In Vitro Study on the Bond Strength Between 3D-Printed Resin and Resin Cement for Pediatric Crown Restoration
10.5933/JKAPD.2023.50.1.104
- Author:
So Yung KIM
1
;
Yoosoek SHIN
;
Ik-Hwan KIM
;
Je Seon SONG
Author Information
1. Department of Pediatric Dentistry, Yonsei University Dental Hospital, Seoul, Republic of Korea
- Publication Type:Original Article
- From:
Journal of Korean Academy of Pediatric Dentistry
2023;50(1):104-112
- CountryRepublic of Korea
- Language:Korean
-
Abstract:
A 3D-printed resin crown is a novel option for esthetic crown restoration for primary teeth, which are typically bonded with resin cement. The purpose of this study was to evaluate the bonding ability of a 3D printing resin and compare it with other indirect resin materials for crown fabrication. The shear bond strengths of two 3D printing resin materials, Graphy (GP) and NextDent (NXT), and two indirect resin materials, VIPI Block (VIPI) and MAZIC Duro (MZ), were compared in the study. For all materials, the shear bond strength at the interface between the surface of the resin material and resin cement was measured. The mean shear bond strength values of GP, NXT, MZ, and VIPI were 23.29 ± 3.88, 26.14 ± 4.67, 25.41 ± 4.03, and 18.79 ± 4.26 MPa, respectively. There was no significant difference among the SBSs of GP, NXT and MZ except for VIPI. The result of this study indicates that the 3D printing resin meets the essential requirement for clinical use by showing clinically adequate bond strength.
