The comparison of the frictional force by the type and angle of orthodontic bracket and the coated or non-coated feature of archwire.
10.4041/kjod.2011.41.6.399
- Author:
Tae Ho JANG
1
;
Sang Cheol KIM
;
Jin Hyoung CHO
;
Jong Moon CHAE
;
Na Young CHANG
;
Kyung Hwa KANG
Author Information
1. Department of Orthodontics, School of Dentistry, Wonkwang University, Korea. pigtail@wonkwang.ac.kr
- Publication Type:Original Article
- Keywords:
Friction;
Coated Ni-Ti archwire;
Orthodontic bracket
- MeSH:
Ceramics;
Crowding;
Friction;
Nickel;
Orthodontic Brackets;
Saliva;
Titanium
- From:Korean Journal of Orthodontics
2011;41(6):399-410
- CountryRepublic of Korea
- Language:Korean
-
Abstract:
OBJECTIVE: The purpose of this study was to evaluate the difference in frictional resistance among metal, ceramic, self-ligation brackets and coated or non-coated Ni-Ti archwires at various bracket-archwire angulations during the sliding movement of an orthodontic archwire, using an orthodontic sliding simulation device. METHODS: Four types of bracket (Micro-arch Perpect Clear2 Clippy-C and Damon3 and 5 types of orthodontic archwire (0.014", 0.016", and 0.016" x 0.022" inch coated Ni-Ti, and 0.016" and 0.016" x 0.022" inch Ni-Ti) were used. Further, the bracket-archwire angles were set at 4 different angulations: 0degrees, 3degrees, 6degrees, and 9degrees. RESULTS: The frictions from all the experimental groups were found to be significantly increased in order of self-ligation brackets, Micro-arch and Perpect Clear2 (p < 0.001). The presence of a coat had no effect on the friction of the same sized archwires at 0degrees and 3degrees bracket-archwire angles (p < 0.001). Coated archwires had significantly higher frictions than the same sized non-coated archwires at 6degrees and 9degrees bracket-archwire angles (p < 0.001). The frictions increased significantly as the bracket-archwire angles were increased (p < 0.001). CONCLUSIONS: The use of self-ligation brackets will be beneficial in clinical situations where a low frictional force is required. Further, in cases where crowding is not severe, the use of coated archwires should not cause problems. However, more additional explanation is required considering the fact that the damage of coated archwire and exposure of the metal portion in case of binding and notching and the effects of saliva were not taken into account.
