The load deflection rate of looped wire and its change by heat treatment.
- Author:
Yong Kook LEE
1
Author Information
1. Department of Orthodontics, Graduate School, Seoul National University, Korea.
- Publication Type:Original Article
- MeSH:
Hot Temperature*;
Orthodontic Wires;
Stainless Steel
- From:Korean Journal of Orthodontics
1986;16(1):133-144
- CountryRepublic of Korea
- Language:Korean
-
Abstract:
This study was conducted to evaluate the effects of loop formation and heat treatment upon the elastic properties of orthodontic wires. The specimens selected were 016", .018", 016 x 022", and .018 x 022" sized stainless steel (standard) and cobalt-chromium-nickel wires, and were divided into 7 groups as, 1. straight non-heat treated 2. U looped non-heat treated 3. L looped non-heat treated 4. Circle looped non-heat treated 5. U looped heat treated 6. L looped heat treated 7. Circle looped heat treated Heat treatment was performed in Big Jane furnace at 850' F for 3 minutes. The elastic limit and the elastic range of each specimen were determined by bending test, and load deflection rate was computed from those values. The findings were as follows, 1. The formation of loop resulted in increased load-deflection rate for both stainless steel and cobalt-chromium-nickel wires. 2. The heat treated group showed higher load-deflection rate than non-heat treated group, which was more apparent in cobalt-chromiumnickel wire than in stainless steel wire. 3. L loop had the highest Ioad-deflection rate among 3 types of loops, followed by U loop and circle loop. 4. The specimens with greater diameter displayed the more increase in load-deflection rate by looping and heat treatment.
