Relationship between basivertebral foramen and retropulsed bone fragment in thoracolumbar burst fracture
10.3760/cma.j.issn.0253-2352.2017.19.006
- VernacularTitle:胸腰椎爆裂性骨折椎体后上缘骨折块与椎基静脉孔的相关性
- Author:
Xuyang ZHANG
1
;
Shengyun LI
;
Tianming YU
;
Xing ZHAO
;
Shunwu FAN
;
Fengdong ZHAO
Author Information
1. 浙江大学医学院附属邵逸夫医院骨科
- Keywords:
Thoracic vertebrae;
Lumbar vertebrae;
Fractures,bone;
Tomography,spiral computed
- From:
Chinese Journal of Orthopaedics
2017;37(19):1223-1230
- CountryChina
- Language:Chinese
-
Abstract:
Objective To clarify the relationship between the basivertebral foramen (BF) and the retropulsed bone fragment (RBF) in thoracolumbar burst fracture (TLBF) and further explain the mechanism of RBF formation.Methods From June 2013 to June 2016,Sixty-two patients suffering from TLBF with RBF were collected.The characteristics of RBF as well as the parameters of vertebral body were studied using CT reconstruction imaging.In the transverse images,the lengths of RBF (RL) and vertebral body (VL) were measured.In median sagittal images,the heights and widths of RBF (RH,RW) and vertebral body (VH,VW) were also obtained.The ratios of different parameters of RBF and vertebral body (RL/VL,RW/VW,RH/VH) were calculated,and then defined the location relationship of RBF and BF.Eight frozen cadaveric spine were selected and evaluated by Micro-CT scans.Each vertebral body was divided into three layers (Superior,Middle,Inferior).Each layer was further divided into 9 regions (R1-R9),named as SR1-SR9,MR1-MR9,IR1-IR9.Microarchitecture parameters of each region in each layer,including bone volume fraction (BV/TV),bone mineral density (BMD),trabecular connectivity (Corn.D),and trabecular number (Tb.N) and thickness (Tb.Th) were calculated,and their differences were also analyzed to see if the trabecular bone distribution would be affected by BF.In vitro study,burst fractures were simulated on cadaveric spines by using bursting fracture simulator,aiming to observe the RBF morphology and imaging findings to future investigate the relationship between RBF and BF.Results The length and height of RBF were close to half of vertebral body length and height (RL/VL:0.497±0.059,RH/VH:0.485±0.036).The width of RBF was usually one-third of vertebral body width (RW/VW:0.319±0.025),which indicated that the fracture block was often located in the posterior of vertebral body above the BF.BV/TV,Tb.N in the MR2 and MR5 regions were lowest than other regions and the SMI of MR2 and MR5 was largest than others.SR5 was the lowest region in superior lawyer that was corresponded to regions most affected by burst fracture.In simulated burst fractures,the fracture line of RBF went across the vertex or upper surface of the BF and the lower boundaries of RBF were also the upper bound of the BF.Moreover,the damage sites of posterior longitudinal ligament were mainly located at the edge of the BF.Conclusion At the bone defect region,the BF is the weakest area in the vertebral body which may affect the distribution of trabecular bone surrounding it.When subjected to vertical violence,these regions undergo fracture first which impact the anterior and lower boundaries of RBF.Ultimately,RBF was produced upon the BF,involving all or part of the upper bound of the BF.
