Effect of investment materials on 3-point flexural strength of heat pressed zirconia core
10.14815/kjdm.2020.47.4.211
- Author:
Tae-Yeon KIM
1
;
Seha KIM
;
Jeong-Hui JI
;
Byoung gu LIM
;
Sung Geun OH
;
Jaewoo SHIN
;
Junghwan LEE
;
Min-Ho LEE
;
Tae-Sung BAE
Author Information
1. Department of Dental Biomaterials and Institute of Biodegradable Material, School of Dentistry, Jeonbuk National University
- Publication Type:Original Article
- From:
Korean Journal of Dental Materials
2020;47(4):211-220
- CountryRepublic of Korea
- Language:English
-
Abstract:
The purpose of this study was to evaluate the effect of the reaction between investment material and zirconia on the strength of zirconia in the application of heat-pressing method. Sixty specimens were cut (24 mm×4 mm×0.5 mm) into plates from Zirtooth ™ Multi O-9814 block (∅98×14T, HASS, Gangwondo, Korea) and sintered at 1450℃. Specimens were divided into 6 subgroups according to the depending on the investement material; (a) UN group (Control), (b) PH group (Prime vest HS), (c) CP group (Calibra-press), (d) BV group (BC-Vest), (e) MH group (Microstar-HS), (f) F1 group (Formula 1). Five investment materials were buried according to the procedure recommended by the manufacturer and left at room temperature for 30 minutes. The investment mold was dried and maintained at an elevated temperature of 850℃ for 50 minutes. Then, Amber Lisi-POZ LT (HASS) was placed in a thermoformed electric furnace (Programat EP3000/G2, Ivoclar Vivadent, Schaan, Liechtenstein) together with the mold, heated to 915℃ at an elevation temperature of 45℃/min, and moored for 15 minutes. The specimens were loaded to fracture in a universal testing machine and the fracture surface was examined by a field-emission scanning electron microscopy (FE-SEM). The surface of the zirconia specimen with the investment material was analyzed by energy dispersive X-ray spectroscopy (EDS). The 3-point flexural strength test showed the highest value (1265.5 MPa) in the UN group and the lowest value (756.1 MPa) in the F1 group. As a result of EDS analysis, the largest amount of Si was detected in the F1 group, and the most interfacial changes occurred as a result of FE-SEM analysis. It was concluded that when the zirconia is buried with the investment material and the heat press molding is performed, the state of the interface is changed due to the investment material at the bonding interface while the strength is lowered.
