The Change of Sagittal Alignment of the Lumbar Spine after Dynesys Stabilization and Proposal of a Refinement.
10.3340/jkns.2015.58.1.43
- Author:
Won Man PARK
1
;
Chi Heon KIM
;
Yoon Hyuk KIM
;
Chun Kee CHUNG
;
Tae Ahn JAHNG
Author Information
1. Department of Mechanical Engineering, Kyung Hee University, Yongin, Korea.
- Publication Type:Original Article
- Keywords:
Degenerative disease;
Dynamic;
Finite element analysis;
Lumbar;
Spine;
Stabilization
- MeSH:
Animals;
Finite Element Analysis;
Head;
Humans;
Lordosis;
Spinal Stenosis;
Spine*
- From:Journal of Korean Neurosurgical Society
2015;58(1):43-49
- CountryRepublic of Korea
- Language:English
-
Abstract:
OBJECTIVE: Dynesys(R) is one of the pedicle-based dynamic lumbar stabilization systems and good clinical outcome has been reported. However, the cylindrical spacer between the heads of the screws undergoes deformation during assembly of the system. The pre-strain probably change the angle of instrumented spine with time and oblique-shaped spacer may reduce the pre-strain. We analyzed patients with single-level stabilization with Dynesys(R) and simulated oblique-shaped spacer with finite element (FE) model analysis. METHODS: Consecutive 14 patients, who underwent surgery for single-level lumbar spinal stenosis and were followed-up more than 24 months (M : F=6 : 8; age, 58.7+/-8.0 years), were analyzed. Lumbar lordosis and segmental angle at the index level were compared between preoperation and postoperative month 24. The von Mises stresses on the obliquely-cut spacer (5degrees, 10degrees, 15degrees, 20degrees, 25degrees, and 30degrees) were calculated under the compressive force of 400 N and 10 Nm of moment with validated FE model of the L4-5 spinal motion segment with segmental angle of 16degrees. RESULTS: Lumbar lordosis was not changed, while segmental angle was changed significantly from -8.1+/-7.2degrees to -5.9+/-6.7degrees (p<0.01) at postoperative month 24. The maximum von Mises stresses were markedly decreased with increased angle of the spacer up to 20degrees. The stress on the spacer was uneven with cylindrical spacer but it became even with the 15degrees oblique spacer. CONCLUSION: The decreased segmental lordosis may be partially related to the pre-strain of Dynesys. Further clinical and biomechanical studies are required for relevant use of the system.
