Dosimetric analysis of 3D-printing template assisted and CT-guided 125I seed implantation for treatment of soft tissue sarcoma
10.3760/cma.j.issn.0254-5098.2018.05.005
- VernacularTitle:3D打印模板辅助CT引导放射性125I粒子植入治疗软组织肉瘤的剂量学研究
- Author:
Xuemin LI
1
;
Ran PENG
;
Yuliang JIANG
;
Zhe JI
;
Fuxin GUO
;
Haitao SUN
;
Jinghong FAN
;
Xu LI
;
Weiyan LI
;
Junjie WANG
Author Information
1. 100191,北京大学第三医院肿瘤放疗科
- Keywords:
Three-dimensional printing template;
125I seeds;
CT-guidance;
Dosimetry;
Soft tissue sarcoma
- From:
Chinese Journal of Radiological Medicine and Protection
2018;38(5):350-354
- CountryChina
- Language:Chinese
-
Abstract:
Objective To compare the dose distribution of postoperative plans with preoperative plans of 3D-printing template (coplanar and non-coplanar) assisted and CT-guided 125I seed implantation for the treatment of soft tissue sarcoma,and to explore the accuracy of treatment at dosimetry level.Methods From December 2015 to July 2017,19 patients with soft tissue sarcoma (a total of 25 lesions)were treated with 3D printing template assisted and CT-guided 125I seed implantation in Peking University Third Hospital.All patients underwent preoperative assessment,CT simulation orientation,preoperative planning,3D-template printing,3D-template reduction,needle and seed implantation,postoperative dosimetry assessment,postoperative care and follow-up.The preoperative and postoperative dosimetric parameters were conpared.Ten cases of soft tissue sarcoma in superficial trunk or limbs were screened.Preoperative planning of coplanar template and non-coplanar template were designed respectively.The dosimetric parameters of preoperative planning guided of two templates were compared.Results Twentyfive 3D-printing templates were designed and constructed,and 25 lesions were totalled.There was no statistical difference between preoperative and postoperative dosimetric parameters.There was no statistical difference of the preoperative plan's dosimetric parameters between coplanar and non-coplanar in soft tissue sarcoma of superficial trunk/limbs.Conclusions The validation of actual dose distribution in postoperative plans assisted by 3D-printing template in 125I seed implantation showed that most of parameters could meet the expectation of preoperative plans,which indicated the improvement in accuracy for this new modality.For soft tissue sarcoma located in the superficial trunk/limbs,it was recommended to select the 3D-printing coplanar template firstly.