Effect of anatomic, semi-anatomic and non-anatomic occlusal surface tooth preparations on the adaptation of zirconia copings.
- Author:
Syed Rashid HABIB
1
;
Waleed ASIRI
;
Mohammed Jameel HEFNE
Author Information
- Publication Type:Original Article
- Keywords: Zirconia copings; Zirconia crowns; Marginal fit of zirconia crowns; Adaptation of zirconia crowns
- MeSH: Bicuspid; Cementation; Crowns; Tooth; Tooth Preparation*
- From:The Journal of Advanced Prosthodontics 2014;6(6):444-450
- CountryRepublic of Korea
- Language:English
- Abstract: PURPOSE: To compare the accuracy of marginal and internal adaptation of zirconia (Zr) copings fabricated on anatomic (A), semi-anatomic (SA) and non-anatomic (NA) occlusal surface preparations. MATERIALS AND METHODS: 45 extracted bicuspid teeth were prepared for receiving zirconia crowns, with different occlusal preparation designs A=15, SA=15 & NA=15. The Zr copings were fabricated by using CAD4DENT, CAD/CAM. The copings were adjusted, cemented and were cross sectioned centrally from buccal cusp tip to lingual cusp tip into mesial and distal halves. The copings were examined under electron microscope at x200 magnification and the measurements were recorded at 9 predetermined areas in micrometers. RESULTS: Overall mean gap values for the three groups was found to be 155.93+/-33.98 microm with Anatomical Occlusal preparation design having the least gap value of 139.23+/-30.85 microm showing the best adaptation among the groups. Post Hoc Tukey's test showed a statistically significant difference (P=.007) between the means of gap for A & NA preparation designs. Measurements recorded at 9 predetermined points showed variations for the three groups. CONCLUSION: Anatomical occlusal preparation designs resulted in better marginal and internal adaptation of Zr copings. There is a considerable variation between the measured marginal and internal gap values for the Zr copings fabricated by the (CAD4DENT-CAD/CAM). This variation may be associated with the lack of standardization of the preparation of teeth, computerized designing of the coping for each tooth, cement used, uniform pressure application during the cementation of the copings, sectioning of the copings and the microscopic measurements.
