Preparation and in vitro evaluation of FDM 3D printed theophylline tablets with personalized dosage.
- Author:
A KAIDIERYA
1
;
R G ZHANG
1
;
H N QIAN
1
;
Z Y ZOU
1
;
Y DANNIYA
1
;
T Y FAN
1
Author Information
1. Department of Pharmaceutics, Beijing Key Laboratory of Molecular Pharmaceutics and New Drug Delivery Systems, Peking University School of Pharmaceutical Sciences, Beijing 100191, China.
- Publication Type:Journal Article
- Keywords:
3D printing;
Dosage;
Fused deposition modeling;
Personalized medicine;
Tablets;
Theophylline
- MeSH:
Humans;
Theophylline/chemistry*;
Tablets/chemistry*;
Drug Liberation;
Printing, Three-Dimensional;
Polyvinyl Alcohol/chemistry*;
Technology, Pharmaceutical/methods*
- From:
Journal of Peking University(Health Sciences)
2022;54(6):1202-1207
- CountryChina
- Language:Chinese
-
Abstract:
OBJECTIVE:To explore the feasibility of preparing different doses of tablets for personalized treatment by fused deposition modeling (FDM) 3D printing technology, and to evaluate the in vitro quality of the FDM 3D printed tablets.
METHODS:Three different sizes of hollow tablets were prepared by fused deposition modeling 3D printing technology with polyvinyl alcohol (PVA) filaments. Theophylline was chosen as the model drug. In the study, 20 mg, 50 mg and 100 mg of theophylline was filled into the cavity of the tablets, respectively. The microscopic morphology of the tablets was observed by scanning electron microscopy (SEM). The weight variation of the tablets was investigated by weighing method. The hardness of the tablets was measured by tablet hardness tester. The contents of the drugs in the tablets were determined by ultraviolet and visible spectrophotometry (UV-Vis), and the dissolution apparatus was used to assay the in vitro drug release of the tablets.
RESULTS:The prepared FDM 3D printed tablets were all in good shape without printing defects. And there was no leakage phenomenon. The diameter and thickness of the tablets were consistent with the design. The layers were tightly connected, and the fine structure of the formulation could be clearly observed without printing defects by scanning electron microscopy. The average weight of the three sizes of tablets was (150.5±2.3) mg, (293.6±2.6) mg and (456.2±5.6) mg, respectively. The weight variation of the three sizes of tablets were boss less than 5%, which met the requirements; The hardness of the tablets all exceeded 200 N; The contents of theophylline in the three tablets were 98.0%, 97.2% and 97.9% of the dosage (20 mg, 50 mg and 100 mg), and the relative standard deviation (RSD) was 1.06%, 1.15% and 0.63% respectively; The time for 80% drug released from the three dosage of tablets was within 30 min.
CONCLUSION:Three different dosages of theophylline tablets were successfully prepared by FDM 3D printing technology in this study. The exploration may bring beneficial for the preparation of personalized dose preparations. We expect that with the development of 3D printing technology, FDM 3D printed personalized tablets can be used in the clinic as soon as possible to provide personalized treatment for patients.
