Risk of micro-fracture in femoral head after removal of cannulated screws for femoral neck fracture
10.7507/1002-1892.202001076
- Author:
Kai CHU
1
Author Information
1. Department of Orthopaedics, Yantaishan Hospital
- Publication Type:Journal Article
- Keywords:
cannulated screw;
Femoral neck fracture;
internal fixation;
micro-fracture
- From:
Chinese Journal of Reparative and Reconstructive Surgery
2020;34(9):1091-1095
- CountryChina
- Language:Chinese
-
Abstract:
Objective: To explore the changes of bone and risk of micro-fracture in femoral head after removal of cannulated screws following femoral neck fracture healing under the impact force of daily stress. Methods: A total of 42 specimens of normal hip joint were collected from 21 adult fresh cadaveric pelvic specimens. Wiberg central-edge (CE) angle, bone mineral density, diameter of femoral head, neck-shaft angle, and anteversion angle of femoral neck were measured. Then, the 3 cannulated screws were implanted according to the AO recommended method and removed to simulate the complete anatomical union of femoral neck fracture. The morphology of screw canal in the femoral head was observed by CT. Finally, the specimens were immobilized vertically within the impact device in an upside-down manner, and the femoral heads were impacted vertically. Every specimen was impacted at 200, 600, and 1 980 N for 20 times with the impacting device. After impact, every specimen was scanned by CT to observe the morphology changes of screw canal in the femoral head. Micro-fractures in the femoral head could be confirmed when there was change in the morphology of screw canal, and statistical software was used to analyze the risk factors associated with micro-fractures. Results: After impact at 200 and 600 N, CT showed that the morphology of screw canal of all specimens did not change significantly compared with the original. After impact at 1 980 N, there were protrusion and narrowing in the screw canal of the 22 femoral head specimens (11 pelvic specimens), showing obvious changes compared with the original screw canal, indicating that there were micro-fractures in the femoral head. The incidence of micro-fracture was 52.38% (11/21). logistic regression results showed that there was correlation between micro-fracture and bone mineral density ( P= 0.039), but no correlation was found with CE angle, diameter of femoral head, neck-shaft angle, and anteversion angle ( P>0.05). Conclusion: The micro-fractures in the femoral head may occur when the femoral head is impacted by daily activities after removal of cannulated screws for femoral neck fractures, and such micro-fractures are associated with decreased bone density of the femoral head.
