Dynamics analysis of knee joint during sit-stand movement.
10.7507/1001-5515.202203021
- Author:
Peng SU
1
;
Sikai WANG
1
;
Li ZHANG
2
;
Tian LIU
1
;
Chao YUE
1
;
Qinjian ZHANG
1
Author Information
1. School of Electromechanical Engineering, Beijing Information Science and Technology University, Beijing 100192, P. R. China.
2. Rehabilitation Hospital, National Research Center for Rehabilitation Technical Aids, Beijing 100176, P. R. China.
- Publication Type:Journal Article
- Keywords:
Dynamic model;
Ground reaction force;
Joint torque;
Motion capture;
Sitting and standing movement
- MeSH:
Humans;
Hip Joint;
Biomechanical Phenomena;
Movement;
Knee Joint;
Torque
- From:
Journal of Biomedical Engineering
2022;39(5):982-990
- CountryChina
- Language:Chinese
-
Abstract:
Sit-stand movement is one of the most common movement behaviors of the human body. The knee joint is the main bearing joint of this movement. Thus, the dynamic analysis of knee joint during this movement has deeply positive influences. According to the principle of moment balance, the dynamics of the knee joint during the movement were analyzed. Furthermore, combined with the data obtained from optical motion capture and six-dimensional ground reaction force test, the curve of knee joint torque was calculated. To verify the accuracy of the analysis of dynamic, the human body model was established, the polynomial equations of angle and angular velocity were fitted according to the experimental data, and the knee joint simulation of the movement was carried out. The result revealed that in terms of range and trend, the theoretical data and simulation data were consistent. The relationship between knee joint torque and ground reaction force was revealed based on the variation law of knee joint torque. During the sit-stand movement, the knee joint torque and the ground reaction force were directly proportional to each other, and the ratio was 5 to 6. In the standing process, the acceleration first increased and then decreased and finally increased in reverse, and the maximum knee torque occurred at an angle of about 140°. In the sitting process, the torque was maximized in the initial stage. The results of the dynamics analysis of knee joint during sit-stand movement are beneficial to the optimal design and force feedback control of seated rehabilitation aids, and can provide theoretical guidance for knee rehabilitation training.