Effects of implant alignment and load direction on mandibular bone and implant: finite element analysis
10.14368/jdras.2020.36.3.176
- Author:
Hyunju CHUNG
1
;
Chan PARK
;
Kwi-Dug YUN
;
Hyun-Pil LIM
;
Sang-Won PARK
;
Hongso YANG
Author Information
1. Department of Periodontology, School of Dentistry, Chonnam National University, Gwangju, Republic of Korea
- Publication Type:Original Article
- From:Journal of Dental Rehabilitation and Applied Science
2020;36(3):176-182
- CountryRepublic of Korea
- Language:English
-
Abstract:
Purpose:To evaluate the effects of load direction, number of implants, and alignment of implant position on stress distribution in implant, prosthesis, and bone tissue.
Materials and Methods:Four 3D models were made to simulate posterior mandible bone block: two implants and 3-unit fixed dental prosthesis (FDP) with a pontic in the center (model M1), two implants and 3-unit FDP with a cantilever pontic at one end (model M2), FDP supported by three implants with straight line placement (model M3) and FDP supported by three implants with staggered implant configuration (model M4). The applied force was 120 N axially or 120 N obliquely.
Results:Peak von Mises stresses caused by oblique occlusal force were 3.4 to 5.1 times higher in the implant and 3.5 to 8.3 times higher in the alveolar bone than those stresses caused by axial occlusal force. In model M2, the connector area of the distal cantilever in the prosthesis generated the highest von Mises stresses among all models. With the design of a large number of implants, low stresses were generated. When three implants were placed, there were no significant differences in the magnitude of stress between staggered arrangement and straight arrangement.
Conclusion:The effect of staggering alignment on implant stress was negligible. However, the number of implants had a significant effect on stress magnitude.
