The effect of solder and laser weld on corrosion of dental alloys.
- Author:
Jin BAIK
1
;
Yi Hung WOO
;
Dae Gyun CHOI
;
Boo Byung CHOI
Author Information
1. Department of Prosthodontics, College of Dentistry, Kyung-Hee University, Korea. yhwoo@khu.ac.kr
- Publication Type:Original Article
- Keywords:
Corrosion;
Solder;
Laser weld;
Potentiodynamic polarization;
Immersion
- MeSH:
Alloys;
Corrosion*;
Dental Alloys*;
Gold Alloys;
Immersion;
Spectrum Analysis
- From:The Journal of Korean Academy of Prosthodontics
2005;43(2):264-279
- CountryRepublic of Korea
- Language:Korean
-
Abstract:
STATEMENT OF PROBLEM: Intraoral corrosion not only affects the esthetic and function of metallic dental restoration, but also has biologic consequences as well. Therefore, corrosion is considered a primary factor when choosing the dental alloy and laboratory technique. PURPOSE: The objective of this study was to compare the effects of solder and laser weld on corrosion. MATERIAL AND METHODS: Test specimens were made of 2 types of gold alloys, Co-Cr and Ni-Cr alloy and fabricated 3 methods, respectively: as cast, solder, and laser weld. For the analysis of corroding properties, potentiodynamic polarization test and immersion test conducted. The potentiodynamic polarization scan curve were recorded in 0.9% NaCl solution(pH 7) using Potentiostat/Galvanostat Model 273A. All specimens were exposed to 0.9% NaCl solution(pH 2.3) during 14 days. Elemental release into corrosive solution was measured by atomic emission spectrometry. Differences in corrosion potential and mass release were determined using ANOVA. RESULTS AND CONCLUSION: Through analyses of the data, following results were obtained. 1. In Pontor MPF and Wiron 99, corrosion potential of the solder group was statistically lower than as cast and laser weld group(p<0.05), but there was no difference between corrosion potential of solder group and laser weld group in Pontor MPF and no differences between as cast and laser weld group(p>0.05). In Jel-Bios 10 and Wirobond, there was no difference of corrosion potential according to joining methods(p>0.05). 2. In all tested alloys, the amount of released metallic ion was greatest in the solder group(p<0.05). There was no difference between as cast group and laser weld group in Jel-Bios 10 and Wirobond(p>0.05). 3. In scanning electron microscopic examination, except soldered Wiron 99 specimens, it is impossible to discriminate the corrosive property of solder and laser weld. 4. Under the this experimental circumstances, laser weld appears superior to the solder when corrosion is considered.
