Effect of laser-etched pure titanium surface on early proliferation of MG63 cells
10.12016/j.issn.2096-1456.2019.07.005
- Author:
GUO Zehong
1
;
NING Yingyuan
1
;
XU Shulan
1
;
ZHU Peijun
1
;
DING Xianglong
1
;
GAO Yan
1
Author Information
1. Center of Oral Implantology, Stomatological Hospital of Southern Medical University
- Publication Type:Journal Article
- Keywords:
laser etching;
pure titanium;
surface treatment;
roughness;
MG63;
proliferation
- From:
Journal of Prevention and Treatment for Stomatological Diseases
2019;27(7):435-440
- CountryChina
- Language:Chinese
-
Abstract:
Objective : To investigate the effect of a laser-etched pure titanium surface on proliferation of the human osteosarcoma cell line MG63 and to provide a basis for study of implant surface modification.
Methods:The pure titanium plate was cut into titanium pieces by a numerical control machine tool and divided into smooth surface and laser etching groups. The titanium surface of the laser etching group was etched with an Nd:YAG continuous wave laser using predetermined parameters, and the surfaces were observed by scanning electron microscopy (SEM). The surface micromorphology of each titanium sheet was evaluated. The relative element content of the titanium surface was measured by energy dispersive X-ray spectroscopy (EDS). The Ra value of each surface was determined using the Veeco roughness tester. MG63 cells were inoculated on 2 sets of titanium tablets. At 1, 3, and 6 h postinoculation, cell adhesion to the two groups of titanium sheets was observed under the microscope. At 24 h after inoculation, cellular F-actin was directly stained using immunofluorescence, and the morphology of the cytoskeleton was observed by laser confocal microscopy. Cell proliferation was examined at 1, 3, and 5 d using a MTS kit, and the data were analyzed with SAS 9.4.
Results :The surface of the smooth surface group was smooth and flat, the element composition was pure titanium, and the roughness Ra was 179.23 nm. The surface of the laser-etched group formed a regular and uniform pore structure. The composition was mainly Ti, O, C, etc, and the surface roughness Ra was 14.11 μm. A large number of cells were uniformly distributed on the two titanium sheets in the observations at 1, 3, and 6 h. At 24 h postinoculation, MG63 cells were completely stretched on the two sets of titanium sheets and had extended a large number of pseudopods and microfilaments to cross-link with peripheral cells; moreover, the cell division phase was observed. The cell proliferation of the two groups at 1, 3, and 5 d showed a significant increase with time, indicating that no cytotoxicity occurred on the surfaces of the two groups. However, the cell proliferation in the laser-etched group was superior to that in the mechanical smooth surface group.
Conclusion:The surface morphology of titanium can be controlled by laser etching, which is conductive to increase the microstructure of implants without cytotoxicity and promoting osteoblast proliferation in the early stage.
- Full text:激光蚀刻的纯钛表面对MG63细胞早期增殖的影响.pdf