying phantom thickness on TLD were measured to find the effect of TLD holder on the dose coefficient used for dose calculation in radiation therapy. RESULTS: The linearity of response of TLD in TLD holder to the nominal dose was improved than TLD only used as dosimeter. And in various measurement conditions, it makes a marginnal difference between TLD in TLD holder and TLD only in their responses. CONCLUSION: It was proven that the TLD in TLD holder as a new dosimetry could be used in vivo dosimetry.
Polytetrafluoroethylene ; Silver Sulfadiazine ; Water

PURPOSE: To design and test the CT simulator phantom for geometrical test. MATERIAL AND METHODS: The PMMA phantom was designed as a cylinder which is 20 cm in diameter and 24 cm in length, along with a 25x25x31 cm3 rectangular parallelepiped. Radio-opaque wires of which diameter is 0.8 mm are attached on the other surface of the phantom as a spiral. The rectangular phantom was made of four 24x24x0.5 cm3 square plates and each plate had a 24x24 cm2, 12x12 cm2, 6x6 cm2 square line. The squares were placed to face the cylinder at angles 0degrees, 15degrees, 30degrees, respectively. The rectangular phantom made it possible to measure the field size, couch angle, the collimator angle, the isocenter shift and the SSD, the measurements of the gantry angle from the cylindrical part. A virtual simulation software, AcQSimTM, offered various conditions to perform virtual simulations and these results were used to perform the geometrical quality assurance of CT simulator. RESULTS: A 0.3~0.5 mm difference was found on the 24 cm field size which was created with the DRR measurements obtained by scanning of the rectangular phantom. The isocenter shift, the collimator rotation, the couch rotation, and the gantry rotation test showed 0.5~1 mm, 0.5~1degrees0.5~1degrees, and 0.5~ 1degreesdifferences, respectively. We could not find any significant differences between the results from the two scanning methods. CONCLUSION: The geometrical test phantom developed in the study showed less than 1 mm (or 1degrees) differences. The phantom could be used as a routine geometrical QC/QA tools, since the differences are within clinically acceptable ranges.
Polymethyl Methacrylate ; Silver Sulfadiazine

The 4 bank mico-MLC (mMLC; Acculeaf, Direx, Isral) has been commissioned for clinical use of linac based stereotactic radiosurgery. The geometrical parameters to control the leaves were determined and comparisons between measured and calculated by the calculation model were performed in terms of absolute dose (cGy/100 MU). As a result of evaluating calculated dose for various field sizes and depths of 5 and 10 cm in water in the geometric condition of fixed SSD (source to surface distance) and fixed SCD (source to chamber distance), most of differences were within 1% for 6 MV and 15 MV x-rays. The penumbral widths at the isocenter were approximately evaluated to 0.29~0.43 cm depending on the field size for 6 MV and 0.36~0.51 cm for 15 MV x-rays. The average transmission and leakage for 6 MV and 15 MV x-rays were 6.6% and 7.4% respectively in single level of leaves fully closed. In case of dual level of leaves fully closed the measured transmission is approximately 0.5% for both 6 MV and 15 MV x-rays. Through the commissiong procedure we could verify the dose characteristics of mMLC and approximately evaluate the error ranges for treatment planning system.
Radiosurgery ; Silver Sulfadiazine ; Water

No abstract available.
Eating ; Female ; Humans ; Silver