Influence of different heat treatments on the corrosion behavior of a new type of high palladium dental alloy
10.12016/j.issn.2096-1456.2017.02.003
- Author:
LIU Jia-jun
1
,
2
;
MENG Yu-kun
3
Author Information
1. Department of Stomatology, Shenzhen People&rsquo
2. s Hospital
3. Department of Prosthodontics, West China School of Stomatology, Sichuan University
- Publication Type:Journal Article
- Keywords:
Dental casting alloy;
High-palladium alloy;
Heat treatment;
Corrosion behavior;
Electrochemical experiment
- From:
Journal of Prevention and Treatment for Stomatological Diseases
2017;25(2):80-86
- CountryChina
- Language:Chinese
-
Abstract:
Objective:To evaluate the influence of different heat treatments on the corrosion behavior of a new Pd-Ag-In-Ga alloy.
Methods :The corrosion of a new Pd-Ag-In-Ga alloy was tested according to ISO 10271：2001/cor.1:2005(E). Taken as comparison, a commercial high-palladium alloy (Spartan® Plus) was also employed in the study. For electrochemical corrosion test, the open-circuit potential (Eocp) and potentiodynamic polarization curve were recorded and then the electrochemical parameters, namely corrosion potential (Ecorr) and corrosion current density (Icorr) calculated. The surfaces of the specimens that before and after corrosion test were observed by scanning electron microscopy (SEM).
Results :Both of the high-palladium alloys had lower corrosion tendency and higher corrosion resistance by heat treatment in the ISO 10271 electrochemical corrosion test. For both alloys, heat treatment at 500 ℃ was found to be effective in improving the corrosion resistance as the best datas of electrochemical parameters (Eocp, Ecorr, Icorr) were detected among the four temperature groups. However, no evidence showed that there was significant difference in corrosion resistance between the two alloys. Comparison of surface morphology of the specimens before and after electrochemical experiments by SEM demonstrated that all groups of the two alloys were visible of pitting corrosion and crevice corrosion phenomenon that gradually became less with increasing heat treatment temperature. Horizontal comparing among the groups of the two alloys, no apparent differences in the distribution of pitting and crevice corrosion was found.
Conclusin :The variation in compositions of high-palladium alloys did not cause significant difference in corrosion behavior due to the identical palladium matrix. The similarity in corrosion behavior among the two high-palladium alloys might be attributed to the predominant palladium content.
- Full text:不同热处理对自研新型高钯牙科合金腐蚀行为的影响.pdf
