Effect of intrapulpal pressure on the bonding strength of resin cement to dentin.
- Author:
Yi Xiang PAN
1
;
Xiu Hua LI
2
;
Fu Cong TIAN
3
;
Xiao Yan WANG
1
Author Information
1. Department of Cariology and Endodontology, Peking University School and Hospital of Stomatology & National Clinical Research Center for Oral Diseases & National Engineering Laboratory for Digital and Material Technology of Stomatology & Beijing Key Laboratory of Digital Stomatology, Beijing 100081, China.
2. Fifth Clinical Division, Peking University School and Hospital of Stomatology, Beijing 100020, China.
3. Department of Endodontics, Dental College of Georgia, Augusta University, Augusta 30912, USA.
- Publication Type:Journal Article
- MeSH:
Composite Resins;
Dental Bonding;
Dentin;
Dentin-Bonding Agents;
Humans;
Materials Testing;
Microscopy, Electron, Scanning;
Resin Cements;
Surface Properties;
Tensile Strength
- From:
Journal of Peking University(Health Sciences)
2019;51(2):321-326
- CountryChina
- Language:Chinese
-
Abstract:
OBJECTIVE:To evaluate the effect of intrapulpal pressure simulation on the micro-tensile bond strength (μTBS) of resin cement to dentin.
METHODS:Thirty extracted human third molars were selected. Occlusal enamel was removed to expose dentine surface and teeth with residual dentin thickness of 0.5-2.5 mm were selected. Dye permeation through dentin tubules with or without intrapulpal pressure (IPP) simulation, or after Single Bond Universal (SBU) application on dentin surface with IPP simulation were observed at the end of 0 min, 5 min, 30 min and 2 h. The teeth with residual dentin thickness of (1.0±0.1) mm were divided into 2 groups with IPP simulation of 15 or 0 cmH2O (1 cmH2O=0.098 kPa), which was maintained for 30 min before bonding procedure. SBU was applied on the dentin surface and light cured, then RelyX Ultimate (RLX) cement was heaped on the dentin surface (diameter=10 mm, height=4 mm) and light-cured. After the dentin-resin cement samples were stored in distilled water for 24 h at 37 °C, the samples were cut into beams with cross sectional area of 0.9 mm×0.9 mm for μTSB testing (n=100). The data were analyzed with two independent samples t-test (α=0.05). The fracture mode was observed using scanning electron microscopy (SEM). The results were analyzed with Fisher exact test (α=0.05). The rest of dentin-resin cement samples (five samples for each group) were cut perpendicular to the bonding interface and the morphology of the bonding interface was observed using SEM.
RESULTS:The dye permeation through dentin tubules with IPP simulation was faster than those without IPP simulation. The μTSB of RLX to dentin with and without IPP simulation were (26.26±9.78) MPa and (28.70±9.0) MPa, respectively. The most frequent fracture mode was mixed-fracture mode. There was no significant difference between the two groups for neither bond strength nor fracture types distribution (P>0.05). Regarding the morphology of dentin-resin cement bonding interface, both groups showed 4-8 μm finger-like resin tags.
CONCLUSION:With SBU pretreatment, the IPP simulation had no influence on the immediate bond strength of RLX to dentin.
