Prognostic evaluation of hip joint function following capsule repair based on a threedimensional finite element analysis model.
10.12122/j.issn.1673-4254.2020.12.20
- Author:
Hansheng HU
1
;
Jingcheng WANG
2
;
Zhihua LU
2
;
Weimin FAN
1
Author Information
1. Department of Orthopedics, First Affiliated Hospital of Nanjing Medical University, Nanjing 210029, China.
2. Department of Orthopedics, Subei People's Hospital, Yangzhou 225000, China.
- Publication Type:Journal Article
- Keywords:
capsule;
finite element analysis;
hip joint;
total hip arthroplasty
- MeSH:
Arthroplasty, Replacement, Hip;
Biomechanical Phenomena;
Finite Element Analysis;
Hip Joint/surgery*;
Humans;
Prognosis;
Stress, Mechanical
- From:
Journal of Southern Medical University
2020;40(12):1826-1830
- CountryChina
- Language:Chinese
-
Abstract:
OBJECTIVE:To construct a three-dimensional (3D) finite element mechanical model of total hip arthroplasty for comparison of biomechanical differences of the hip joint following capsule repair and postoperative rehabilitation.
METHODS:Six frozen specimens of hip joint posterior capsule ligament complex were collected in a bone-capsule-bone manner, and the load-strain curve and other mechanical properties of the specimens were tested using a universal material testing machine. Thin-section CT data of the pelvis and lower limbs obtained from a volunteer were imported into Mimics software to construct a 3D model of the hip joint. Digital models of the cup, femoral prosthesis and joint capsule were created in CATIA software and imported into Mimics to simulate total hip arthroplasty; the assembled data were imported into ABAQUS software. The properties of the capsule were set according to results of the mechanical test, anatomical studies, and constitutive equations, and the biomechanics of the anatomically repaired and conventionally repaired capsules were compared during hip flexion.
RESULTS:The results of testing on the 6 capsule specimens showed a mean ultimate tensile strain of (39.21±5.23)% and a mean of ultimate tensile strength of 1.65±0.38 MPa. The stress-strain curve of the finite element model was consistent with the results of mechanical test on the specimens and the biochemical characteristics of the capsule. The stress was distributed evenly in the anatomically repaired capsule during hip flexion but not in the capsule repaired through the conventional approach; the tensile stress in the lower part of the conventionally repaired capsule reached the ultimate tensile stress measured on the capsule specimens at a 90° flexion.
CONCLUSIONS:The finite element model allows dynamic, quantitative and visual assessment of stress distribution in the hip joint capsule, and compared with the conventional approach, anatomical repair can achieve better biomechanical properties of the capsule.
