In vitro evaluation of a removable partial denture framework using multi-directionally forged titanium
10.4047/jap.2020.12.6.369
- Author:
Ginga SUZUKI
1
;
Satoshi SHIMIZU
;
Mana TORII
;
Ai TOKUE
;
Guo YING
;
Masao YOSHINARI
;
Noriyuki HOSHI
;
Katsuhiko KIMOTO
;
Hiromi MIURA
;
Tohru HAYAKAWA
;
Chikahiro OHKUBO
Author Information
1. Department of Removable Prosthodontics, Tsurumi University School of Dental Medicine, Kanagawa, Japan
- Publication Type:Original Article
- From:The Journal of Advanced Prosthodontics
2020;12(6):369-375
- CountryRepublic of Korea
- Language:English
-
Abstract:
PURPOSE:This study evaluated the availability of multi-directionally forged (MDF) titanium (Ti) as a component of removable partial dentures (RPDs). MDF-Ti remarkably improved the mechanical properties of RPDs due to its ultrafine-grained structure.
MATERIALS AND METHODS:The wear resistance, plaque adhesion, and machinability of MDF-Ti were tested. As controls, commercially pure (CP) titanium was used for wear, plaque adhesion, and machinability tests. For wear resistance, the volume losses of the titanium teeth before and after wear tests were evaluated. Plaque adhesion was evaluated by the assay of Streptococcus mutans. In the machinability test, samples were cut and ground by a steel fissure bur and carborundum (SiC) point. An unpaired t-test was employed for the analysis of the significant differences between MDF-Ti and the control in the results for each test.
RESULTS:Wear resistance and plaque adherence of MDF-Ti similar to those of CP-Ti (P>.05) were indicated. MDF-Ti exhibited significantly larger volume loss than CP-Ti in all conditions except 100/30,000 g/ rpm in machinability tests (P<.05).
CONCLUSION:Although the wear resistance and plaque adherence of MDFTi were comparable to those of controls, MDF-Ti showed better machinability than did CP-Ti. MDF-Ti could be used as a framework material for RPDs.
