Subtractive versus additive indirect manufacturing techniques of digitally designed partial dentures
10.4047/jap.2021.13.5.327
- Author:
Ahmed Mamdouh SNOSI
1
;
Shaimaa Mohamed LOTFY
;
Yasmine Galaleldin THABET
;
Marwa Ezzat SABET
;
Fardos Nabil RIZK
Author Information
1. Oral and Maxillofacial Prosthodontics Department, Faculty of Dentistry, British University, Cairo, Egypt
- Publication Type:Original Article
- From:The Journal of Advanced Prosthodontics
2021;13(5):327-332
- CountryRepublic of Korea
- Language:English
-
Abstract:
PURPOSE:The purpose of this in vitro study was to evaluate the accuracy of digitally designed removable partial denture (RPD) frameworks, constructed by additive and subtractive methods castable resin patterns, using comparative 3D analysis.
MATERIALS AND METHODS:A Kennedy class III mod. 1 educational maxillary model was used in this study. The cast was scanned after modification, and a removable partial denture framework was digitally designed. Twelve frameworks were constructed. Two groups were defined: Group A: six frameworks were milled with castable resin, then casted by the lost wax technique into Co-Cr frameworks; Group B: six frameworks were printed with castable resin, then casted by the lost wax technique into Co-Cr frameworks. Comparative 3D analysis was used to measure the accuracy of the fabricated frameworks using Geomagic Control X software. Student's t-test was used for comparing data. P value ≤ .05 was considered statistically significant.
RESULTS:Regarding the accuracy of the occlusal rests, group A (milled) (0.1417 ± 0.0224) showed significantly higher accuracy than group B (printed) (0.02347 ± 0.0221). The same results were found regarding the 3D comparison of the overall accuracy, in which group A (0.1501 ± 0.0205) was significantly more accurate than group B (0.179 ± 0.0137).
CONCLUSION:In indirect fabrication techniques, subtractive manufacturing yields more accurate RPDs than additive manufacturing.