Agreement in optic disc measurements between Cirrus HD-OCT and Heidelberg retinal tomograph Ⅱ in myopic eyes
10.3760/cma.j.issn.2095-0160.2016.08.017
- VernacularTitle:Cirrus HD-OCT与HRT2测量近视眼视盘参数的一致性评估
- Author:
Kunliang, QIU
;
Riping, ZHANG
;
Geng, WANG
;
Xuehui, LU
;
Mingzhi, ZHANG
- Publication Type:Journal Article
- Keywords:
Diagnostic techniques,ophthalmological;
Myopia;
Optic disk/pathology;
Tomography,optical coherence/methods;
Microscopy,confocal;
Human
- From:
Chinese Journal of Experimental Ophthalmology
2016;34(8):744-749
- CountryChina
- Language:Chinese
-
Abstract:
Background As myopia is a common ocular condition which has been reported as the risk factor of primary open angle glaucoma,it is of great importance to evaluate the optic disc morphology in myopic eyes.Objective This study was to evaluate the agreement of optic disc measurements between Cirrus high-density optical coherence tomography (HD-OCT) and Heidelberg retina tomograph (HRT) in myopic eyes;and to investigate the relationships between axial length (AL) and differences of optic disc parameters measured with the two devices.Methods One hundred and fifty myopic subjects were included in this prospective cross-sectional study.One eye from each subject was randomly selected for optic disc imaging by Cirrus HD-OCT and HRT2 in Joint Shantou International Eye Center of Shantou University and The Chinese University of Hong Kong from September to December in 2010 under the approval of Ethic Committee of this hospital and informed consent of each patient was received.Each subject received complete ophthalmic examinations including intraocular pressure (IOP) measurement,visual acuity,refraction,slit lamp,dilated fundus examination and perimetry.The subjects were divided into low (≤-3.00 D,35 eyes),moderate (-3.00 D＜SE＜-6.00 D,60 eyes) and high myopia (SE ≥-6.00 D,55 eyes) groups according to the refractive status.Measurement of axial length was performed with IOL master.Optic disc parameters including disc area,rim area,cup volume,vertical cup-to-disc ratio (VCDR) and average cup-to-disc area ratio (ACDR) were measured by Cirrus HD-OCT and HRT2,respectively.The OCT measurements were corrected for ocular magnification using the Littman's formula,and the results were compared between the instruments.The measurement agreement was evaluated using Bland-Altman plots.Pearson correlation analysis was used to evaluate the associations between AL and the measurement differences of the two instruments.Results The mean axial length and refraction were (25.62±1.10) mm and (-5.22±2.34) D,respectively.The corrected optic disc parameters were significantly larger than those without adjustment by using Cirrus HD-OCT (all at P＜ 0.001).In the high myopic group,the disc area measured by Cirrus HD-OCT was significantly larger than that by HRT2 (P＜0.001).In the moderate myopic group,the rim area measured by HRT2 was significantly larger than that by the Cirrus HD-OCT (P =0.040).The measurements of ACDR,VCDR and cup volume by Cirrus HD-OCT were all larger than those by HRT2 in the three myopic groups (all at P＜0.001).The 95％ limits of agreement (LoA) of disc area and rim area with the two devices were-0.64 to 0.74 and-0.74 mm to 0.62 mm2,respectively.The differences of disc area,rim area and cup volume measurements from the two devices were significantly and positively associated with axial length (r=0.158,0.148,0.156,all at P＜0.05).No significant correlation was detected between AL and the differences of ACDR and VCDR (r =0.012,0.093,both at P ＞ 0.05).Conclusions Optic disc parameters measured by Cirrus HD-OCT are affected by optical magnification in myopic eyes.Poor agreement is found across all of the disc measurements with Cirrus HD-OCT and HRT2.The two devices should not be used interchangeably for measurements of optic disc.Moreover,the differences between measurements of the two devices are significantly associated with AL.
