Determination of 240 Pu/ 239 Pu in Plutonium-containing Particle by Laser Ablation Multiple Collector Inductively Coupled Plasma Mass Spectrometry
10.11895/j.issn.0253-3820.171028
- VernacularTitle:激光剥蚀-多接收电感耦合等离子体质谱法 测定含钚颗粒物中240 Pu/239 Pu比值
- Author:
Wei WANG
1
;
Ming Zhi LI
;
Jiang XU
;
Qing Guo ZHOU
;
Yang Yong SU
;
Min Yan WU
;
Yi Guan WEI
;
Sui FANG
;
Liang Wen WANG
Author Information
1. 西北核技术研究所
- Keywords:
Plutonium particles;
240 Pu / 239 Pu ratio;
Laser ablation multiple collector inductively coupled plasma mass spectrometry
- From:
Chinese Journal of Analytical Chemistry
2017;45(11):1719-1726
- CountryChina
- Language:Chinese
-
Abstract:
The isotopic fingerprints of plutonium are extremely important for nuclear safeguards and nuclear forensics. An analytical method was developed for direct determination of 240 Pu / 239 Pu ratio in plutonium-containing particles by laser ablation multiple collector inductively coupled plasma mass spectrometry ( LA-MC-ICP-MS). The risk of ablated particles leakage was reduced by leak detection, exhaust hood, and swiping the laser cell. Scanning mobility particle sizer (SMPS) was used to measure the effect of ablation parameters on the size distribution of ablated particles. The results showed that the majority of ablation material presented as particles from 40 -500 nm and the sweep time after laser ablation should be longer than 15 min. The particle size was evaluated to guide LA-MC-ICP-MS system. By using external normalization method for correction of the mass fractionation correction factor and ion counter efficiencies measured by nebulizer-coupled MC-ICP-MS, a LA-MC-ICP-MS method was established for analysis of 239 Pu / 240 Pu ratio in plutonium particles. Spot size, ablation rate and laser dwell time were set at 30 μm, 5 Hz and 5 s, respectively. Laser energy density was controlled to ensure that the intensities of 239 Pu for plutonium-containing particles were about 2×104 cps and 2×105 cps, respectively. The analytical results showed that the relative uncertainties for 239 Pu / 240 Pu was less than 1. 4% ( n = 6), and the measured value deviated by less than 4. 7% from the reference value. The time for adjusting system and determining 239 Pu / 240 Pu ratio in single plutonium particle was 9 h and 0. 5 h, respectively. The results demonstrated that this technique was rapid, precise and accurate, and could be used for determination of 239 Pu / 240 Pu in plutonium-containing particles.
