Reproducibility and accuracy of tooth size measurements obtained by the use of computer.
- Author:
Eun Jeong KIM
1
;
Hyeon Shik HWANG
Author Information
1. Department of Orthodontics, College of Dentistry, Chonnam National University, Korea.
- Publication Type:Original Article
- Keywords:
computer system;
tooth size;
reproducibility;
accuracy
- MeSH:
Computer Systems;
Crowding;
Crowns;
Incisor;
Molar;
Tooth*
- From:Korean Journal of Orthodontics
1999;29(5):563-573
- CountryRepublic of Korea
- Language:Korean
-
Abstract:
The purpose of this study was to evaluate the availability of computer system for the measurement of tooth size in the model analysis through the comparison of two measurements: One was to use a computer; and the other was to use vernier calipers. Twenty sets of casts were used, which showed a moderate degree of crowding and full eruption of all teeth. The mesio-distal width of 12 teeth from the left central incisor to the left first molar at each set of the casts were measured twice with vernier calipers and a computer respectively. This measurement was repeated two weeks later. First, for the reproducibility analysis, the two computer measurements were compared then the vernier calipers measurements were compared. Second, all the teeth were sepapated into the region of mesiodistal contact points and its width was measured by a micrometer to obtain standard measurements. For the accuracy analysis, these standard measurements were compared with the measurements from the dental casts using two methods. The difference between them was defined as the measurement error. To investigate the cause of measurement error, an examination was made for the presence and degree of contact point deviation on each tooth from the upper and lower occlusograms, and the mesio-distal angulation of each tooth was measured with TARG. Following results were obtained through statistical analysis. 1. In the analysis for reproducibility ; the measurements with vernier calipers showed significant differences in three out of twelve teeth while the computer measurements showed significant differences in one out of twelve teeth. 2. In the analysis for accuracy : compared with the standard measurements, the measurements with vernier calipers showed significant differences in three out of twelve teeth while the compute measurements showed significant differences in two out of twelve teeth. 3. Compared with the standard measurements. the measurements with vernier calipers were apt to be larger at the upper first molar, and smaller at the lower first molar. The computer measurements, however, were apt to be larger at both upper and lower first molars. 4. the measurements with vernier calipers showed the largest error at the lowe first molar and the degree of error was variable according to the tooth while the difference of error was small in the computer measurements. 5. In the analysis for the correlation of the degree of measurement errors with the contact point deviation index and the mesio-distal crown angulation of each tooth, the measurements with vernier calipers did not show significant correlation while th measurements with computer showed slight positive correlations. The results of this study indicate that a computer system may be useful for the measurement of tooth size in the model analysis.
