A photoelastic study on the initial stress distribution of 3 types TMA multi-vertical loop arch wire.
- Author:
Hyeong Chul LEE
1
;
Youn Sic CHUN
Author Information
1. Division of Orthodontics, Department of Dentistry, College of Medicine, Ewha Womans University, Korea.
- Publication Type:Original Article
- Keywords:
MVLAW;
open vertical loop;
TMA wire;
electric welding stop;
tip back bend
- MeSH:
Bicuspid;
Incisor;
Molar;
Tooth;
Welding
- From:Korean Journal of Orthodontics
1995;25(1):73-85
- CountryRepublic of Korea
- Language:Korean
-
Abstract:
Multi -Vertical Loop Arch Wire(MVLAW) is a kind of appliance for uprighting the mesially inclined posterior teeth axes simultaneously. In this study MVLAW was classified as 3 types by modifing the vertical loop design and named type A, B and C. Each MVLAW was fabricated from .017" x .025" TMA wire and preactivated at the distal end of the open vertical loop with 10 degree tip-back bend(type B has an electric welding stop at the distal end of each loop and type C has no electric welding stop). Type A MVLAW was preactivated at the apex of each open vertical loop with 10 degree tip-back bend(the electric welding stop of type A is positioned at the mesial side of each loop). The aim of the present study was to identify when and which MVLAW is more effective to correct the buccal segment axes simultaneously. The photoelastic overview of the upper and lower right quadrant showed that stress concentrations were observed in its photoelastic model. The obtained results were as follows: 1. Higher level compression can be seen clearly at the distal curvature of the lower 1st and 2nd molar when A type MVLAW was applied without short class III elastic, but mild compression cannot be seen at the distal curvature of lower anterior teeth using the class III elastic. 2. Higher concentration was presented at the mesial curvature from the lower 1st premolar to the 2nd molar than the anterior teeth when B type MVLAW without short class III elastic was applied, but using the short class III elastic, higher concentration of compression was presented in the anterior teeth area. 3. Areas of higher compression and tension were not observed at the mesial and distal curvature of the entire lower teeth except lower central and lateral incisors in C type MVLAW without short class III elastic, but using the short class III elastic, higher concentration was seen at the mesial curvature of the lower 1st premolar and lower anterior teeth.
